This is a paper about the effects from smoldering fire on lithic objects from an archaeological view. The introduction gives the background to this paper, a short orientation to forest wildfires and why the work is limited to: flint, quartz, quartzite and slate. Material and methods describes the stone materials and the setup that was used in the temperature logged tests with three replications for each type of material. The fuel in the burnings was peat on a bottom of sand. Flint showed a more drastic effect from heat compared with the other materials. Slate seems to have greater tendencies to change to darker colour and luster at lower temperatures than the other materials.

The purpose of this paper is to clarify and understand the difference between Brunius?, Zettervall's and Graebe's valueing of a historical building, the cathedral of Lund. Between 1833 and 1963 the cathedral of Lund went through three larger restorations. The character of the restorations however differs a lot between the three church architects, Brunius, Zettervall and Graebe. In a time of low interest for the Middle Ages and of many demolitions of churches in the countryside, Brunius stood out as a researcher and an enthusiast of that special time.

Not much is today known about how epiphytic lichens are effected by fire. A considerable part of the fires in Sweden today are prescribed fires for the purpose of environmental conservation. How these fires affect lichens is largely unknown. The aim of this study is to find out how epiphytic fruticose and foliose lichens on Scots pine are affected by fire, and to elucidate the relationship between fire intensity and the survival of lichens and later re-colonization. The study was performed at three locations just outside Umeå in Västerbotten that were burned 5-7 years earlier. In all locations there were larger groups of surviving Scots pines with varying amount of fire-damage in the crown, which enabled a reconstruction of fire intensity.

The tomato is an important crop worldwide, and in recent years it has received great attention due to its rich content of carotenoids, which in studies indicate to have health benefiting properties. Many studies have been done in this area of research and in how to optimize the carotenoid content in tomatoes and tomato products. The objectives of this essay were to summarize present data in this field. The results were as follows:There are nine different carotenoids identified in tomatoes. Lycopene and ?-carotene are the ones that have been given the greatest attention.

Cross-suckling, i.e. when an offspring nurses a female other than their own mother, occurs in pig production systems where sows are group housed during lactation. As production systems where several sows and their litters are housed together during lactation are getting more common, the need of knowledge regarding cross-suckling increases. The overall aims with this thesis was to investigate how sow behaviour and productivity are associated with the occurrence of cross-suckling, and to investigate consistency in sow nursing behaviour related to cross-suckling. The study included information about the first 4 parities of 40 LxY sows kept in outdoor and indoor production environments. Sows were single housed the first 2 weeks after farrowing and group housed (4 or 5 sows per group) from 2 weeks after farrowing until weaning, 7 weeks after farrowing.

Global climate change is one of the greatest challenges in our history. As the average temperature is rising due to anthropogenic emissions, impacts such as floods, droughts and hurricanes, affect the lives of millions of people. Though the least developed countries are least responsible for emissions, they are the worst affected. This thesis focuses on environmental justice in the adaptation discourse. By outlining the adaptation discourse from the United Framework Convention on Climate Change principles, to the Marrakesh Accords, via the Kyotoprotocol my ambition is to analyse how environmental justice has been interpreted in relation to the adaptation discourse.

The aim of the study was to investigate if methane emission in a constructed wetland changed in a diurnal pattern correlating to temperature, humidity or light conditions. The gas measurements were carried out with a static chamber technique. The wetland (in Nykvarn outside of Linköping, Sweden) takes care of wastewater to reduce the nitrogen loads. Measurements were carried out at three different occasions in the summer of 1998 on two sites in the wetland. One site was close to the inflow, inhabited by Lemnaceae, and another site was located further downstream inhabited by the emergent macrophyte Typha latifolia.

