In this report the importance of irrigation scheduling in dry climate is shown, how it can save water and energy; how this method can improve crop yield by supplying the right amount of water at the right time. It is shown how irrigation scheduling and irri-gation technology together increase the irrigation efficiency..

This examination work on studies and research in articles is mostly from other countries. The purpose of the examination work have been to find out if there are any means you can work with to find out when its time to start irrigation, how they works and if they are credible. In Sweden there is not many means for decide when it?s time to irrigate and how much water you should appear. Swedish farmers think they have so much experience that they don?t need techniques like this.

A literature study and a field trial have been carried out in order to investigate the physiological response of potato plants to different soil moisture levels. Higher yield, quality and number of tubers can according to the literature be obtained if constant high soil moisture is kept during major parts of the growing season. A field trial was set up where drip irrigation was used as an alternative to conventional irrigation techniques to maintain high and constant soil moisture. The application of water in the drip irrigated area was monitored and adjusted on a daily basis so that the soil moisture stayed as close as possible to the recommended level. The sprinkle irrigated area was irrigated according to traditional practices with approximately 35 mm every 7th to 10th day depending on the whether.

Structural rationalizations and regionalization of the agricultural sector in Sweden has lead to unevenness in thedistribution of plant nutrients. Nutrients are lost from crop producing farms as harvest products are sold, whilefarms with animal production often have manure in excess of their needs. In addition to this the retention ofwater and nutrients in naturally occurring wetlands has decreased due to a reduction of wetlands in number andsize in the agricultural landscape. This increases nutrient levels in agricultural run-off and causes eutrophicationas well as nutrient losses from arable soils. One potential solution to both problems would be to store nutrientrichsurface water from agricultural areas and use it for irrigation of agricultural crops.

Structural rationalizations and regionalization of the agricultural sector in Sweden has lead to unevenness in thedistribution of plant nutrients. Nutrients are lost from crop producing farms as harvest products are sold, whilefarms with animal production often have manure in excess of their needs. In addition to this the retention ofwater and nutrients in naturally occurring wetlands has decreased due to a reduction of wetlands in number andsize in the agricultural landscape. This increases nutrient levels in agricultural run-off and causes eutrophicationas well as nutrient losses from arable soils. One potential solution to both problems would be to store nutrientrichsurface water from agricultural areas and use it for irrigation of agricultural crops.

?Mechanical debridment ? A studie in irrigation optimization? is a final thesis which was executed by Fredrick Ekman, in close collaboration with the other group member Mikael Johansson, during the spring 2012. The thesis was carried out through Karlstad University Faculty of Technology and Science in the study program of Innovation and Design Engineering (180 ECTS credits). The client of the project was Medilink AB located in Lindesberg, and the contact person was Nils-Erik Söderström, Chief Executive Officer. The project was supervised by lecturer, Lennart Wihk, and examined by lecturer and professor Fredrik Thuvander at Karlstad University.

To plan and build a garden in Dubai has other conditions and challenges than what you experience in Sweden. The heat, wind and lack of water makes the need for durable plants, a good design and landscaping important if you want to have the opportunity to use your garden during most of the year. The soil is poor of nutrients, alkaline and sometimes saline, witch makes supplying the soil with organic material and various fertilizers necessary if you want to be able to plant a bigger range of plant material in your garden. Another important part is to provide your garden with a good irrigation system that should be put into the ground before planting so that the plants are given a more even irrigation. It?s relatively green scenery you meet and to me it?s in a way surprising since the country with its climate is rather harsh for the purpose of supporting plant life.

Billions of children, women and men lack access to safe water supplies, whichputs the affected in both social as well as economic despair. This paper willpresent some of the conclusions leading Non Governmental Organisations suchas the UN has presented recently concerning the terms of sustainability. Much ofit is true and important, but nothing can be done without extended cooperationbetween nations worldwide to find arguments that prevent short-term thinkingand economic wealth on the behalf of future sustainability.With a growing population and an increased competition for fresh water, theworld will soon face a severe shortage of good quality water for irrigation. This isbecause the distributions rarely match the demand, neither in Australia nor inAfrica. Important to notice is the major factor that the degradation of theenvironment is not one country?s problem to solve.

