One of the most serious and economically important defects caused by clostridia in milk products is the late blowing of semi-hard cheeses.Clostridia occur naturally in soil and can contaminate milk through crops contaminated by dung and soil followed by a less successful silage process, that give them opportunity to grow unaerobically. When anaerobic conditions occur, such as storage of semi-hard cheese, they ferment lactic acid to butyric acid and the gases CO2 and H2.At the fusion of Arla and MD Foods, a series of changes were conducted on the MPN method for lactic acid fermentation for clostridia in milk. These changes resulted in an increased accuracy due to an increased number of test tubes and the change of media from MRCM to BBB, Bryant & Burkey Broth, that was thought to be more selective for Cl. tyrobutyricum, the organism mostly found in hard cheese. When the number of dairy farmers that were given quality reduction fines increased, the new method was suspected and a validation was conducted.The validation included inoculation of different clostridia and bacillus strains into BBB substrate and enzymatic testing of positive samples with Rapid ID 32A.

Sweden's drinking water quality is considered to be high partly due to a high quality of the raw water and a well developed sewage infrastructure. Despite this, there is water contamination that could be prevented by installation of a sophisticated early warning system. Some of the major players in the production of drinking water have already invested in different types of early warning systems to ensure drinking water of high quality. There are various forms of early warning systems where automatic monitoring of E. Coli is an interesting alternative.

For several years Uppsala University together with several companies has been involved in a WISENET project aimed at improving railway transport security. By placing a sensor system near the wheels of each wagon, the temperature of the bearings can be measured and transmitted to a collector placed centrally on the wagon. This in turn transmits the collected data to RFID receivers placed intermittently along the railway.As the signals are transmitted wirelessly, problems may occur as the antennas get dirty or coated with ice and snow. To determine the effects of these coatings, several tests were performed examining the reflection coefficient S11, the impedance Z11 and the efficiency eta of an antenna, and how they varied when various coatings were placed over the antenna. Examined coatings were ice, snow and water to determine the effects of weather, and various metal-based coatings: powdered iron both pure and partially oxidized, and iron ore granules.

The increasing oil prices during the last years have made it profitable to use cereal grains as a fuel. When compared with wood, cereals contain higher amounts of Cl, S and ash. The Cl and S content makes the gases from cereal combustion more corrosive than gases from wood combustion. The goal of this master thesis was to find out the variation of Cl, S and ash content for oat grain grown under different conditions. Oats was chosen because in Sweden it's considered as the cereal with the best fuel qualities.

This report describes the construction of a climate-cabinet for testing of HV-cards (High Voltage) produced at VG Scienta. The main part of the report describes all the different components of the cabinet. The most important parts are a PID regulator from Eurotherm model 2408, a solid state contactor (SSC), a thermocouple, a finned resistor from DBK and different fans. The report even includes the connection between components by cable wiring, isolation, grounding, fuses and shaping of metal goods.As the cabinet also communicates with a computer, the report includes the solution of the data communication using the software iTools from Eurotherm. The communication part includes information about a converter that converts EIA422 to USB.The cabinet was produced at a company, called VG Scienta, in Uppsala during the spring 2010.

The Kverneland Ecomat and The Ecomat Seeder has been tested in three different field studies. All the studies were conducted on soils with different clay content during 2005 in Säby outside Uppsala. In one of the trial spring ploughing with the Ecomat and spring ploughing and seeding with Ecomat Seeder were compared with conventional autumn mouldboard ploughing and spring mouldboard ploughing to conventional depth (22-23 cm). In this study the quality of the seedbed, the number of emerged plants and weeds, the pentration resistance and the yield were examined. Shallow spring ploughing (10 cm) with the Kverneland Ecomat has shown to be a good alternative to conventional autumn ploughing when growing spring crops. During the season 2005 tilling with the Ecomat resulted in a higher yield than conventional ploughing. In 2002-2005 the average yield for shallow spring ploughing was 4 percent higher than after conventional autumn mouldboard ploughing and 10 percent higher than after spring mouldboard ploughing to conventional depth (22-23 cm). In the other two studies, ploughing to different depth in the autumn with the Ecomat was compared with conventional mouldboard ploughing and stubble discing.

