The release of green house gases and the environmental impacts humans have on the environment are huge and might cause irreversible changes to our earth. Meat is considered to have large impacts on the environment, especially beef meat and therefore there have lately been considerable discussions on the sustainable level of meat consumption and production. The main goal with this thesis is to study sustainable meat production and meat consumption in the county of Dalarna in Sweden. Indicators for sustainable meat production and meat consumption were developed and applied on three cases. Interviews were carried out with a municipality in the region that represents the consumer and three beef farmers that represents the producers.

The sun is an endless energy source and the heat it produces can be used to heatup our homes. This technology is relatively old and was introduced in the late70-s. There are two kinds of solar collectors that are most frequently used todayand these are plain solar collectors and vacuum solar collectors. The plain solarcollectors are the once that are used the most but the vacuum solar collectorshave increased more as a percentage the last couple of years.The biggest question asked regarding an investment in solar heating is if theplant is economically profitable. This question has no direct answer because itis dependent on a couple of prerequisites.

This Master?s Thesis aims to investigate and assess the methods used to decrease the discharge ofmetals, primarily copper, from the water purification plant at Assa Industries plating factory inEskilstuna.Literature studies of the purification methods precipitation, ion exchange, evaporation, reverseosmosis and electrolysis has been done to appraise the adequacy of the technique. Thesetechniques are commonly used for purification of industrial waste water.Assa has four plating lines: the Trumline, the big Zinkline, the new Zinkline and the Decorativeline. The new Zinkline is the most modern of the four lines and purification is done byrecirculation over an ion exchange unit. The demand for fresh water is thereby heavily reduced.The Trumline, the big Zinkline and the Decorative line all use older techniques.

We are heading towards a huge switch of how energy is produced with fossil fuels being replaced by renewable energy sources. It is not difficult to replace the energy you use in the house and there is no need for futuristic technology. There are already many established products on the market such as high efficiency vacuum solar collectors, heat pumps & small wind power stations that can supply the energy being used in a house. The company Sol & Energiteknik SE AB in Huskvarna has many different products which can reduce the need for an outside energy distributor. An average house in Sweden uses 15 000 kWh for heating, 5000 kWh for tap water and 5000 kWh for electricity.

Better, more efficient fertilizers with great productivity and economic returns are needed, but it is important today to find fertilizers that are also sustainable. It is also important to carefully monitor their impact on the environment, including potential side-effects. In this context, the microbial communities that carry out numerous essential functions contributing to a functional ecosystem are of particular interest. The present study is a complement to a pot experiment that investigated the potential of different waste products for use as fertilizers and how they affect the microbial community. In the pot experiment, the clearest treatment change in microorganism community function was found in the fully fertilized treatment used as a positive control. The question was whether this was indirect, i.e.

Vid tillverkningsprocesser av nya komponenter omvandlas material till antingen en produkt eller restprodukt, varpå restprodukterna hanteras som antingen biprodukt eller avfall. Oavsett karaktärisering är den genererade beståndsdelen föremål för någon form av fortsatt behandling. Vid frågan om restprodukt kan det handla om en åtgärd för avfallshantering, då substanserna saknar funktionella egenskaper för fortsatt användning. Det kan också vara så att avfallet besitter ett kommersiellt värde och kan återanvändas som en råvara i andra anläggnings- och tillverkningsprocesser eller i form av bränsle. Oavsett tillämpad åtgärd krävs tydlig lagstiftning som främjar en gynnsam utveckling och förhindrar uppkomsten av skadliga föroreningar.

Städerna växer och samtidigt ökar efterfrågan på närodlade och ekologiska grödor. För att klara av att producera närodlat och mer hållbart skulle ett alternativ vara att odla i så kallade vertikala växthus. I Kiruna finns Sveriges största malmgruva som drivs av företaget LKAB vars olika processer leder till spillvärme. I Kiruna är klimatet kallt jämfört med större delen av Sverige och därför erfordras uppvärmning om odling ska kunna ske året runt i ett växthus. Examensarbetets uppgift är därför att undersöka hur man kan utnyttja spillvärme till ett vertikalt växthus i samband med en ny kontorsbyggnad på LKABs gruvområde.

Due to the globalization today the competition in the market has in- creased and it requires flexibility and produce according to customer demand. In order to reduce the cost of wages industrial companies are now considering moving the manufacturing to low-cost countries. To keep up with the competition in the market without moving the manu- facturing abroad, Lean Automation was developed. The concept of Lean Automation is to reduce the perceived complexity with automa- tion and make automation available for new users and in new applica- tions.Haldex Brake Products are situated in Sweden and want to maintain the manufacturing of the automatic brake adjusters in the country. It is a product well-known and highly exposed to the competition in the mar- ket.