Hemp has been used for textiles for a long time in history until it became illegal to grow in many countries in the 1930s. It is interesting from an environmental point of view because it doesn?t need any pesticides and in most locations it doesn?t need any irrigation either, compared to cotton, which normally requires big amounts of both pesticides and water for irrigation. Hemp is a bast fiber, which means that the fibers are located on the bast of the stem (on the outer layer of the stem). Therefore they cannot be spun directly, they have to be removed from the stem first.

The focus of this project was to characterize the occurrence of ESBL-­?producing bacteria in two irrigation water ponds in Southern Sweden. Samples were taken from two ponds nearby each other, from which analyses were made based on levels of community and individual isolates. Community samples were used for attempts for characterization of resistance patterns in irrigation water using the Omnilog PM-­?plate system. The growth of community microbiota in the presence of the following antibiotic substances was assessed; amikacin, gentamicin, kanamycin, penicillin G, ampicillin, piperacillin, trimethoprim, potassium tellurite and ciprofloxacin. Isolates were pure cultured using semi-­?selective media: LB, Rainbow Agar, mEnterococcus, 0.1 TSA and VRBD. A total of 177 isolates were isolated randomly. Each isolate was identified using the Omnilog GENIII-­?system of biochemical characterization. Further, the isolates were tested on Brilliance ESBL-­?agar for their ability to grow. Out of the total number of isolates, 30 were selected, preferably Enterobacteriaceae or Pseudomonas spp., based on their high similarity to library strain during the identification in the Omnilog-­?system. These were further characterized using Etest-­?sticks. Three selected strains were picked for further analyses using exogenous isolation for attempts to simulate horizontal gene transfer, and Omnilog PM-­?panels containing various antibiotics of interest. Selections of samples were chosen for molecular tests targeting plasmid-­?borne resistance genes CTX-­?M1, CTX-­?M2 and SHV. The method for assessing community-­?resistance patterns showed ambiguous data that was difficult to interpret; further optimization is recommended. For all tested PM-­?plates, generally greatest differences between substances were found among wells with the strongest concentration of antibiotic substance. A total of 175 isolates displayed ability to grow on ESBL-­?agar. Etests confirmed ability of isolates to resist many ?-­?lactam antibiotics and many were clinically resistant to certain substances. No plasmids were transferred during exogenous isolation. During molecular tests, a few matches were found for the CTX-­?M1 gene. Isolates analyzed with Omnilog PM-­?plates showed resistance to most compounds tested. The isolates showed greatest resistance toward penicillin G, ampicillin, amikacin, kanamycin and trimethoprim. In the study, it was established that resistance among bacteria was frequently occurring in the irrigation water, and ?-­?lactamase producing bacteria was very common. Extended studies are needed to assess the frequency-­? and occurrence of horizontal gene transfer (HGF) in this environment. Although some potential corresponding data is found, it is at this point not possible to determine whether the resistances are due to antibiotics used in veterinary medicine, human medicine or one additional reason is travel and trade. in irrigation water using the Omnilog PM-­?plate system. The growth of community microbiota in the presence of the following antibiotic substances was assessed; amikacin, gentamicin, kanamycin, penicillin G, ampicillin, piperacillin, trimethoprim, potassium tellurite and ciprofloxacin. Isolates were pure cultured using semi-­?selective media: LB, Rainbow Agar, mEnterococcus, 0.1 TSA and VRBD. A total of 177 isolates were isolated randomly. Each isolate was identified using the Omnilog GENIII-­?system of biochemical characterization. Further, the isolates were tested on Brilliance ESBL-­?agar for their ability to grow. Out of the total number of isolates, 30 were selected, preferably Enterobacteriaceae or Pseudomonas spp., based on their high similarity to library strain during the identification in the Omnilog-­?system. These were further characterized using Etest-­?sticks. Three selected strains were picked for further analyses using exogenous isolation for attempts to simulate horizontal gene transfer, and Omnilog PM-­?panels containing various antibiotics of interest. Selections of samples were chosen for molecular tests targeting plasmid-­?borne resistance genes CTX-­?M1, CTX-­?M2 and SHV. The method for assessing community-­?resistance patterns showed ambiguous data that was difficult to interpret; further optimization is recommended. For all tested PM-­?plates, generally greatest differences between substances were found among wells with the strongest concentration of antibiotic substance. A total of 175 isolates displayed ability to grow on ESBL-­?agar. Etests confirmed ability of isolates to resist many ?-­?lactam antibiotics and many were clinically resistant to certain substances. No plasmids were transferred during exogenous isolation. During molecular tests, a few matches were found for the CTX-­?M1 gene. Isolates analyzed with Omnilog PM-­?plates showed resistance to most compounds tested. The isolates showed greatest resistance toward penicillin G, ampicillin, amikacin, kanamycin and trimethoprim. In the study, it was established that resistance among bacteria was frequently occurring in the irrigation water, and ?-­?lactamase producing bacteria was very common. Extended studies are needed to assess the frequency-­? and occurrence of horizontal gene transfer (HGF) in this environment. Although some potential corresponding data is found, it is at this point not possible to determine whether the resistances are due to antibiotics used in veterinary medicine, human medicine or one additional reason is travel and trade..

