The thesis work has been carried out at Volvo Aero Corporation (VAC) in Trollhättan. VAC has entered a partnership as developing and producing partner with engine manufacturer Pratt & Whitney and is currently at the starting phase of producing the turbine rear frame (TEC) to the engine PW1000.The purpose of this study was to create a report on process level that describes the conditions and the potential with PW1000 TEC to reach the product cost calculation taking into account lead times and describe alternative method solutions.The report describes a comparison between the present flow (2012), a flow based on product cost calculation (2016) and a potential flow (2016). The work has mainly been based on acquiring the knowledge and information available to inspect the present flow; this has been done by workshop observations, meetings and gathering of the information that is available on the work site for the PW1000 TEC.The information obtained has been merged into an Excel document, called Roadmap. It serves as a roadmap with current situation as the start and the potential flow for 2016 as the goal. With the roadmap as a tool, assumptions have been taken considering the flow and how it will change, where processes have been eliminated, reduced or marked as a problem..

The EU has decided that it should be possible for consumers to get information about the origin of the electricity they buy. Therefore, there is a need to examine different systems for electricity disclosure. In this thesis two ways of disclosure have been studied:? Certificate system. A certificate system involves two parallel markets, one for trading electrical energy and one for trading certificates of origin.? Separated Markets.

The purpose of this study was to evaluate the different substrates that enter the digestion on Sundet wastewater treatment plant for production of biogas.This work have done an analysis of data about the biogasproduction from January 2012 to feburari 2013, this showed that the food substrates has a greater gas production than internal sludge.Through laboratory test the VS, TS and COD values for all the substrates used in the biogas production could be determinded. But the COD-method was less optimal for analysis of fat and food, therefore it optimized the method for fat but due to time constraints, this could not be done on the food substrates..

Eutrophication of the Baltic Sea is a serious problem. A major contributing factor is diffuse losses of phosphorus (P) from agricultural land in surrounding countries. In order to estimate P losses, environmental monitoring of small agriculture-dominated catchments is being carried out in most of these countries. Evaluation of the risk of P leaching to waters is usually based on chemical tests originally developed to quantify the amount of soil P available for plant production. The tests are performed in different ways in the different countries and a number of different extraction agents are in use.

This thesis has been carried out in New Zealand in collaboration with the University of Waikato. In association with Dr. Mike Duke the purpose of this work is to investigate whether two different software for modeling of photovoltaic systems are useful in the teaching of solar energy.The next ten years grid-connected photovoltaic systems are assumed to increase and therefore also a rising demand for people with engineering knowledge are to be predicted. For engineer students with a focus on solar energy a more practical teaching with design software´s can be a good method to make the students comprehend more when it comes to large scale photovoltaic systems and be more prepared for working life.The software´s used is called Transient System Simulation (TRNSYS) and Photovoltaic Systems (PVSYST) which are both well used throughout the world. To assess the reliability of the software´s, a reference solar power plant at 16.1 kWp installed capacity are used, which consists of photovoltaic modules from four different manufacturers.

This report contains CFD-simulations of cable tray fires in nuclear power plant applications with the CFD-code SMAFS. Furthermore the report evaluates the use of CFD-codes within this kind of problems. The assessment of this report is that there is a tendency towards the good use of CFD-codes but before using it solely more research has to be done on the subject..

This report summarize a simple and efficient way to convert 2D into 3D designs. It explains the benefits of a 3D design compared with 2D, and how those benefits may be used.It will also give the reader a presentation of the company Clean Air Technologies, which for the most part constructs cleaning facilities for power plants. How to create 3D-libraries for some of those facilities will be introduced in this composition.The collaboration with Clean Air Technologies has resulted in several 3D animated movies and rendered images. This has increased the quality of the companies offer presentations, which has made it easier for the prospective customer to get an improved overall image of the power plant design..

Svenska Kraftnät is (together with the other transmission system operators of the Nordic power system) responsible for keeping balance between the generated and demanded power in the Nordic power system. Spontaneous load variations and system disturbances, however, lead to power imbalance followed by frequency variations. The frequency deviations can be limited to an acceptable level by the spinning reserve, mainly by hydro power control. But there are also other system properties which have a great influence on the frequency and system stability. The frequency and voltage dependence of the loads have a direct influence on the power balance.