Fast pyrolysis is a method for converting biomass into three energy rich products: char, gas and bio-oil, where the latter is most interesting.  Pyrolysis is an endothermic process where biomass is heated in an anaerobic environment and, with the right operating conditions, up to 80 %wt bio-oil can be extracted. Key parameters for fast pyrolysis are: stable reactor temperature (~500°C), short residue time for gas in the reactor (<2 s) and a very high heating rate for the biomass. Today there are several different process solutions for fast pyrolysis, where fluidized beds and rotating cones are most developed. Bio-oil has compared to fossil oil: lower heating value, low pH and also polymerizes with time. Because of this upgrading is desirable for increasing competitiveness.

Vid tillverkningsprocesser av nya komponenter omvandlas material till antingen en produkt eller restprodukt, varpå restprodukterna hanteras som antingen biprodukt eller avfall. Oavsett karaktärisering är den genererade beståndsdelen föremål för någon form av fortsatt behandling. Vid frågan om restprodukt kan det handla om en åtgärd för avfallshantering, då substanserna saknar funktionella egenskaper för fortsatt användning. Det kan också vara så att avfallet besitter ett kommersiellt värde och kan återanvändas som en råvara i andra anläggnings- och tillverkningsprocesser eller i form av bränsle. Oavsett tillämpad åtgärd krävs tydlig lagstiftning som främjar en gynnsam utveckling och förhindrar uppkomsten av skadliga föroreningar.

Environmental problems are accelerating with energy consumption and the release of greenhouse gases as the major issues. This affects landscape planning mostly through environmentally hazardous transportation and heating of buildings. In environmental work, the term "Sustainable development" is often used. This term was coined in the Bruntland report in 1987. A number of frameworks have been developed to clarify the term and to remind the user about relevant aspects of sustainability.

BackgroundThis paper is based on an issue raised by the organization Energigas Sverige, which together with the Ministry of Finance has posed the question about the fiscal impact of an increase in biogas production. Since the fiscal effects of an increased biogas production are both positive and negative, due to reduced use of fossil fuels, we want to investigate this further.PurposeThe purpose is to describe and explain the obtained fiscal impacts of an increased biogas production and based on our problem: ?What are the obtained fiscal effects caused by an increase in biogas production?? we could see the following fiscal effects: positive impact on employment, increased revenues of social security contributions and income taxes, reduced unemployment costs and reduced tax revenues on fossil fuels. These effects are summarized in a negative tax revenue of 2,6 billion SEK. Along the summarized negative effect we also accepted one of the two prepared hypotheses, which stated that an increase in biogas production leads to a negative fiscal impact. Design/Methodology/ApproachWe have chosen to work from an Anglo-Saxon scientific tradition and furthermore, we have a positivistic approach when we want to explain the relationship between cause and effect of an increase in biogas production and the following fiscal impacts.

The development within the textile industry is always ongoing with development of new andbetter textiles, which often mean the use of non-natural materials like polyester. This doesn?t lineup with the work shared around the world against an improved environment, so the idea came touse a form of linen fibers instead of polyester as the reinforcing material together with cotton.The idea was to use flax, linen of low quality, which is seen as a waste product and garbage inthe production of high quality linen and flax seed oil. This flax of low quality needs to beseparated before it can be used in cotton spinning machines. Fireball 2 is just that, a process toseparate flax fibers through the treatment of a technique called electrohydraulic discharge.The thesis works goal is to evaluate the Fireball 2 process ability to separate flax fiber.

This paper deals with a taphonomic study of contexts with osteological material of dog (C. familiaris L.) from the Mesolithic and Neolithic of Sweden and Zealand, Denmark. The general aim is to develop and test a method to try to understand the activity behind and define specific archaeological structures. My questions also regards to wether a taphonomic analysis of the material could be used to identify treatments as wrapping and contraction of the dogs, but also dismembering and other preparations of the body. The study focuses on the relation between the space of decomposition, disarti-culation of the joints, evidence of wall effect, cutmarks, weathering and signs of postdepositional arrangements.The analysis is based on contexts from the materials Hornborgasjön, Vedbæk, Skateholm I and II, Sjöholmen, Ertebølle, Bökeberg, Bredasten, Löddesborg, Bergsvägen and Röekillorna, dating from early Maglemose culture to Neolithic Battle axe culture.The analysis shows that a closer study of taphonomic processes can be used to identify different structures as graves, offerings, religious and non religious contexts or parts of animals, probably put into the ground as waste.

Most swedish newspapers have a homepage where their news are presented. Existing guidelines describing how to write for the web often recommends you to keep it short and stay objective. But how about longer pieces of content presented in the print version? What will become of reports, interviews and essays as we?ve come to know them as the printed newspaper goes digital?Interviews with representatives of five swedish newspapers shows that the extent to wich content is being published on the web is connected to the overall purpose of the web presence. The fact that many newspapers does not publish longer pieces of text on the web rather seems to be an economic issue, than a matter of good readability.Past studies shows that longer pieces of text may well work on the web, if the reader?s interest is big enough.