SUMMARYThere was no previous study in what high level dressage riders had for ideas of how to best prepare for their training sessions with an instructor. Neither any study of how high level dressage riders seemed to be more or less susceptible to the instructions from their instructor during their training sessions. If the sport had more knowledge about this, it might result in more riders on a higher level. The purpose of this study was to find out how high level dressage riders are preparing themselves for the best result for an instructor led training session and how they could bring as much as possible instructions from the coach. The two questions of the study were: How are high level dressage riders preparing themselves for a training session with an instructor, practically and mentally, and how can they affect their susceptibility to instructions?The study was carried out both by reviewing existing literature and studies in general education and pedagogy in the riding education, and by a qualitative interview study of six dressage riders who rode on a difficult level at the competitions, during the year of 2009.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

In today?s society there is an increasing demand for renewable energy sources such as sun and wind power. These sources are intermittent, and energy storage is therefore needed to ensure a constant power supply. This report compares pumped hydro energy storage (PHES), compressed air energy storage (CAES), flywheels, batteries, super magnetic energy storage (SMES) and hydrogen energy storage.The opportunities for further development are limited for PHES and CAES in comparison with the other technologies. Lithium-ion batteries and hydrogen energy storage are considered to have the most potential in the future.

Today many different types of lock systems are used all over the world. Passwords, finger prints and magnetic strips are a few examples. When the key is a three dimensional object, lika a physical metal key, the security depends, in a high degree, on that you can?t copy the object without access to it. One approach to copying the object is photographing the object, and from these photographs create a copy.

Hospitals have a set perception as an unpleasant and frighteningatmosphere.The examination-rooms of today within the children?shospitals are often bare and needs embellishment and decoration tocreate a satisfying setting. The decoration might have the function asa divertion from pain and anxiety.According to my experience the decorations of today consists mainlyof Winnie the Pooh figures, a clown or a hockey poster, never anythinglinked to the body and it?s functions.Spina, Thorax & Femur is a project that focuses on the visual identityand possibility to a deeper understanding and playfulness around thebody perception within the nursing environment.A visit at the hospital could be part of a creative knowledgeacquisition. The project result are two boards of glass-enamelledsteel.

Magnetic resonance imaging (MRI) is a safe and painless diagnostic method. The patient may become concerned, suffer from anxiety and experience the examination as unpleasant. Detailed information and a good treatment can reduce anxiety and distress for the patient. The purpose of this study was to illuminate the patient?s experiences in connection to MRI, and to describe the patients needs for information and treatment.

Zero knowledge protocols is a lesser known type of protocol that can be used for identification. These protocols are especially designed not to reveal any information during an identification process that can be misused later on, neither by the one who should be convinced of the identity of the user, nor by anyone else that is eavesdropping. Many of these protocols are also especially designed for implementation in smart cards. The more common type of card with a magnetic stripe has during the last few years become more susceptible to attacks since they are easily copied. Smart cards combined with a secure identification protocol has been predicted to be the solution to this problem.

This research analyzed differences in measurements of magnetic field strength and frequency response in five audio induction loops installed in rooms of wooden construction materials and five audio inductive loops installed in rooms of steel reinforced concrete constructions. The inductive loops were installed at floor level and the measurements were made at the listening height of 1.2m. Measurements of background noise, field strength and frequency response were made at fifteen different measurement points across the room. The research measurements showed that there are differences in field strength and frequency response between these two conditions, whether the audio induction loop is installed in a wooden construction or the audio induction loop is installed in a reinforced concrete construction. The results had a significance level of p=0,05..

Detta arbete har som syfte att studera upplevd Agency. I bakgrunden för arbetet presenteras tidigare studier kring Agency och val i spel. Dessa används sedan för att ta fram tre designprinciper: Tydlighet, motivation och variation. Arbetets frågeställning gick ut på att se om dessa principer i praktiken ökade Agency och vilken princip som var effektivast.För att besvara frågeställningen till arbetet skapades sex stycken banor till spelet Magnetic. Tre följde de ovan nämnda designprinciperna och tre bröt emot dessa.

This report describes the design and construction of a prototype that automatically aims a microwave link towards a target. The link, that is located on a mobile aerial mast, is used by Saab Training Systems as a part of an infrastructure network. The report also discusses the development of a GUI that communicates with the control unit by Bluetooth.The control unit, called Pan/Tilt-controller, controls the position of the link by stepping motors. One motor controls the azimuth angle and the other one controls the elevation angle.By a GUI the operator enters the coordinates on its own position and the targets position. Hereafter a bearing is calculated and it will be sent up to the control unit.The control unit will sense its own direction by a magnetic sensor that works as an electronic compass.

Functional Magnetic Resonance Imaging, fMRI, can be used for analyzing brain activity in subjects performing language tasks. The purpose of this study was to develop aphasia-friendly information adjusted to aphasic subjects participating in fMRI studies. The objectives were to investigate if adjusted information was important for the ability to perform language tasks and if the information could be used for different types of aphasia.Sixteen aphasic subjects participated in the study, six of these underwent fMRI. The participants varied in grade and type of aphasia. They had Swedish as their native language and were aged between 26 and 89, mean 57.

Lameness localized to the hoof is a common problem in horses. Magnetic resonance imaging (MRI) as a diagnostic tool is becoming more common and is well suited for examination of the distal limb and the hoof capsule. Today there are two different methods of MRI where in one the horse is under general anesthesia and in the other the horse is standing and only sedated. In this study we have compared the visualization of the distal interphalangeal joint using these two methods in two different groups of horses with unknown clinical problems referred to two different equine hospitals. The width of the joint structures including thickness of joint cartilage and joint fluid and also the width of the dorsal pouch of the distal interphalangeal joint were measured.

This master thesis studies distributed navigation which isa function implemented in a future network based combat information system to improve the accuracy in navigation for combat vehicles in a mechanized battalion, above all in the event of loss of GPS. In the event of loss of the GPS the vehicles obtain dead reckoning performance through the backup system that consists of an odometer and a magnetic compass. Dead reckoning means a drift in the position that makes the accuracy in the navigation worse. The distributed navigation function uses position and navigation data with measurements between the vehicles to estimate the errors and uncertainties in positions, which are used to improve the accuracy in position for the vehicles. To investigate and demonstrate distributed navigation, a simulation environment has been produced in Matlab.

The assignment is issued by Scania Maintence AB seeking a new approach to detect power changes in their industrial processes. The work has taken place at Ångströmslaboratoriet and tests have been performed at Scania AB Södertälje.Today?s society consumes enormous amount of energy. In both economically and environmental view, it is important that the processes are effective, with high power factor. There are many ways to measure power in the industry, what they all have in common is that the installation is advanced, requires time and planning.

This thesis analyses how a radiology department at the largest hospital in Sweden, Karolinska University Hospital, most profitably could expand its capacity for investigating cancer patients using magnetic resonance imaging (MRI). The queues today for patients waiting to be scanned are long, which delays the start of cancer treatments. Meanwhile the hospital has a budget deficit of half a billion SEK, which make any expansion hard. In this thesis we evaluate the alternatives of investing in new machinery; utilize the current machinery better by using them more days annually or through a shift work system. Finally we evaluate a combination of these.