A study was conducted to investigate the new and frequently discussed concept curling parents. There were no previous studies of curling parenting, and therefore traditional classifications of parenting (Baumrind, 1967, 1980; Maccoby & Martin, 1983) have been used for comparison. Parents (N=140) born between 1959 and 1981 participated. They completed questionnaires to establish their level of curling behaviour. The high Cronbach's alfa confirmed coherence in the curlingcriteria, which implied that curling parents exists as a group.The results confirmed our hypothesis that participants exhibiting high levels of curling behaviour were permissive in their parenting style, had a bad conscience concerning their parenting and wished for more time with their children.

In the last decades, high speed cutting has become an attractive technology in the wood industry. The possibility of reducing global costs in addiction with an increase in productivity, were the main reasons for the enlargement of the use of this technology. As usual, these advantages are accompanied by disadvantages that should be carefully analyzed. If on the one hand cutting forces are reduced with increasing cutting speeds, on the other hand, the centrifugal forces affecting the tool are higher. Exposed to such high loads, there is a considerable risk of tool failure that embeds hazards for both machine and workers.

The dependency of continuous electricity supply is high in the Swedish society today, at the same time no one is willing to pay for a too costly or over dimensioned power distribution system. The owners of the distribution systems are the ones responsible for this balance act of maintaining a high quality of electricity delivery to customers at a reasonable cost.In this master thesis a limited part of the primary distribution system (10 kV), owned by Mälarenergi Elnät AB and located in the city centre of Västerås, was chosen for a deeper analysis of its reliability. Its ability to handle outages of system components (N-1 and N-2 contingency analysis) was investigated to find out potential weak spots and parts of the grid that showed signs of being overdimensioned.The results of the performed simulations showed that in 74 % of the studied N-1 contingencies cases, consisting of outages of a bus bar in a distribution substation, the system could handle this without causing outages in other parts of the grid. For the N-2 contingencies 61 % passed the test. It was also found that one of the two included high voltage substations could alone supply the investigated part of the grid.

Gunsta is situated about 10 km east of Uppsala. Today there are plans to establish 1000 new households in Gunsta before year 2030. The required energy for heating houses and water would be distributed via a district heating system, which also includes 200 existing residences. The annual required energy, according to this study, would be 16.2 GWh with a maximal peak effect of 6.9 MW. To meet this need, the study suggests a system with heat pumps to upgrade the 31?C water from a 1.8 kilometre deep borehole.

Due to fast growing and rapid changes in markets today, most of the organizationsthat are trying keep up with these changes have a high demand for software that areof high quality and comes with a low price. To meet these goals software companieshave to implement new methods to develop software that are suited for rapidchanges. The concept of agile methods can fulfill this need. Our purpose with thisthesis was to investigate how well agile methods could be applied in organizationsthat could be identified as adhocracies. A case study was conducted in anorganization which we could identify as an adhocracy.

Uvån Hagfors Teknologi AB (UHT) has developed a process ? GRANSHOT® ? for quicksolidification of metals in water baths. In the process liquid metal is splintered ? granulated ?into small drops. The drops are rapidly cooled in a water bath where all the heat energy from theliquid metal is transferred into the water.

The public sector is a major purchaser of goods and services. By setting requirements for environmental and social considerations in public procurement, an authority has the possibility to use consumer power to influence the actors in a market. The purpose of this paper is to investigate public procurement of textile products in a municipality, in order to gain knowledge about factors that may be important for the use of environmental and social criteria. Håkan Hydén´s (professor in sociology of law) norm model was used as the basis of the analysis, where the conduct was investigated along three dimensions of the norm ? willingness, knowledge and system conditions ? in order to identify underlying factors that can influence the process.The results ? analyzed by using interviews and documents ? show that the procurer's willingness, motivation and knowledge are important factors in this context, as well as the political priority of the municipality.

