Audionomprogrammet.

The purpose of this paper was to investigate whether Suzanne Retzinger?s linguistic cues for shame and verbal behaviors for hiding shame could be used to measure shame in surveys based on Thomas Scheff?s theory of shame. I created a measurement instrument consisting of 30 statements, which were all meant to measure general shame.The instrument was administrated to 180 respondents studying at Karlstad University, of whom 4 respondents were removed from the data set due to lack of standardization. With the polytomous rasch model used for the analysis, data from 176 respondents were analyzed, of whom 124 respondents were female and 52 were male.The result showed that the measurement instrument?s statements should not be used together because the analysis indicated multidimensionality.

The student project Elba at KTH started in 2011 and is a project where a battery driven prototype car is developed. The vehicle competes in Eco Shell Marathon in Rotterdam, Holland. In this competition the vehicle that travels a certain distance including several starts and stops with the lowest energy consumption wins. To minimize the consumption is therefore very important, which requires knowledge of the vehicles energy losses.A vehicle's energy losses depends on several factors and can be divided into the powertrain efficiency and the driving resistance. The driving resistance can then be divided in to rolling and air resistance, if smaller losses like vibrations are ignored.

This is a report of our examination project in electronics carried out for Bofors Test Center in Karlskoga. The task was to construct an electronic devise for starting up different kinds of Measuring systems in exact time during test sequences. The modules that are used today are old and unreliable. Our goal was to construct a prototype, which later on is supposed to be developed into a useful system..

The purpose of this thesis work was to develop an automatic fault detection system for surveillance of bearing temperature in hydropower turbines. The parameters used except the bearing temperature were cooling water temperature and cooling water flow. A simple static model based on data sampled every minute was developed to estimate the bearing temperature. Then a detector for detection of change in bearing temperature based on the CUSUM-algorithm was designed. Since the amount of data was very small the developed model was too uncertain to be used in a working system.The designed fault detection system showed to work well for the available data.

The urbanization of the world is increasing. How it affects bird populations have been well studied during the last decade, and comparisons between urban and non-urban habitats have been carried out. A common method for Measuring habitat quality is to calculate the population density. This method is easy to use, but have been criticized during the last couple of years. In this study, data of population densities was compared with data on reproduction success.

The mining company LKAB extracts iron ore in three areas in the north of Sweden, Kiruna, Malmberget and Svappavaara. The iron ore is refined and in the pelletizing plants the material is rolled to finished pellet product. The different steps of pelletizing plants causes among other things emissions to the air. It occurs occasionally stops in the production and the emissions are vented via an emergency chimney without purification. The aim for this work is to look into how LKAB may improve their monitoring of air emissions and control of ambient air quality and the analysis methods which are suitable for Measuring.

This master thesis has been carried out as a prototype development project. The project hasbeen performed in cooperation with ÅF Combra AB. The purpose with the master thesis is toconstruct a Bluetooth interface between an accelerometer and a smartphone and constructinga physical prototype containing an accelerometer. This is done to test a new user interface tomobile phones. The master thesis has also included a research about the possibility toimplement distance Measuring with Bluetooth.

Smartphone applications, or apps, are an increasingly important part of omnichannel retailing. While the adoption and usage of apps for communicating with consumers has grown exponentially over the past few years, there is little academic research in this area. The primary purpose of this thesis is to describe how the involvement in a product category affects consumers' intention to use a retailer-branded smartphone application during their shopping trip. Drawing upon recent IS-literature with models TAM and UTAUT, our results indicate that product category involvement constitutes an important factor on the intention to use a retailer-branded smartphone application. By viewing involvement as a multidimensional construct, our study shows that the degree of hedonic and expressive value a product cateogry provides consumers with has important effects on intention, and these relationships are not moderated by consumers' age.

Skin temperature is detected through signals in unmyelinated C-fibers and thin myelinated A?-fibers in the peripheral and central nervous system. Disorders in thin nerve fibres are important and not rare but difficult to diagnose by the most common neurophysiological methods. In this pilot study different methods for quantitative sensory testing, QST, were compared to give some ideas about which method could be the most efficient to use in order to point out injuries of the sensory system in clinical practice. The comparison was made between Békésy (separate warmand cold thresholds) and Marstock test (combined warm and cold thresholds).

This thesis aims to develop a control system for Measuring electromagnetic compability (EMC). This has meant that a controller designed around an ATmega8 microcontroller has been manufactured and programmed. It has also meant the development of a comprehensive control software in the program MATLAB. The control system has been tested with satisfactory results and can now, monitor and control measurements of the EMC-type..

We set out to compare two different categories of workers: the, so called, white- and blue collar workers. The studies aim was to measure if there were any observable differences between the two in means of optimism and sense of coherence. There are two tools created for Measuring optimism and sense of coherence, the Life Orientation Test ? Revised (LOT-R) measures an individual?s level of optimism and Aaron Antonovsky devised a test for Measuring an individual?s level of sense of coherence (SOC). Optimism is best explained like a way to measure anticipation, how an individual expect future events to fall out.

From embankment dams is something that has long been noticed and given rise to different questions. The most serious question is if the sludge is a result of inner erosion through the dam, and thus consists of material transported from the dam. Concerns have also been raised whether the sludge could interfere with the systems drainage capacity and thereby lead to high pore pressure in the dam, or if the measurement of seepage is disturbed, as the Measuring is usually made via Thomson weirs, which could risk being blocked. The result of this investigation shows that the sludge is a result of the oxidation of iron by iron bacteria, and to the greater part consists of these oxides as well as the bacteria?s own structures. The iron oxidizing bacteria, FeOB, oxides ferrous iron to ferric as a part of their metabolism, and thereby create large quantities of iron(oxy)hydroxides.

AbstractObjective: The aim of this study was to investigate the statistical properties of a self-assessment instrument for depression, Känsloläge, with regard to validity, reliability and factor structure. Method: The data collection method used for the study was mail questionnaires. The sample consisted of patients who had received treatment for heart failure, arrhythmic disorders or coronary heart disease at a hospital in Uppsala, Sweden. The study population consisted of 53 patients. The self assessment form?s validity was analyzed by Measuring the criterion validity.

In this bachelor thesis, diagnostic methods for one of Siemens stem inlet control valves have been developed. The work has taken place during ten weeks at Siemens Industrial Turbomachinery AB in Finspång. The company produce steam- and gas turbines and also provides service and maintenance. The purpose with this project has been to develop diagnostic methods that oversee the health of the control valves. By using the developed methods you will know when it?s time for maintenance.