The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

This thesis describes possibilities for Metso Paper to lower their costs of spray pipes for their pulp wash press TRPE, with maintained good functionality and quality.Information that can be used by competitors has been censored in this version of the essay.To find solutions, alternative suppliers have been contacted and asked to quote. There has also been a new spray pipe designed. The manufacturing costs of the new design have been calculated.The thesis also contains a concept generation of an alternative product to the spray pipes in installations where a high pressure washer is used.To be able to ask other manufacturers of spray pipes to quote, a demand specification based on the currently used spray pipe was made. This was then sent to two alternative suppliers.An investigation of earlier used spray pipes, and the currently used, shows that the nozzles are a big part of the total costs of the spray pipes. To attempt to reduce the nozzles high cost an concept generation was made to find the best solution for a new design.There was a request that it should be possible to change the internal brushes in the spray pipe without cutting and welding.

Energy efficiency is important both to reduce costs and to reduce greenhouse gas emissions in the atmosphere. Reducing costs will also help maintain business competitiveness.Scania in Södertälje is a company where the Optimization of energy use is an ongoing and continual process. One area with potential to make energy and cost savings is the effectiveness of the ventilation systems in offices and industrial premises at Scania. During the summer months an increased demand for cooling occurs, leading to increased ventilation and a peak in district cooling system usage. Sorptive cooling is a technology where the supplied air is cooled by applying external heat.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

In today?s society Internet is evolving the tourism industry and it?s the pioneers that use this marketing channel to further their brands that?s that reap the benefits of early adoption. In this essay we research how well two kinds of ownership structures, private ownership and chain ownership, in the hotel market match up against each other in Internet presence and the steps they have taken to encourage guests too book via their websites. We determined that the hotel market in Karlstad was sufficient to study the different kinds of ownership structures as it?s small enough to see the competition between private ownership and chain ownership clearly instead of as normal in more densely populated cities where chain owned hotels dominates the marked due to sheer size. The scientific research consists of two types of methods.

The thesis presents an optimally designed kinematic structure for a new 6-DOF haptic devicebased on TAU configuration. The configuration of the TAU-2 proposed by Suleman Khan andKjell Andersson [1] was modified and its mobility was verified by using Grübler criterion tohave a 6 DOF. Analytical kinematic models for the inverse and forward kinematics weredeveloped for the haptic TAU configuration to determine a set of optimal design parameters.Kinematic performance indices such as volume of the workspace, kinematic isotropy and payload index, were defined based on the singular values of the Jacobian matrix. The Jacobianmatrix was scaled to homogenize the physical units. The Jacobian matrix dependent on theposition and orientation of the end-effector gives local isotropy and pay load index, so globaldesign indices were defined, which represent the performance of the mechanism in the wholeworkspace.

This thesis describes the redesign ofequipment designed for drying bags thatis used in Fresenius Kabis´manufacturing of their nutritionmedicine in Uppsala. The need of thistask arise during the start of thedevelopment of a new packaging line werethis equipment were meant to be used. Anevaluation of the bagdryers capacity andcapability was necessary.The work started with gathering ofinformation from suppliers of the usedcomponents and from the responsibleengineers for this equipment. Aneducation to learn how the equipmentworked and how to operate it were taken.That was followed by the creation of astudy plan were the tests were plannedto test different parameters effect onthe drying result and to see if thebagdryer managed to handle the bags ofthe correct format in the pace that theequipment should be designed for.The test results detected a need ofdesigning a unit with a function thatholds the bags in place while passingthrough the dryer in order to attainhigh quality results. The results werelater used for Optimization of thedesign.

Den här rapporten behandlar ett system som använder en databas som lagringsplats för loggar. En bra metod för att hämta ut dessa loggar saknades och databasdesignen behövde förbättras för sökningar i loggarna. En applikation för att hämta och söka i loggposter från databasen skapades. En undersökning om hur databasdesignen kunde förbättras genomfördes också. Båda delarna gjordes i ett projekt för att de hörde ihop.

The Smart Grid technology has during the last decade been established as a way to create a greater flexibility on the electricity grid that will be needed as the development moves towards an increased share of renewable primary energy sources in the electricity production. One part of the Smart Grid technology is the ability to shift loads in time, to adapt to either price or emissions, known as Demand Response. This project, which was conducted at KTH in collaboration with the consulting corporation Capgemini, examines the economic, environmental and social aspects of the Demand Response technology. In the project, three household products are used in a model that derives the potential savings in costs and emissions of CO2e. The results show that the actual savings measured in SEK are small, but that the savings measured in percent can be as high as 20 percent. Reduction of CO2e emissions is slightly lower.

Business Process Modelling Notation (BPMN) is a way to graphically draw a diagram of a business process. A BPMN diagram consists of several so-called flow objects. These are interconnected in the graph through sequence  flows. BPMN models are merely graphical representations of business process and there is a need to simulate these diagrams for different purposes. The simulation that now is available for BPMN is that the model is evaluated by checking if it is correct.

Business Process Modelling Notation (BPMN) is a way to graphically draw a diagram of a business process. A BPMN diagram consists of several so-called flow objects. These are interconnected in the graph through sequence  flows. BPMN models are merely graphical representations of business process and there is a need to simulate these diagrams for different purposes. The simulation that now is available for BPMN is that the model is evaluated by checking if it is correct.

Scana-Booforge is a Swedish company which specialize in heat treatment of various metal. The treatments take place in quenching ovens, where fans are used to circulate the hot air. The fans used today do not have a satisfactory lifespan. This thesis aims to develop a new design of the fans for the quenching ovens, and the goal is that the new fans will bring cost savings for Scana-Booforge.The design development process started with mapping out the environment in which the fans operate, and with analysis of the existing fan structure and damages, in order to establish the cause of failure and of short durability. The performance of the fan were also established at this stage.

The genus Campylobacter is globally recognised as the leading bacterial cause of human foodborne gastroenteritis. Every year around 8000 Swedes are infected by Campylobacter. Most people are infected by thermotolerant Campylobacter species, commonly C. jejuni and C. coli.

Cultivable land is a limited resource and agriculture contributes to some of the most serious environmental problems facing the planet like, global warming, eutrophication and loss of biodiversity. The specialized, industrial agriculture with monoculture and extensive input of external energy, commercial fertilizer, and chemical pesticides are all essentially unsustainable. An adaptation to other methods of production is necessary to preserve the environment for future generations. The aim of this study is to describe the factors that distinguish sustainable from unsustainable agriculture. The results will be used to examine if and how the European Union (EU) works in order to create a more sustainable agricultural industry and to analyze the preconditions for such development.