The aim of this report is to increase the knowledge and understanding of the problems within the production at AQ Enclosure systems, and thereby achieve a more stable flow throughout the whole process, a better working environment and better competition advantages. The internal flow along with the external cooperation is very important for the company, because it views flexibility and short leadtime as it is the most important competitive means. The part of AQ production that?s been investigated is the manufacturing of ATM-machines, where the costumer is Banqit. This company is a rater small company with about 4 % of the world market of ATM-machines.In order to achieve the aim of the report extensive interviews have been carried out with employees at AQ.

The Rya power plant in Borås produces district heating, district cooling and electricity. The plant is owned by Borås Energi och Miljö AB and is run by Dalkia Facility Management AB.In order to get the best heat exchange from the district hot water a pair of twin pumps and a turbine circuit pump are used as return pumps. Turbine circuit pumps are used to increase the pressure through the heat exchangers at the power plant. The pumps are in use when the flow is over 2 000 m3 h-1 and during the summer when re-cooling is used to improve the effectivens of the heat boilers.Since the pumps, that are parallel connected, rotating at a fixed rate per minute, the pressure is regulated with regulating valves. This report shows that during the 4,300 hours that the pumps where in use, energy corresponding to 590 MWh was wasted.

In Sweden, the eutrophication of lakes, water courses and the coastal areas is considered the major threat to aquatic ecosystems and therefore actions taken to reduce the nutrient load to aquatic system including the Baltic Sea has high priority. There are many different sources of phosphorous and nitrogen and domestic wastewater is one contributing factor to the high load. Especially waste water from households that is not connected to municipal sewage treatment or a local small scale plant with appropriate nutrient removal efficiency is considered a problem. These types of households are quite common in rural areas in Sweden and in areas where summer houses has been converted to permanent living. Swedish legislation now permit the municipalities to decide in which areas within the municipality higher demands of the local small scale treatment facility should be met by the households (i.e.

In health care today at Uppsala County Council the daily work involves spending time at the computer. IT-systems were implemented to support and aid the care givers in their work. Around these systems there is a support organization to support the users in using the system. The aim of this thesis is to investigate this organization in terms of how well it works and how successful it is in helping the users. This has been done by investigating the flow of information trough the organization and by focusing at the role of IT-coordinators with responsibility for support, process development, education and statistics.

The globalization that has occurred during the last few years has made it more important for companies to have a well-functioning logistics system. Customers demand more options, which lead to an increased flow that creates greater demand regarding packaging and transports. Diverse logistics costs are nowadays a substantial cost for many companies. Therefore, more effort is aimed at optimizing transportation to lower these costs.The purpose of this project is to create a user-friendly calculation of logistics costs that illustrates how the costs vary, depending on how the flow is structured. This is done by examining which aspects that affect the total logistics costs and by mapping which aspects that should be included in a calculation of the logistics costs.Literature studies have been carried out parallel with empirical studies at Scania's production unit, MC, in Oskarshamn.

During the Swedish banking crisis in the early 1990?s, the government paid out 65 billion Swedish kronor to save Swedish banks from bankruptcy. In the process, two banks left the private sector to be taken over by the state. This thesis builds on a study from 1998 in seeking to quantify the financial end result for the Swedish government from the subsidies. Taking a cash flow approach and accounting for the time difference, it starts with the money paid out during the years of crisis and subtracts the money that has since been returned to the government by successful management of the relinquished assets.

The main focus for this essay is to describe the relationship between human and nature through a material investigation that takes its shape through sculpture. With the help of a fairytale-like story the reader can share the creation of the sculpture and how my thoughts flow through the process that will result in an exam project. Rooted in earlier projects I discuss the crash between civilization and the wilderness as well as talking about the likeness of the creative process and child play. I also discuss the body's place in the forest and the loneliness that we humans created that has cut us off from the rest of the creatures and plants in the forest. My aim is that in the final piece I will create a fiction place where these can be joined together again.

Valmets own foundry in Karlstad has during a long period of time had problems being profitable. The goal today is to turn this around. Today there are three different productionlines; engine blocks, Yankeecylinders and components for the wind turbine industry. This master thesis has focused on examining if value stream mapping is a useful tool to use in a foundry, and therefore outside the typical manufacturing industry. The target has also been to evaluate if there is a possibility to improve the flow in the foundry and also the results.During the 20 weeks this work has been done at the foundry data has been collected and analyzed.

