The company Sol & Energiteknik wanted to examine the possibility to make a standardhouse totally energy independent. Based upon this I have, during the spring of 2007,examined the possibilities available at the market today through litterature studies, contactwith several companies and reading reports at the internet.The first thing to examine has been to determine the energy consumption for a standardhouse, and find out if there are better technologies to be used for energy conservation.My conclusion in this matter is that there are possibilities today for building a house moreenergy efficient.When I had reached the point at which my design for the house was decided, I also hadto choose the different products to use to produce energy as well as to store that energy.To produce heat and electricity to the house I decided to use a wind turbine and a solarwater heater.The most difficult part of designing a house that is energy independent is that theproduced energy must be stored somehow. Storing the heat is relatively easy beacuse theheat can be stored in a large water tank. The electricity is a bigger problem beacuse itmust be stored in batteries, which today are too expensive to be used in a standard house.In the future producing and storing hydrogen might be used to produce electricity, buttoday that technology is both expensive and not tested enough.My final conclusion is that a standard house can not be built to be totally energyindependent today, unless it is very expensive to connect the house to the electricitynetwork. As an alternative solution I came up with a proposal for a house which isconnected to the electricity network and have some amount of own produced energy.This house prooved to be a good investment if you choose to build it today, and it couldbe a very good investment in the long run beacuse energy prices increase every year..

Uppsalahem is the leading housing corporation in Uppsala with its over 160 real estate properties. Uppsalahem is owned by the municipality of Uppsala, which has a climate and energy goal that aims for 100 MW of solar energy to be installed in Uppsala by 2030. The 100 MW goal, combined with Uppsalahem?s environmental policy, is a strong incentive to investigate the possibility of installing PV modules on the many available roof areas that Uppsalahem possesses. The objective of this thesis is to create a foundation for future decisions regarding PV systems for Uppsalahem.

This thesis aims to investigate the information effects of fair value accounting in Nordic real estate companies. As a consequence of the mandatory IFRS adoption in the European Union in 2005, listed Nordic companies are allowed to recognize investment property at fair value in accordance with IAS 40. Theory suggests that fair value accounting should lower information asymmetry. Therefore, this study aims to examine correlation between fair value accounting of investment property and information asymmetry on the stock market. To investigate this, we use bid-ask spread as a proxy for information asymmetry and examine Nordic real estate companies before and after the implementation of IFRS.

The residential and service sector in Sweden accounts for approximately 38% of the total energy usage and Sweden has an aim to reduce the total energy use by 20% by 2020 compared to 2008, which means residential sector will have to improve energy efficiency. As part of that a law was instituted by the Swedish parliament that all properties must have an Energy Performance Certificate (EPC) to thereby give the property owners a greater insight into energy use in their buildings and propose recommendations for energy-efficiency measures. On the EPC, a value on the building's energy performance in terms of energy use in kWh / m2 per year is declared, of which electricity is a share of it. Instructions on what to include in the amount facility electricity for running the facilities is regulated by the authority for building, Boverket while SVEBY has made an interpretation of the regulations in their report "Brukarindata bostäder" where they have a table on what should be included in the amount and what not to include.This report is a study of two similar apartment buildings, where one of the buildings recently underwent renovation, to see if the declared amount of energy for electricity, in the EPC, is consistent with the measured value, and whether there has been any reduction in facility electricity in the renovated building after the renovation.The result shows that the measured value of the building electricity was 2.6 kWh / m2 per year, 28,8 %, lower than the declared value in the building that have not undergone a renovation. Calculation of values from previous years (2011) by the same percentage of facility electricity as in the results of the measurements, 56.7%, it becomes clear that the declared value for facility electricity in the EPC of the renovated building do not correspond with reality and that there has been an increase in use of facility electricity after the renovation..

Latent heat storage is a way to store thermal energy when a phase change material undergoes a phase change. The advantage of latent heat storage is the capability to store more energy per mass unit than other heat storage methods. The most commonly used phase change in latent heat storage is the transition between solid and liquid. Phase change materials can be divided into organics, inorganics and eutectics.In the Nordic Electricity Market the price of electricity is set every hour by Nordpool spot, which leads to price fluctuations because of changes in demand. The main goal of this report is to create a latent heat storage system in a single-family home and investigate the possibility to save money by charging the latent heat storage system when the price of electricity is low, and discharge when the price is high.The thermodynamic model consisted of a ?tube-in-tube? heat exchanger with phase change material in the outer tube and water as the heat transfer fluid in the inner tube.

This examination paper is about the potential for Solar cells on apartment blocks. The technology with using solar cells for manufacturing electricity, has been on the market for a while, but recently the new installations of solar cells has increased. Solar cells are suited for placements on buildings but are expensive to obtain. The municipal real-estate company is interested in solar cells but wants to know more before they invest in the technology. This report contains an account of the solar cell and a guide to how a connection to the grid is accomplished.

Wind power is one of the sources of renewable energy which has to be developed further in order to lessen our dependence on non renewable sources of energy. It's mainly oil and coal which have to be replaced by green energy. Wind power is already established in many countries, for example Germany, The United States of America and Denmark but it has to be continually developed and expanded to meet the needs of the growing energy consumption in the world. During the last few years many types of small wind turbines have appeared on the market. These small wind turbines are an alternative to the big wind turbines or power generators which demand huge sums of investment money.A new target group can now buy the small wind turbines in order to cover their own usage of electricity.