The trend towards increasingly large farming units raises questions regarding how to better monitor production. Larger units make the impact from possible errors more severe, which increases the pressure on management supervision. To cope with management issues, prevent errors and handle increased demands on traceability and documentation, the Real Time Location Systems (RTLS) concept is making its way into various parts of agriculture. In sectors outside agriculture, RTLS are already being used successfully to track and locate items through nodes at different levels of accuracy, such as room level or the relative or absolute position. Empirical data can be received in real time from the nodes.

This final project is an investigation about the responsibility in rooms where the walls and floors are exposed or partly exposed to irrigation of water, as a bathroom, laundry room and WC. The cost for all water damage is valued for 5 000 000 000 SEK each year. How is this possible with all information about the problem and good materials? Who is responsible? Incites had been made in the subject throw reading reports and participation in courses about how to make a room mention above. Discussions have been made with workers in the trade of making the walls waterproof.The conclusion in the rapport is about who´s responsible for the damages and will pay the cost of the renovation. The responsibility is discussed between the contractor and the insurance company.

Guazuigua is a small village in Bolivia, which has had too small water resources, especially for irrigation. A project started after some studies were made, to create a canal to provide the village with water from a nearby town. To make the canal work it had to cross a dried out river. There have been several attempts to cross these dried out rivers, but with poor results. The purpose of the report is to provide a solution for this problem.

Efterföljs handbokens riktlinjer vid kateterspolning? En observationsstudie om följsamheten kring Handbokens riktlinjer och hygienrutiner vid kateterspolning. Patienter med urinkatetrar är frekvent förekommande inom stora delar av vården och är därför något som vårdpersonalen kommer i kontakt med. Momentet då katetern spolas är förenat med komplikationer och därför har en jämförande kvalitativ studie här genomförts utifrån Handbokens riktlinjer för hälso- och sjukvårdspersonal gällande hygien, material och tillvägagångssätt för att säkerställa en god och säker omvårdnad. Föreliggande studie syftar till att beskriva överensstämmelsen mellan hur kateterspolningar genomförs i praktiken och de riktlinjer som ges i Handboken avseende kateterspolning. Observationerna genomfördes på en vårdavdelning och deltagarna i studien bestod av undersköterskor samt patienter som bar kvarliggande katetrar.

This pilot study examined whether treatment with Vortex Process Technology (VPT) of the irrigation water used on tomato (Solanum lycopersicum) plants had any effect on plant growth. In a block experiment, with two blocks comprising 12 vases containing 1 L water and two tomato plantlets, treatment in which, nutrient solution was based on Vortex-treated water was compared with an control using untreated water. All vases were kept in a static aerated culture system in a daylight chamber for four weeks. The results showed that the effect of the two blocks exceeded the effect of vortex treatment in terms of leaf area and weight of fresh and dry matter. Plant height, stem width and internodal length were significantly different in tomato plants grown in Vortex-processed water compared with the untreated control.