Not much is today known about how epiphytic lichens are effected by fire. A considerable part of the fires in Sweden today are prescribed fires for the purpose of environmental conservation. How these fires affect lichens is largely unknown. The aim of this study is to find out how epiphytic fruticose and foliose lichens on Scots pine are affected by fire, and to elucidate the relationship between fire intensity and the survival of lichens and later re-colonization. The study was performed at three locations just outside Umeå in Västerbotten that were burned 5-7 years earlier. In all locations there were larger groups of surviving Scots pines with varying amount of fire-damage in the crown, which enabled a reconstruction of fire intensity.

This thesis has the overall objective to develop the optimum sealing system between the retarder and transmission. Today, there is a pressure-relief and two radial seals separation between the retarder and transmission. It has been found that carbon residue formation may occur between retarder axle and seal lips with, in some cases, leakage as a result.We have in this thesis tried to explain the phenomenon of carbon residue, how it is formed and why it can be seen just on the seals? A rig test was conducted where we show how friction, speed, transmission temperature and mitigation phases of the retarder affects temperatures in the sealing environment. Factors affecting the coke structure are reported, together with proposals for measures that provide a mitigating seal environment.

Thermal fatigue is a serious problem in todays power plants. A large amount of damages around the world circles around that subject. The damage can come from the mechanism of two flows mixing with different temperatures in a T-junction. It is a fundamental prerequisite that these T-junctions are frequently tested for damages. An amount of criterias steers the rate of testings.

EW26 is a Bachelor thesis carried out by students, Jessica Blomberg, Sara Danielsson and Mikael Johansson, during the academic year 2010-2011 at the Innovation Engineering Program of Halmstad University. The project was conducted in close cooperation with Ergosafe AB.Ergosafe develops, manufactures and sells electric sliding windows. Due to the company?s current expansion phase they want to increase their product range. The company has identified a need for large windows that moves vertically.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

A sample of milk inoculated with S. aureus was treated with penicillin, and Antipen (a new commercial product containing penicillinase) was added. To another sample with S. aureus and penicillin, formic acid to pH 5 was added, and to yet another sample, a combination of formic acid and Antipen was added. Controls with no penicillin were treated in the same way.

This is a graduate work at the Swedish University of Agricultural Sciences, The Department of Urban and Rural Development, Ultuna. The purpose of this paper has been to find out and describe principles for designing parks that offers good recreational and aesthetical values and require little amount of carbon dioxide emissions during their maintenance. The purpose has also been to see if it's possible to use city wastewater in some extent to assure the plants water supply and to find other means to make it less necessary to use purified water for watering. Recently made studies as well as older ones show how important green areas are in dense city structures both from a health and a climate perspective. Trees and other plants adsorbs different forms of air pollution and can also lower the temperature in the surrounding area through their transpiration.

This study examines the use of building modeling and energy simulations in the design process  of  a  building.  The  take-off  point  is  the  notion  of  energy  simulations  being needed early and throughout the building design process, and that the lack of energy simulations may be explained by the fact that they are time consuming and therefore often too expensive. A greater interoperability between software tools used by relevant disciplines,  such  as  the  architect  and  the  energy  specialist,  would  create  smoother workflows, which would reduce this cost and open up for more frequent and iterative energy  simulation  processes.  The  study  is  an  assessment  of  the  modeling  tool  Revit and  the  simulation  tool  Virtual  Environment  and  whether  they  can  create  smoother workflows, and make leeway for a more frequent use of energy simulations throughout the  design  process.  It  also  investigates  the  limitations  of  what  can  be  examined  by simulations in Virtual Environment. This will hopefully help clarify the future role of energy  simulations  in  design  processes.  The  method  is  a  trial  by  error  approach  of testing the two software tools by building and simulating a model. The results of these tests  show  that  the  workflow  is  not  optimal  (and  therefore  time  consuming)  for frequent  and  iterative simulations  throughout the  design  process,  but  it  also  reveals some  great  possibilities  of  what  can  be  performed  with  these  two  powerful  tools  at hand.  Further  development  with  regards  on  platform  independency  of  the  building information  model,  including  seamless  exporting  and  importing,  seems  necessary  to strengthen the future role of energy simulations..