Smallholder farmers in Uganda suffer from declining productivity. With a rapidly increasing population, marginal land is taken into production and the current land management leads to loss in soil fertility and escalation in soil erosion. There are studies indicating that the use of agroforestry increases soil organic carbon (SOC) compared to systems without trees. Soils which are high in carbon have many advantages, for example better water holding capacity, which can reduce stress on crops during drought. The aim of this study was to determine the effect agroforestry has on SOC concentration in small-holder farming systems in Uganda. The intended system to study was farms practicing agroforestry methods or not in intercropped plantain (cooking banana) fields.

Svenska Aerogel AB has developed the material Quartzene® which is of the typeprecipitated silica and contains calcium - magnesium silicate ((Ca, Mg) SiO3). Thematerial is used for molecular filtration of contaminated air. Qartzene?, which is inpellet form, is porous and has a high internal surface which is a requirement for themolecular filtration. With the use of various impregnations, filtration can affect thedesired outcome.

This study is a degree project in environmental engineering at Mälardalens university. Its purpose has been to perform a risk assessment on whether or not any contaminations are present in the soil at two properties in Köping. The assessment was to be done accordingly to a method that has been set up by The Swedish Environmental Protection Agency (Naturvårdsverket). The method for investigation of contaminated sites is called MIFO. MIFO consists of two stages.

It is common knowledge that our horses do occasionally hurt themselves and cause damage to their bodies. They also manage to do it in the most remarkable ways. The problem is not that they hurt themselves, because everybody does so from time to time. The problem is that they often experience difficulties with the healing of the wounds. The cause to that problem is the fact that they often lose a vast amount of tissue, the wound is more often than not extensively contaminated and the wound is often found a long time after the accident occurred.

Lättelement located in Örnskoldsvik AB is one of Sweden's leading companies in the development of building elements in the form of roofs, walls and floors made ??out of light beams. The company has clients from Lund to Kiruna, and from Norway. This means that the elements have high standards when they have to take many different loads from wind and snow due to such wide geographic variation.The roof elements are structured so that the main body is made of light beams with an I?profile.

It is imperative to provide more information regarding changed conditions resulting landslide events in a future climate. The aim of this thesis is to assess landslide susceptibility in Huddinge Municipality in middle Sweden. The main purpose is to produce a map, to visualize landslide susceptible areas, and to integrate the result with changes in physical factors such as climate change. Also, the thesis aims to analyze anthropogenic factors such as changes in land use and an increasing population in Huddinge Municipality. Methods used are GIS-analyses, interviews with staff of Huddinge Municipality, and field observations.

Åfors glasswork was a company which started in 1876 and closed in 2012 due to the bad economical situation in the company. After its closure, the glasswork left behind contaminated soil with different concentrations of heavy metals such as, arsenic from arsenic trioxide, a chemical used to remove bubbles during the melting of glass, and lead oxide, a chemical used in the production of crystal glass. Crystal glass?s production occurred under 1921-1971, but emissions of lead into the air from Åfors glasswork continued until 2011, because of the artist Bertil Valliens? artglas was made in Åfors glasswork from 1970?s and onwards.The aim of this study was to estimate how much lead (Pb) and arsenic (As) that were released by Åfors Glasswork into the atmosphere during the operational period of the glasswork in comparison with how much of lead and arsenic were purchased for the company. Added to the assistance of the data from National Archives the variations in the activities of Åfors glasswork could be shown.

With a growing population on earth the amount of end-of-life vehicles (ELVs) and other scrap steel increases. The European Directive 2000/53/CE? requires a minimum of 95 % reuse and recovery and 85 % re-use and recycling no later than 1 January 2015, for end-of life vehicles. This imposes a need for more efficient recycling and recovery. Despite this shredder residue (SR) is commonly land filled.This report investigated the magnetic fines residue generated at Stena Metall shredder facility in Halmstad, Sweden.

This master thesis encompasses an inventory and risk classification of four disused landfills within the municipality of Uppsala, Sweden. The model of the classification; ?Method of Surveying Contaminated Sites? is developed by the Environmental Protection Agency and can be used as a framework to investigate and describe the environmental damage and the level of risk for each object. The risk classification model has a rating from 1 to 4, where 1 represents a very high risk while 4 is a small risk. Risk class depends largely on the type of land use that exists on the object, and hence, various benchmarks must be taken into account.