The goal of this project was to implement and compare Invere Discrete Cosine Transform using three methods i.e. by bit parallel, digit serial and bit serial. This application describes a one dimensional Discrete Cosine Transform by bit prallel method and has been implemented by 0.35 ìm technology. When implementing a design, there are several considerations like word length etc. were taken into account.

In this report a system for Rapid Control Prototyping, RCP, is evaluated through animplementation of the motor control methods Field Oriented Control, FOC, and Space VectorPulse Width Modulation, SVPWM. The evaluation emphasizes on time-consumption andresource utilization on the used hardware and on usability for of software.A new mechatronic laboratory is under development at ABB Corporate Research in Västerås. Itwill be used for both mechanical and motion control design using existing and new hardware.The control structure in a traditional robot system will be interfaced to a rapid prototypingsystem which should allow easy changes to algorithms at different levels in the system.The system designated for this project comes from National Instruments and constitutesLabVIEW Real-time and FPGA module as the software tools. The hardware is a NI Single-Board RIO (Reconfigurable Input Output), sbRIO, development board including a Field-Programmable Gate Array, FPGA, from Xilinx and a microprocessor from FreescaleSemiconductor. Graphical programming is performed in the LabVIEW environment, andthrough Xilinx tools the LabVIEW FPGA code is compiled to VHDL code.A pre-study was carried out to clarify the concept of RCP and investigate different systems forRCP and their traits.

Corporate governance intensified due to the corporate scandals in the USA which led to a new law the so called Sarbanes-Oxley Act (SOX).In 2005 the "Svensk kod för bolagsstyrning" (The Code) was introduced. The main purpose of The Code is to strengthen the confidence in Swedish companies quoted on the Stockholm Stock Exchange. The Code focuses on the working process of boards. The rules set by The Code places higher demands on the board.  Among many other duties the board has to establish long term operational goals and strategy.

With the globalization, companies in the West chose to shift production to developing countries to cut down costs. This had a major impact when child labor and very poor working conditions in these factories were discovered and led many companies to take responsibility for their suppliers and the employees by adopting voluntary so-called Codes of Conduct.There is a subtle balance to enforce improvement of working conditions for employees at suppliers´ factories and to keep costs down. On the one hand, companies would like to conduct extensive audits at their suppliers to ensure code of conduct compliance and thus protect their legitimacy. On the other hand, audits are expensive so companies would like to minimize audits to keep costs down. Companies thus have to strike a delicate balance in relation to how many and what suppliers they choose to audit.

In this bachelor thesis we have used a case study to examine the potential opportunities and obstacles an organization may have to internally implement a code of conduct with regard to the environmental guidelines. To succeed with the implementation of codes of conduct, companies need to ensure that what is provided to be implemented do this according to scheduled time targets, but also that is to be implemented in the organization actually is what is intended to be implemented, and that those that are involved in the implementation will be satisfied with result, this is because it is the employees who will follow the guidelines contained in the Code. Heide & Grönhaug (2002) argues that lack of communication is the main reason why the implementation in the business strategies fails. In this case study we have used primary data from interviews in the case company as well as secondary data from earlier research and information from the case company itself to develop our conclusions. The case study shows that the existing environmental awareness in an organization often is founded in common sense about how to act.

There are several ways of conducting software testing where some may include users and others may include personnel whose work task is to execute test on systems. Although most developers and project managers understand the point of testing the system, it is not always being done and the most common reason is that there is no time for it. However, this is a false assumption as it may instead cause some bugs in the system that would not have been there in the first place if tests had been there to prevent bugs in the code.My purpose for this thesis was to find suggestions for changes in the development process in an ongoing project used by Acino and Svenska Försäkringsfabriken in order to increase the quality of the system used. In this thesis, I have approached the purpose by pursuing a case study of the two companies through observation and interviews. By doing this I acquired the relevant information to make suggestions for change.

Corporate governance intensified due to the corporate scandals in the USA which led to a new law the so called Sarbanes-Oxley Act (SOX).In 2005 the "Svensk kod för bolagsstyrning" (The Code) was introduced. The main purpose of The Code is to strengthen the confidence in Swedish companies quoted on the Stockholm Stock Exchange. The Code focuses on the working process of boards. The rules set by The Code places higher demands on the board.  Among many other duties the board has to establish long term operational goals and strategy.

Recent accounting scandals, often led by managers trying to improve results and thereby their own bonuses, have severely damaged the publics view of management. In the aftermath of scandals such as Enron, Parmalat and Skandia, demand has increased for Corporate Governance codes and similar regulation. The Swedish code for Corporate Governance came into effect on July 1, 2005. The code requires all Swedish companies listed on the Swedish Stock Exchange (OMX A- and O-list), with a turnover exceeding 3 billion SEK, to disclose a report regarding Corporate Governance, attached to the annual report.The purpose of this paper is to examine whether the new disclosure required by the Swedish Corporate Governance code will have a measurable effect on stock prices. The authors have applied event study methodology examining daily returns around the announcement of the Corporate Governance reports.