AbstractElectricity consumption is a globally increasing problem caused by the high share of electricity produced in coal power plants. These contribute to high carbon emissions when only about 1/3 of the heat generate electricity and the remaining 2/3 of the heat cools off. Combined heat and power plants (CHP) have high efficiency because they use the residual heat for domestic heating. The CHP plant often use fuels from renewable resources, giving them a lower carbon footprint, but are also depending on the heat demand. If electric powered products such as drying cabinets convert to heat powered products more environmentally friendly electricity will be produced by CHP plants, which can supplant electricity, produced from coal power plants and reduce carbon emissions.

Photovoltaic Systems in Sweden has longbeen heavily dependent on subsidies and grants to bring in a profit for the investor. Production of excess electricity is a major reason for this as the compensation for excess electricity today is low. However, there are businesses that have an electricityneed that are particularly suitable for solar electricity. These businesses have an electricity demand when the sun shines the brightest and if the Photovoltaic System is properly scaled, the excess electricity can be minimized. A golf club is that kind of a business and this thesis aims to examinate the solar power potential for golf businesses in Sweden.Nine golf clubs was selected from different locations in Sweden.

The development of solar photovoltaic (PV) is increasing,with declining module prices and with a strongenvironmental profile. Policies are developed around theworld to achieve the targets set for renewable energy.In Helsingborg, the local power company Öresundskraft isworking with solar PV to achieve the goals of the city.With their vision: - Energy for a Better World and Powerfor the Region, their work with developing the local solarPV market is continuing and the next step is to create asolar PV policy. Today their offer is 1 SEK/kWh for theexcess electricity delivered to the grid.It turns out that compensating the customer is a vitalpolicy and it has to be dynamic to follow the decisions ofpolitics. The same survey shows indeed, thatenvironmental and technical part is of interest. Solar PVwill be supported locally to act on environmentalsustainability and locally produced electricity and withthis Öresundskrafts vision will be achieved..

Currently there is a controversial debate about that we must reduce our impact on the global warming; therefore both the Government and the local authorities have invested heavily in developing renewable energy in Sweden. The major development on the wind power market can be seen as a result of both the technological development and also on the decision that the Government took in 1996, which opened up the wind power market for private parties.This paper has aimed to examine the types of financial innovations that have arisen from the investments and financing of wind power on Gotland, and what these innovations can contribute to the future development of wind power.The problems that this thesis is based on is; what kind of financial innovations have occurred within investment and financing of wind power? How can these innovations contribute to the continued development of wind power on Gotland? The conclusion of this study shows that respondents and participants have defined a number of financial innovations that have emerged. Where some of the innovations only can be seen as incremental since they are based on continuous improvements, while others can be seen as radical as they are completely new for the context in which they operate. The study has also shown that Gotland has a great potential to produce more renewable electricity, but the development is dependent on the new power lines being built, in order to export electricity to the mainland..

The Rya power plant in Borås produces district heating, district cooling and electricity. The plant is owned by Borås Energi och Miljö AB and is run by Dalkia Facility Management AB.In order to get the best heat exchange from the district hot water a pair of twin pumps and a turbine circuit pump are used as return pumps. Turbine circuit pumps are used to increase the pressure through the heat exchangers at the power plant. The pumps are in use when the flow is over 2 000 m3 h-1 and during the summer when re-cooling is used to improve the effectivens of the heat boilers.Since the pumps, that are parallel connected, rotating at a fixed rate per minute, the pressure is regulated with regulating valves. This report shows that during the 4,300 hours that the pumps where in use, energy corresponding to 590 MWh was wasted.

This thesis has identified and studied measures to allow for reduced use of electricity in a waste incineration plant in western Sweden. The energy extracted from the waste at the powerplant is utilized and sold in form of electricity and heat. Technical and environmentally the combined heat and power plant is by today's standards among the leading waste incineration plants in the world. The owners are constantly striving to improve the efficiency of the waste incineration plant. They have seen the opportunities for savings in reducing internal usage of electricity.

This thesis aims to examine the viability of various techniques for increased electricity generation in CHP plants and the effect of electricity price fluctuations on the profitability.The techniques examined are fuel dryer, pellet production, methane production, combined methane- and pellet production, seasonal heating storages in caverns and pit heat storages and condensing tail. Using Excel and Matlab, the prerequisites for investment costs, revenues and expenses were calculated.What affects the price of electricity is a combination of economic and technological development, energy prices, economic structure, population changes and weather. Different scenarios for the electricity price were therefore examined. In the base case, the electricity price was given by the Nord Pool electricity price statistics of area three in 2011. Thereafter, WiMo was used to design the electricity scenarios for 2030, which was then applied to the data to obtain the viability of various scenarios. The techniques examined were found to give greater profits to the CHP plant by increasing and optimizing the production of electricity.

The following thesis is examining compliance with EU-law from a member state perspective. The variation in the compliance level between the member states from 1995 to 2005 is analyzed to prove the fact that the Nordic member countries during the measured time period experienced a low number of infringements. The infringements that did occur were resolved faster and more efficient in the Nordic countries then in the other member states. The theory used to explain the Nordic compliance rate is divided between external and internal pressure in a pull and push model. The external pressure is illustrated with argumentative persuasion from the EU-commission to the individual member states; how the state responds to the persuasion in order to act compliant.