Control of a diesel engine equipped with Variable Geometry Turbine (VGT) and Exhaust Gas Recirculation (EGR) requires a multivariable control method. One problem is that the engine system is non-linear. Furthermore there are strong cross-connections between inputs and outputs and the inputs have alsoboundaries. To be able to manage these control problems, MPC has been used that is a multivariable method. The MPC-controller consists of an optimization problem and therefore MPC can find the optimum control signals in an easy way.

To the sewer systems households, industries and other activities are connected. The wastewater is collected at treatment plants where a nutritious sludge is produced. The sludge does not only contain nutrients, but also hazardous substances originating from different activities in society. To reduce the flow of hazardous substances to treatment plants and to create a sustainable recycling of plant nutrients the Swedish Water & Wastewater Association has developed the certificate system REVAQ. This certificate requires a good quality of the sludge but also that the treatment plants maps the origin of the unwanted substances.

This literature review describes organic pig production in Sweden, its advantages and disadvantages, but also how its problems can be reduced or solved. Organic pigs have the possibility to a more natural behaviour than conventional pigs. With outdoor pigs comes problems, especially during wintertime, concerning water and feed supply, thermal environment and supervision. Parasites and leakage of plant nutrients are other difficulties that comes with outdoor pigs. All problems and difficulties can be reduced or put right through correct management.

The effects from a planned wind farm on the grid utility Gävle Energis electrical grid have been studied. The wind farm is planned to be built in the forest 15 km north of Gävle and will have 23 turbines with rated power from 2 to 2.5 MW, resulting in a total installed power between 46 MW and 57.5 MW. The grid connection will be made at 70 kV. The aim of the analysis was to determine what effects the wind farm would have on the power grid in the form of electrical disturbances (flicker etc.), need for new investment and raised operational cost. To allow the connection of the wind farm technical solutions (new lines, power stations and grid reinforcements) have been constructed.

The running of gas turbines with low emissions causes high pressure pulsations to arise in the combustion chamber. These pulsations are high amplitude sound vibrations. At some frequencies these are harmful to the gas turbine. Hence these pulsations are monitored to avoid operating conditions where pulsations are specifically harmful. It is necessary to expose the system of known pulsations to verify the functionality of the monitoring process.

Oilseed rape is an important crop in Sweden and is grown on about 90000 ha today. The interest in oil seed pro-duction is increasing because of growing demand and high prices for oil seed both in Sweden and Europe. However, an increased intensity in the oil seed production can bring higher risk of yield losses due to fungal diseases. The purpose of this study was to investigate what different fungi are associated with oilseed rape under field conditions and if their incidence is correlated to crop establishment problems. This study was carried out in three parts: 1) investigations on fungal community structure in roots and rhizosphere soils from young spring- and winter rape plants sampled in failed respectively good establishment patches in four fields, 2) investigations on the pathogenicity of fungi isolated from oilseed rape in controlled environment and 3) investigations on the effect of different fungicide seed treatments on germination and early plant development in a field soil naturally infested with damping off- and Verticillium wilt pathogens. The studies on community structure using a combined approach of standard fungal isolation techniques and DNA based methods revealed a high fungal diversity in three out of four studied fields of spring rape and winter rape. For some unknown reason, very few fungal species were identified from the fourth field.

Sewage sludge contains plant nutrients and has earlier been utilised as fertilizer to cropland. Unfortunately not only plant nutrients but also heavy metals, pathogens and organic contaminants tend to accumulate in sludge. The suitability to use sewage sludge in agriculture has therefore been subject to several discussions over the years. The Swedish food industry does no longer accept sludge as fertiliser for Swedish producers. In 1999 the Swedish parliament accepted several objectives for environmental protection. In order to prevent environmental pollution and further exploitation of the earth crust, one of these objectives confirm that phosphorous from sewage shall be recirculated to arable land.