In the current study, the aim was to investigate whether tail posture and motion can be an indicator of the emotional state of pigs and if the tail posture of the pig is affected by social breeding value (SBV), coping style and/or housing. Emotional state can be defined in two dimensions: valence and arousal. Two batches of 96 finishing pigs were studied in a one generation selection experiment with a 2x2 set up and were housed in a barren or straw bedded pen. In each pen, 6 pigs (3 male, 3 female) were housed. A back-test was done to determine the coping style of the pigs with two categories; high resister and low resister pigs.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

This master thesis was conducted in order to investigate the effects of the browsing species Yeheb on animal tissues in Swedish landrace goats and to make a literature review in order to increase the knowledge of the importance of this plant for livestock production in Somalia. The evergreen Yeheb bush is a very important feeding source for grazing and browsing animals in Somalia during the dry period. Yeheb contains cordeauxiaquinone that stains the bones of the animals red/pink, which has been an increasing problem when exporting meat to foreign countries. In an experiment, two goats were fed dry and fresh leaves from the Yeheb bush for one and two months, respectively. The goats did not feed the intended amount of dry leaves, since the supply and palatability was not as high as estimated.

The aim of this study is to highlight the computer as a learning resource in the education and give us knowledge about how the students uses the computer in year one in a selected High School where one computer per student were introduced in autumn 2011. The aim is also to contribute to the discussion about how the computer can become a natural learning resource for all students in all subjects, including the students in need of special support.How are the High School students using the computer?Are there differences in computer use, whether the student is in academic or vocational program?Are there differences in computer use between boys and girls?Do the student experience that the digital competence is increasing together with if they experience the computer as aid?In what degree do the teachers encourage the students to use the computer?How much do the students use the computer to learn mathematic?The study is based on a survey of all students in year one in a municipal High School.The result of the study is showing that the students first of all use the computer to play music, surf the Internet and to be logged in on social media (eg. Facebook). The students have learned to use the computer for the tasks they need, although the teachers don?t encourage the students to use the computer in any higher means, not in mathematics and not in other subjects.

The use of Power Line Communication, PLC, as a communication solution for Automated Meter Reading, AMR, is popular by utilities in Sweden and other parts of the world due to demands of accurate and fast meter reading. However the use of the electrical grid as a communication medium is complex and sometimes problematic. This report handles some of the issues and problems that are important to understand when using the grid as a communications medium. Focus is mainly on investigating high frequency distortion in the Kristianstad power grid own by C4energi caused by a frequency converter. Measurements on site are done to investigate signal damping in the grid, different configurations for the frequency converter and signal strength of the PLC-system.

Inspection errors are nowadays usually written with pen and paper during building inspections. A company in Stockholm is developing a method by which inspections are made digitally from the beginning and where the inspection attachments shall be stored in a database. The idea of this method is that entrepreneurs can use the database to get an experience feedback from previous surveys so that they can improve their production processes. One problem that occurs is how inspection errors will be sorted into the database. They have to be sorted so that contractors or clients can use and sort out the information in a sensible way when they want to evaluate and make improvements in their production processes.This thesis examines how the inspection errors can be sorted in a structured manner.

AbstractThe importance of good construction planning affects the final costs of the production and the timing of the project. Planning for building projects has been studied with the aim of identifying how three week planning appears in the construction industry today.A case study has been conducted in Navisworks Simulate to assess whether the software is suitable to connect the task schedule with the BIM model to create a 4D model. 4D models are used for performing 4D construction simulation to visualize the project. In order to use the benefits of the model, investment in equipment and software is required. This means higher costs for the companies.

The art of producing films have been around for more than a century and the technology just continues to evolve. But although much has happened in 100 years, there are also processes, theories and practices that look the same now as then. I write this thesis because I want to find the differences between the analogue and the digital way of production. This study is based on a qualitative approach because my ambition is to seek the views concerning film production processes. The advantages of analogue film is that it contains more information than the digital formats and that it has a more cinematic style.