The aim of this essay was to obtain an understanding about company owners thinking about the connection between having an own company, and the risks for an alcoholic abuse. The risk factor I was researching was stress, alcoholic culture, accessibility and rehabilitation.I have interviewed five owners of small companies, two women and three men, which represents four different kinds of branches. The theories I used in analysing the empirical findings where the theories of psychosocial work environment of Lazarus, Karaseks demand/control model, epidemiology- and culture perspective.I have found that the main stress factors for company owners where the economical stress and great load of work. The stress was also related to the fact that company owners of small companies often were alone with all the responsibility and problems.Women did not use alcohol very often as a tool to reduce stress. If individuals were using alcohol to reduce their stress, it also had to deal with their ability of coping and also what channels they had for coping..

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

The company LightLift Esystems AB manufactures patented motorized lift systems for the illumination of halls with high ceilings. The company wants a new design for singular heavy lights in order to be more competitive.This project consists of the development of the new design under the requirements and specifications imposed by the company. The new design must support lights up to 300kg and keep the overall dimensions as low as possible without modifying the driving unit.This document contains all the designing steps followed to reach the final solution as well as the material selection, manufacturing process and assembly of all the parts that form it.The solution obtained shows to be very competitive with other alternative products, since this new design triples their maximum load capacity while the dimensions are very similar.In this context, the optical appearance was also very important to the company and so it was another main objective of this project. From an aesthetical point of view, the final solution proves to be very compact and versatile since it can either be hidden behind a false ceiling or covered by a plastic case that gives the design a very nice look.Finally, the solution achieved fulfils all the requirements and specification previously imposed. It is reliable, compact, cheap to manufacture, easy to assembly and it has a good optical appearance. .

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

Today?s wind power plants are only compensated for their reactive power consumption at no-load. As the wind power plants grow bigger the amount of reactive power they need also increases. This is no longer a problem that can be ignored, especially as the net owners are beginning to charge the reactive power they transport.In this thesis a couple of different methods of compensation and their prices will be discussed and evaluated. Problems, such as self-excitation, that can occur if one fully compensates the wind power plant will also be brought to surface.

The purpose with our thesis is to understand and explain the advantages and disadvantages there is with the self scanning system. The advantages and disadvantages we will highlight from three different angels; the store management perspective, the staff perspective and the customer perspective. These three perspectives will together form an overall perspective over the advantages and disadvantages as the self scanning system has contributed with. Finally we will highlight the differences and resemblances we have found between the perspectives.Through a qualitative approach we have gathered data to our thesis. Furthermore we have based our theory chapter and our empirical chapter on the base of Grounded Theory.

The Swedish winters 2009/10 and 2010/11 were rich in snow and many roofs collapsed, mainly largespan frames. Investigations were made and the amount of snow was not the primary cause, insteadthere were several other causes. One of these was that in some cases roofs were shoveled in anunfavorable manner which affected the load patterns negatively, so causing the roofs to collapse.Most people lack the knowledge of how shoveling will affect the roof. Had there been an increasedunderstanding regarding shoveling, some roofs could have been prevented from collapsing.Through both qualitative and quantitative research in the form of interviews and calculations thetheoretically best ways to shovel a selection of roof types is presented in the report. The roofstructures covered are 3-compartment, continuous and Gerberspliced metal roof decks.

In order to rescue a distressed submarine crew, the Swedish Navy is able to use a deep submergence rescue vehicle, DSRV. This mini submarine ascends, docks to the downed submarine and picks up the whole crew. The submarine rescue ship HMS Belos has a special crane located in the aft of the ship to lift the surfaced DSRV aboard, which then docks on to the on board pressure chambers located below deck. During inspections the aforementioned crane has shown to have problems with cracks in the structure, most of them located in the bolted joint between the top part of the crane and the two leg parts. A simulation of the forces acting on the structure in heavy sea condition was conducted; these values were then used as input values in a Finite Element Method, FEM, analysis of the joint.

Sub Saharan Africa has during the last decade become the world?s fastest urbanizing region. This change is concentrated to a few metropolitan areas one of them being Dar es Salaam, the largest city of Tanzania. Since the 1960s Dar es Salaam has grown from being a relatively small coastal city of approximately 300 000 people to become a bustling urban centre of four million inhabitants. This development has had a major impact on the city structure, which in turn has affected people?s welfare and the surrounding environment. One such consequence is the detrimental loss of urban vegetation and open areas in the city.

In Sweden live badgers are used in tests in order to train and prepare earth dogs for hunting underneath ground. This has for several years causeddebate concerning the welfare of the badgers. It is questioned whether the purpose of the dog training, i.e. to reduce injuries in both dogs and prey, is worth the suffering that is reflected on the badgers. The aim of this investigation was to study 1) stress levels in badgers when used in earth dog training, 2) if the stress load differs when the badgers are exposed to dogs with varying aggression levels (low, moderate, high).

Since 1 January 2010 it is a requirement to use the European standards, Eurocodes, in Sweden when constructing bridges. One chapter that has caused an extra amount of problems for the engineers is the one about fatigue analysis, which resulted in us doing this thesis.To do this we had to read all of the Eurocodes that direct, or indirect deals with fatigue and calculating of such. We have read the background documents for the Eurocodes and master?s thesis in the subject. We also studied the calculations of bridges constructed by different construction firms.We have chosen to limit the thesis to discuss only road bridges made of concrete due to the lack of method for verification of concrete in the national appendix.

BACKGROUND: One of the nurse?s areas of responsibility is to relieve suffering. Research has shown that nurses give an indication of an emotional load in the interaction with dying patients. This means that patients need of relieved suffering gets disregarded because of nurse?s fear of the unknown.

During 2010, 1446 people committed suicide in Sweden. Research shows that groups that are less favored in society have an increased risk of suicide. Social services often encounter groups of people that have a high risk of suicide, for instance welfare recipients or substance abusers. The purpose of this study was to shed light on how social workers talk about suicide and how this might affect interactions with suicidal clients. The study is based on qualitative interviews with five social workers in Stockholm.

The aim of this study was to gain insight into how two enterprises work with competence development and thereby study how the relationship between competence development and workers, employees, look like. The focus was on the workers motives and motivation towards a participation in a competence development course, their attitude to education, and how the transfer of skills gained from the course, into the workplace looks like. Further on, the work situations influence on the workers competence development has been taken into account.In the study, six people were interviewed in the role of either manager, coach or course participant who are employed in two different enterprises in the south of Sweden.The results showed that the participants were motivated by a strive for personal development or that the participants viewed education implementation as a part of the professionalcareer, which has resulted in a positive attitude towards the competence development course. The managers? motive for decisions about education was to change the prevailing attitude among the staff for the better and thereby strengthen the company?s brand. The work situation has encouraged the desire to participate in developmental education as the feeling of control has encouraged the workers to further development.