This is a study of the insect community associated to the wood-decaying fungus Inonotus radiatus found on Alnus glutinosa trees growing in riparian forests at the northern and southern shores of boreal lakes in the province Uppland. Little is known about this particular bracket fungus and its inhabitants. Insects were reared out at the Laboratory from samples of fruiting bodies of the fungus taken at five lakes. During the fieldwork in 2009, data about several environmental variables was also taken. After the rearing period, these variables and their effects over the insects were analyzed.

The guinea pig is an important meat-producing animal in Peru as well as in several other South American countries. They are held in different kinds of systems, from the small backyard breeders with few animals to the large commercial farms with thousands of guinea pigs. One of the major issues at the farms is animals dying of unknown causes. Salmonellosis is often considered as a major cause, but samples for confirmation are rarely taken. It has been known for a long time that Clostridium difficile (C.

Several studies have shown that people misjudge and fail to correctly combine probabilities. An explanation for these tendencies is the conjunction fallacy. Basically, the conjunction fallacy refers to violations of the conjunction rule, which states that the probability of a combination of two independent events (A & B) cannot exceed the probability of neither event (A or B). In connection with the growth of the Swedish gambling market and the fact that betting is an everyday-event containing well-defined probabilities, it is considered to be both up-to-date and relevant to study whether the conjunction fallacy also occurs in betting. Previous studies have shown that people fall victims of the conjunction error, however, only in controlled Laboratory settings.

Ever since ABB has begun diecasting their rotors instead of permanent mold casting it,variation in the quality of the cast has arisen. Diecasting is performed in three differentmachines, M1, M2, M3 with 400, 660 respectively 800 tons of die locking pressures.The aim of this thesis is to answer the following questions:What is the ?right? cast quality? How is the right quality achieved?For sizes 160-180 solutions will be proposed that consider eccentricity between thelaminate and the short circuit ring as well as elimination of the thin Al film that appearson the outer periphery of the rotors.Through considering the statistic material the most often diverging rotor type has beenidentified and one of the actual rotors has been sent to a Laboratory to be analyzed inorder to establish the current defects. The result of the analysis shows that there areplenty of gas- and oxide-porosity.It has been proved that every time the dies temperature decreased below 120°C thecontent of gas porosity increased. It is due to rapid solidification of metal that flowsthrough the ?cold? laminate.It has confirmed that enhanced porosity in squirrel cage causes high impedance in therotors.

Den här uppsatsen är baserad på en enkätundersökning samt intervjuer med gymnasielever angående deras tankar kring djurförsök. Jag har intervjuat studenter från två olika naturbruksgymnasier. Båda har inriktningen djurvård men det är endast en av dem som ger en specialiseringskurs inom forskningsdjur.Min frågeställning är att undersöka om elever som läser kursen i försöksdjurskunskap har en annan inställning än de elever som endast läser djursjukvård. Som resultaten visar så är de eleverna som läser specialiseringskursen mer positiva till både djurförsök och att jobba med försöksdjur. De har också en mer korrekt bild och större vetskap om hur verkligheten ser ut för försöksdjuren.

This master thesis is made of two parts. The first part concerns the method and results ofdesigning a motion control system for a piece of research-equipment called BIRGIT. Theequipment is made to be used for research on eyemovements. In the second part, a computermodel of a part of the balance organ in the inner-ear is developed. The work has been done atthe Bernadotte Laboratory at S:t Erik Eye Hospital.The equipment the control system is made for is a so-called rotationchair.

Beans are a global source of plant-based protein, and in some countries, they constitute a primary source of protein intake. With ongoing climate change, including rising temperatures, it is necessary to adapt beans to ensure a reliable food supply. An important mechanism that many plants have, to cope with high temperatures, is cooling through transpiration. During transpiration, stomata open and release water vapor. Water molecules use heat energy from the leaf to convert into gas, thereby cooling the leaf.

This thesis has been carried out on behalf of IV Produkt AB and intends to set an average ratio of thermal energy losses in apartment buildings that were built during the 1960-1990. This shall be derived by analyzing the total district energy consumption that has been divided into three parts: heat energy losses (the actual heating requirements), the heating of domestic hot water and heating energy consumption for the controlled ventilation.Three different residential areas that were built during the years 1962-1966 and one that was built in 1993 has been analyzed. All residential areas are located in Växjö urban and contains between four and six apartment buildings.The analyzed objects have a mechanical exhaust ventilation systems and district heating as the heating method. No own Laboratory work or experiments have been done in this thesis, the calculations have been done on the basis of parameters from VEAB, interviews with property managers, and literature studies. By calculations, we have got a result that is reported in Chapter 6.

