This master thesis encompasses an inventory of the older industrial community of Gimo. Investigations of the contamination situation for each industrial area were done. A risk classification according to the Swedish Environmental Protection Agency?s ?Method of Surveying Contaminated Sites?, phase one, followed. The risk classification was done on areas of Iron Work, a rockwool industry and a landfill. Gimo have had iron manufacturing from 1615 until 1945. Gimo have had two blast-furnaces and two smithies periodically.

The incineration of waste is steadily increasing in Sweden and so is the production of ashes. The bottom ash has for many years been used as construction material in landfills. Now many of the nation's landfills are closed and there is a great need to find another beneficial use for the ash. Bottom ash is a gravel-like material and with its material properties it can replace natural gravel in parts of roads and surface constructions. Today this use is only approved within landfill areas where leachate is collected and checked.

Waste appears to be a low-cost fuel compared to biofuel. This Masters thesis was conducted for Vattenfall Utveckling AB and deals with how waste in the fuel affects the performance of a SCR-catalyst. Different mechanisms of deactivation were surveyed, focusing on the poisoning mechanism. A literature study was carried out, which was used as a reference when analysing the results.Small samples (9x2x2 cm, 64 pieces) cut out from a full-scale unused honeycomb catalyst were exposed up to 1500h in two different combustion plants, Johannes in Gävle (co-combustion) and Högdalen in Stockholm (waste-combustion). The activity was measured mainly at 300°C but also at 250, 350, 375 and 400°C.

In nature there are about 4,500 minerals identified. These can roughly be divided into two groups, opaque phases and non-opaque phases, with the exception that some opaque phases also may act as a non-opaque phase in different circumstances. The division is made on the basis of the optical properties. Opaque phases are nontransparent, which means that a different type of microscope must be used. A conventional microscope uses transmitted light while the microscope for opaque phases or the ore microscope uses reflected light.

This degree project summarizes five years of education at the landscape architecture program at the Swedish University of Agriculture Sciences, SLU, Alnarp and the School of architecture at Royal Institute of Technology, KTH, Stockholm. The project has been carried out by Lovisa Berg and Per Crona in collaboration with DRIFT Scenkonst. This master project is based on the ongoing transformation of a former mining site in Ställberg, Bergslagen situated in central Sweden. The organization DRIFT is in the process of recreating to former industrial mining site as a green cultural center. Their field of artistic examination concerns existential questions connected to the site. The aim is to offer a place for both performing and experiencing contemporary performing arts in Bergslagen. Our objective is to contribute to the growth of the performing arts project and to demonstrate in concrete terms how a conversion of a mining area can be completed, while taking into account both its history and its new function.

SUMMARYEnvironmental issues are currently a hot topic of debate. Studies within the optics branch have not specifically been conducted previously, so the aim of this study was to determine the extent of environmental-awareness specifically within this branch.A survey, consisting of questions relating to environmental issues, was distributed to 100 randomly-selected opticians in Sweden. Of these 100 surveys, 64 were returned and showed a varied branch-engagement for environmental issues.Results of this survey showed that opticians were best in sorting newspapers, magazines, other paper and hazardous waste. Metal and rigid plastic were not sorted to any larger extent.Choosing environmentally-safe products was not so popular and only six stores always do this. 25 shops turn off electrical machines and equipment over night; while the majority of the remaining stores leave the machines on during the night.27 stores did not know if their electrical company provided ?green electricity?.Results showed that there is a lot of work to be done in making the stores more environmentally friendly.

Considering that the price and demand for energy gradually has risen over the past decade and a wider discussion about the human impact on the environment has become increasingly more important and given a clearer role in modern society. This has contributed to increased incentives to reduce the use of fossil fuels and increase the use of renewable energy.The agriculture currently accounts for 20 % of Sweden's total greenhouse gas emissions. A way for an agricultural company like Wapnö AB to reduce their emissions could be to utilize existing renewable energy sources within their own premises.The report's aim is to create an energy audit of Wapnö?s existing energy system and how it changes with a future biogas plant in operation. The energy audit is used to illustrate how the company?s climate footprint could change.