With the introduction of the Swedish Code for Corporate Governance in December 2004, most companies listed on the major Swedish stock exchanges were required to have a nomination committee responsible for, among other things, evaluating the incumbent board and nominating new candidates. This master thesis aims at analyzing the effects of these nomination committees on institutional investors in their corporate governance, through a qualitative study of 13 interviews. We have found that institutional investors have become more active through their participation in nomination committees and that they have gained more influence over the companies in which they own shares. We believe that in reality nomination committees have more influence over the selection of the board than was intended when the Swedish Code was written..

At Forsmarks Kraftgrupp AB (FKA) forces on pipe systems due to transient flow are frequently calculated as a step to verify their structural integrity. In nuclear industries these forces are often calculated with a one dimensional thermal-hydraulic analysis-code called RELAP5. When calculations regarding more complex geometries are needed, the three dimensional code Fluent is often used. This code is highly time consuming and requires large computational power.This projects aim is to compare calculations of pressure, flow and forces carried out by RELAP5 and Fluent for an arbitrary pipe section during transient flow conditions. This has been accomplished by constructing a simple geometry for which a transient flow is simulated in both programs.

Denna uppsats bygger på fyra grundstenar; Svensk kod för bolagsstyrning, Combined Code on Corporate Governance, riktlinjer från OECD, EU:s rekommendationer. För att skapa förståelse för dessa olika regelverk samt möjliggöra en analys, har teorin om Agent och Principal, samt den om Corporate Governance använts. Förutom studier av regelverk har diverse intervjuer genomförts med svenska och engelska börsnoterade företag som lyder under bolagskoderna, samt även intervjuer med revisionsföretag. Dessa har fungerat som informationskällor, referensramar, och underlag för analys och slutsatser. Det ges även sammanfattningar av Svensk kod för bolagsstyrning, samt för Combined Code on Corporate Governance, en redogörelse för riktlinjerna publicerade av OECD och EU:s rekommendationer.

Property sales involve two main contract partners, the buyer (the new owner) and the seller (the property owner). In some cases the property owner can have let a third person (the leaseholder) lease the property or the land.The rights and obligations that fall on the property owner, the leaseholder and the new owner according to the Code of land laws can appear difficult and unclear, especially con-cerning reservation, the new owner?s duty to inspect the property and when he does not act in good faith, the formal requirement and when terms are changed.The work towards a more uniform interpretation of the Code of land laws should result in a greater correspondence between the rules of leasehold and property sales, the rules of leasehold should be interpreted in accordance with the rules of property sales. This should mean an increased responsibility for the property owner to reserve the lease and a de-creased duty for the new owner to inspect the property. If the lease is only partially re-served, the new owner is only bound by the leasehold to the parts which he understood from the reservation and the duty to inspect the property is limited to documents in the property owner?s possession.

Denna uppsats behandlar borgenärsskyddet vid värdeöverföringar. Det primära målet för begränsningar vid värdeöverföringar är att skydda borgenärer. Borgenärsskyddet i svensk rätt återfinns i 17 kap. 3 § aktiebolagslagen i form av beloppsspärren, som benämns som principen om skyddet för det bundna kapitalet, och försiktighetsregeln. De lege lata ger inte lagregeln något nämnvärt skydd för bolagets borgenärer.

The Swedish industrial society has left several areas with contaminated soil and water which today is of danger for the environment and human health. One of these areas with contaminated soil and water is the region where the former Glava glassworks operated during 1859 to 1939. The main object in this study has been to study the responsibility for the contaminations according to the Environmental Code. The method used is a qualitative content analysis of relevant literature to answer the following questions:What types of contaminations can be found in the area of Glava glasswork and what health issues can these cause?What kind of activity has been conducted in the area that have caused the contaminations in soil and water?According to law, what are the responsibilities for the contaminations in soil and water at Glava glassworks?The contamination in the region has been confirmed to originate from the glasswork due to the environmental engineering survey made in the area in 2009.

Grid codes are becoming more demanding on power generating units due to the factthat the complexity of the power grid is increasing. The penetration of wind powerhas grown over the last years and it is clear that wind farms need to be addressedwith the same type of grid codes as conventional generation units. There is howeveran undeniable difference between the technology in conventional synchronousgeneration units, and the asynchronous generation units in wind farms.This thesis has reviewed the current grid code in Sweden and compared it to the newcode proposed by ENTSO-E, ?the Requirements for Generators?, in the aspect ofwind farms with an installed power of 30 MW or more. The comparison has beencomplemented by an analysis of how wind farms of two different technologies(Doubly fed induction generators and full power converters) can meet therequirements and technical proposals have been given on how to be able to meetcompliance with the new grid codes.The Requirements for Generators contains many non-exhaustive and optionalrequirements, because of this it has been difficult to, at this stage, exactly point outthe technical impact on the grid connection of future wind farms in Sweden.