Based on Laboratory studies with lysimeters, the concentrations of dissolved reactive phosphorus(DRP) and particulate phosphorus, which is the main part of other P (OVRP), has been studied inpercolating water. The experiment was conducted through irrigation of small soil columnscontaining clay topsoil from an experimental field in Västergötland. Three rain simulations wereconsecutively performed. DRP concentrations in the percolating water ranged between 0.2 - 0.3mg·Lclearly related to the phosphorus concentration in the soil, measured in a soil extract ofammonium lactate (P-AL). Concentrations of OVRP were relatively low and ranged between0.12 and 0.16 mg·Lwas not proven and the experiment may reflect how a relatively slow percolation of water mayrelease DRP.

Background Calprotectin is a protein expressed in the cytoplasm inside the neutrophile granulocytes. During inflammatory bowel disease (IBD), the neutrophile granulocytes are involved in a complex interaction at the inflammatory area where they die and release their content into the intestinal lumen. Therefore, calprotectin in stool is a suitable marker for diagnosis and measurement of the disease-activity in patients with IBD. The most commonly used method to detect calprotectin in stool is ELISA, but the process of manual preparation of stool samples is time-consuming.Aim The objective of the study was to evaluate an extraction method that could replace manual preparation of fecal samples and to compare different methods for measuring Calprotectin in stool using two ELISA-methods from two manufacturers and one rapidtest.Methods For extraction of calprotectin from stool samples we used sample collector tubes from Epitope Diagnostics and fecal preparation kits from Roche. Two different ELISA-kits for measuring calprotectin concentration in stool were compared.

When a person arrives at the emergency ward at the Uppsala University Hospital with his or her symptoms he or she explains the problems and then a priority process starts. The staff evaluate at which emergency level the patient is located in a model called Triage. The Triage model helps to decide the priority need and is based upon templates which point out in which of the 5 categories a patient is to be placed, to eliminate any future risk regarding his or her health. A lower triage level means lower priority but implies better health when the evaluation takes place. To obtain optimal effect of the Triage model the evaluation of symptoms must be reproducible so that patients with the same symptoms are placed at the same triage level regardless of whom among the staff conducts the evaluation. The purpose of the study was to see if the resources are allocated based on priority level of the patients.

In this report a system for Rapid Control Prototyping, RCP, is evaluated through animplementation of the motor control methods Field Oriented Control, FOC, and Space VectorPulse Width Modulation, SVPWM. The evaluation emphasizes on time-consumption andresource utilization on the used hardware and on usability for of software.A new mechatronic Laboratory is under development at ABB Corporate Research in Västerås. Itwill be used for both mechanical and motion control design using existing and new hardware.The control structure in a traditional robot system will be interfaced to a rapid prototypingsystem which should allow easy changes to algorithms at different levels in the system.The system designated for this project comes from National Instruments and constitutesLabVIEW Real-time and FPGA module as the software tools. The hardware is a NI Single-Board RIO (Reconfigurable Input Output), sbRIO, development board including a Field-Programmable Gate Array, FPGA, from Xilinx and a microprocessor from FreescaleSemiconductor. Graphical programming is performed in the LabVIEW environment, andthrough Xilinx tools the LabVIEW FPGA code is compiled to VHDL code.A pre-study was carried out to clarify the concept of RCP and investigate different systems forRCP and their traits.

Platelet aggregation is a major and common problem in blood samples from cats. This greatly affects the accuracy of counting of the platelets. Because of the difficulties in counting feline platelets, results for patients and reliable reference values for cat platelets are currently so inaccurate as to be almost useless in diagnosis of thrombocytopenia. In this study we used an effective method to prevent platelet aggregation. Blood was collected in CTAD test tubes and prostaglandin E1 was added to the blood sample.

In this thesis the methane gas potential of three different substrates, two algaes Saccharina latissima and Laminaria digitata and biosludge mixed with paper fiber was studied. This was done by batch experiments in a Laboratory environment to examine the gas production and composition of the produced gas.Biogas production is a complex anaerobic digestion process in which various microorganisms decompose the substrate in steps and at the end produce biogas and a residue. Many factors affect the production of gas, for example the substrate content, temperature and pH in the digester.The analysis of methane potential were divided into two experiments. In experiment 1 substrates were digested along with inoculum from Växjö waste water treatment plant in a temperature of about 37 ?C.

Eutrophication of the Baltic Sea is a serious problem. A major contributing factor is diffuse losses of phosphorus (P) from agricultural land in surrounding countries. In order to estimate P losses, environmental monitoring of small agriculture-dominated catchments is being carried out in most of these countries. Evaluation of the risk of P leaching to waters is usually based on chemical tests originally developed to quantify the amount of soil P available for plant production. The tests are performed in different ways in the different countries and a number of different extraction agents are in use.