Today there is no way of measuring or simulating turbulent flow in high Reynolds numberenvironments. The computational power required to simulate these conditions is not expectedto be available for several decades so instead the CICLoPE project aims at solving thisshortage by the construction of a long carbon fiber wind tunnel in which real measurementscan be made. To do accurate measurements it is of importance that the wind tunnel, 0.9 metersin diameter and 110 meters long, is as straight as possible.This master thesis treat the design and construction of a device which may be used to align thetunnel along a reference laser beam. A design is presented which allows the pipe to be alignedwithin about a quarter of a millimeter along its entire length. Contents span over severalscience fields such as physics, mechanics, control theory and electronics.The result is a theoretically correct design.

Calcareous fens constitute a specific habitat which is uncommon in Europe and protected by the EU habitat directive due to its importance to several threatened species. Hagebyhöga in Östergötland is a calcareous fen habitat included in the Natura 2000 Networking Programme. Adjacent to the existing fen, a degraded fen area is situated. The area has been used for agriculture for several years but is now going to be restored to its former state by the county administrative board of Östergötland.When working with restoration of degraded fen areas it is important to aquire knowledge about the chemical soil conditions. Plant growth limited by phosphorus and low fertility are characteristic conditions for calcareous fens, whilst arable land usually is highly fertile and limited by nitrogen.The purpose of this study is to bring forth useful knowledge for restoring the degraded calcareous fen of Hagebyhöga.

Title: How to manage stress seen from a leadership perspective Authors: Lina Jonsson, Kristian Olsson, Mattias Olsson, Shabnam Tahajjod Supervisor: Marie Aurell Department: Department of Business Administration, IEM Course: Bachelor thesis in Business Administration, FEC 007 Question of issue: How can we understand stress managing at a workplace seen from a leadership perspective? Method: We have chosen a qualitative method for our thesis with inter-views as qualitative data collection. The interviews had a low grade of standardization. Result: On the basis of our question of issue we have drawn the con-clusion that it is important to create comfort at the workplace, that there are a safety and a feeling of handle the work tasks and that there is a plentiful information flow between managers and employees to manage to handle the workplace stress situa-tion..

This study investigates the value relevance of goodwill impairments for equity investors in Swedish listed companies. We provide insight on whether goodwill impairments are value relevant before as well as after the implementation of IFRS 3 and IAS 36. We express market value of equity as a function of book value of equity; net income excluding goodwill impairments and goodwill impairments, using the Ohlson valuation model and Hellström's price regression. Our findings suggest that goodwill impairments are statistically value relevant for equity investors. Prior to the implementation of IFRS 3 and IAS 36, our findings imply that equity investors respond negatively to goodwill impairments.

Abstract Tutor - Anders Richtnér History - Theories suggest that Lean Product Development strategies dramatically increase a company's performance through enabling faster T-T-M, Quality and Costs of Product Development. Purpose - The purpose of this paper is therefore to investigate whether the implementation of LPD actually affect corporate performance measurements T-T-M, Quality and Cost, in a positive way. Methodology - This Bachelor thesis is an exploratory investigation of the concept of Lean Product Development within a global IT- company, performed through four case studies, interviews and complementing corporate performance data. Findings - With empirical data and subsequent analyzes in mind, we note the following; it is clear that the project that produced the best results, in terms of T-T-M, Quality and Cost, also was the one furthest in the process of implementing Lean Product Development..

The construction of buildings and paved surfaces changes the natural water balance.Precipitation generates surface runoff and storm water instead of infiltrating into the soil.Storm water has come to be considered as a major source of pollution in lakes and streams inthe vicinity of urban areas. Reduction of pollutants in storm water is a key action in order toprotect sensitive recipients and maintain high water quality. Storm water is traditionallytransported by storm sewers to the nearest recipient. In recent years the approach to stormwater management has changed; storm water should primarily be disposed of on site, throughlocal disposal of storm water, LOD. LOD is created by a combination of the function ofseveral smaller local facilities and the general sewer system.

Syftet med vår studie är att undersöka hur människor där den kreativa processen är central i sitt yrkesutövande upplever denna process och se om det går att hitta ett mönster. Vi bestämde oss för att ta reda på vad som händer inuti människan runt det kreativa ögonblicket. Vår huvudfrågeställning är: Vad är den kreativa processen? Vi gjorde öppna intervjuer med fem verksamma kreatörer med hjälp av DV-kamera. Vårt resultat visade att det gick att se ett gemensamt mönster i den kreativa processen.