This report is the result of a thesis work carried out on the Risifrutti production at the company Procordia Food AB. The thesis is at a master level and is the final work for the author to receive a Master of Science in Innovative production at Mälardalen University. The thesis comprises 30 credits and has lasted for 18 weeks. The thesis is mainly a research on whether it is possible to perform an Environmental Value Stream Map (E-VSM) in a food processing industry and an evaluation if the tools E-VSM and Green Performance Map (GPM) are useful in this type of industry. An extra part to this research is to use the results from the E-VSM and give Procordia Food AB information on improvement potentials in the Risifrutti production. The author has found it difficult to collect some of the quantitative data to the E-VSM, mainly regarding energy, but by using the Value Stream Mapping (VSM) tool and other Lean tools the author was able to identify and quantify several wastes in the Risifrutti production. Recommendations for improvements based on these wastes have been given to the company. In the research part of this report the utility of the Value Stream Map, Environmental Value Stream Map and Green Performance Map in a food processing industry have been analyzed. The author has found that the Value Stream Map has been a useful tool since waste and unevenness in the tact of the production has been identified. The Environmental Value Stream Map and the Green Performance Map are also great tools when a company wants to analyze their environmental impact and then invest in environmental improvements. However, no profound energy analyzes has been done in the Risifrutti production because of the lack of energy meters for steam, electricity and compressed air in the production lines..

SammanfattningBegreppet slöseri, av engelskans waste, är en term som i dagsläget saknar en klar och entydig definition inom mjukvaruutveckling. Denna rapport har skrivits vid Kungliga Teniska Högskolan i Stockholm och syftar att klargöra termen slöseri och vad den innebär men hjälp av olika projektledningsverktyg från IT-branchen. Det har framkommit att förtag sällan jobbar med en och endast en projektledningsmetod inom mjukvaruutveckling utan det blandas verktyg från olika metoder. Det är ofta brist på kunskap om valda verktyg och hur de ska användas samt vilka olika verktyg som kompletterar varandra eller ej är kompatibla med varandra. En ökad medvetenhet kring valda modeller och verktyg skulle leda till ökad effektivitet och minskat slöseri.

This final year project is made for Peab Jönköping and its target group is the construction industry. The main focus is the use of unutilized building material in the most economical and environmental-friendly way. Unutilized building material is here defined as material purchased for a construction project that for different reasons not has been used. The most important thing to find out was how much building material considered as being waste is actually useable material, and how much less it costs to use that building material instead of throwing it away.When this information was gathered a proposal on how to efficiently use the unutilized building material instead of wasting it was designed. Costs and incomes were investigated and the proposal suggested a storage area where Peab can store their unused building material.

The task of making a correct application for B- activities is the foundry time consuming task. Information and facts concerning your entire business activity shall be attached into a description of environmental consequences, which will be the basis for the decision making whether the activities shall be granted a permission to practise environmentally hazardous actions or not. When the Environmental Act were established 1999, the permission process became more extensor. With this study I want to give an insight about how these applications are made. The methods I have used to collect information are a study literature where the Environmental Act has been the focus, and qualitative interviews with two County Administrative Board. I used the Environmental Act to understand why permission is needed and the interviews to give me insight in how the work is done. My conclusion is that it is very unusual that an application is granted without complements.

Because of the increasing trends in energy consumption and increased environmental awareness, greater focus has been placed on improvement and development of renewable energy sources. An already proven and accepted method is biogas production from anaerobic digestion at municipal wastewater treatment plants.In the waste water treatment process solid material and dissolved pollutants are separated from the water, forming a sludge. The sludge is separated from the process and stabilized during anaerobic digestion or aerobic aeration. Most often, mesophilic anaerobic digestion is used. Because of degradation by microorganisms, biogas with a high content of methane is formed during the digestion.

3D modeling is a common tool in landscape architecture. Today, there have been new ways in which virtual 3D models are successful tools in the dialogue with the public. These new methods involve children and young people who are groups that is hard to reach and engage in citizen dialogues. The purpose of this work was to investigate how a virtual 3D model works in the landscape architect?s communication with the public through the project Gruvstadsparken in Kiruna. Through workshops, I wanted to communicate Gruvstadsparken to get ideas from participants on how the park can be used and be revisited.

Certain types of waste, e.g. bottom ash originating from municipal solid waste incineration (MSWI bottom ash) can be used as road construction materials. A potential problem is the possibility of substances leaching out of the road and spreading in the surrounding groundwater.The aim of this master?s thesis is to conclude whether hydrogeological type settings can be employed to, based on local conditions, provide an estimate of the probable spreading of these substances in the surrounding groundwater, and whether certain types of soils can be identified as being less suitable for the localization of a MSWI bottom ash road. A hydrogeological type setting is defined as a mappable unit with similar hydrogeological properties.

The building sector accounted for around a fourth of the total energy usage in Sweden in year 2010 (Energimyndigheten, 2012). Therefore it has become very interesting to achieve a lower energy usage in residential buildings. One way to achieve that is to build so called passive houses. By being very well insulated and have low leakage through the walls, they can reduce the energy usage for heating with a substantial amount. The first passive house was built during the 90?s in Germany; and in Sweden the first passive house was built in Gothenburg 2001.