Rift Valley Fever (RVF) is a disease caused by Rift Valley Fever virus (RVFV), which is an arbovirus. An arbovirus is a virus that is transmitted by an arthropod vector, in this case a mosquito. The virus is a member of the Phlebovirus genus in the family Bunyaviridae. It was first identified in the Rift Valley in Kenya in 1930. The disease is a zoonosis but mainly affects domestic ruminants inducing massive abortions and a high mortality among young animals.

In several countries that have been early in the development of wind farms, there is today a second hand market for the used wind turbines. The European Union (EU) has established a waste hierarchy in order to minimize throwaway mentality. The second hand market is a part of this as the steps are to minimize, reuse, recycle, extract energy and landfill.In order to promote the development of renewable energy, there are energy certificates for the producers that provide it, wind power being one type of renewable energy. After 15 years the energy certificates for a specific wind turbine are no longer paid, and after that there are several different scenarios for the wind turbine. The scenarios investigated in this bachelor?s thesis are export of the wind turbine to countries that are not as far along as Sweden in their development towards renewable energy, selling in Sweden to individuals, and recycling of the wind turbine, as it mostly consists of metals and therefore is recyclable.

The work covered in this report includes a literature study of the diesel dual fuel technology(hereinafter referred to as DDF). The literature study covers earlier work that has been doneregarding the use of compressed natural gas (CNG) and diesel in a DDF system. Moreover a onecylinder research diesel engine was fitted with a CNG fuel system for experimental testing. Theinstallation of the engine and the test cell is described. Results from the tests are presentedcovering emissions, heat release and pressure traces from the DDF-concept.During the literature study it was found that most research was related to heavy duty dieselengines.

The purpose of the present study was to examine effects of driver, vehicle, and environment characteristics on Collision Warning System (CWS) design. One hypothesis was made that the capability of collision avoidance would not be same among a driver, vehicle, and environment group with different characteristics. Accident analysis and quantitative analysis was used to examine this hypothesis in terms of ?risk? and ?safety margin? respectively. Rear-end collision had a stronger focus in the present study.

  Aim. The aim of the study was to describe how nurses in home care experience to pursue palliative care in ordinary housing. Methods. The study had a descriptive design with qualitative approach and was carried out through semi-structured interviews with 14 nurses in home health care from two medium-sized Swedish municipalities. The material was analyzed with manifest and latent content analysis. Findings. The underlying theme that emerged in the study was: Working with palliative care in the patient´s own homes is positive but challenging. Informants describe among other things that they perceived palliative home care as meaningful and that relatives have a central role in the palliative home care since they are close to the patient around the clock. The stress that emerges from the heavy work load and the long geographic distances are described as strenuous and to affect the care in a negative way. Informants describe the home environment as challenging as it is often not adapted for care and the collaboration with the palliative team is described to be experienced as both positive and negative.

This work consists of a survey and risk classification of eleven metal industries including foundries, finishers and engineering industries in two industrial areas in Mora. The study follows a method called MIFO (Method of Surveying Contaminated Sites) composed by the Swedish Environmental Protection Agency. In the method assessments of the degree of hazard posed by the pollutants, the level of pollution, the conditions of dispersal, sensitivity and the degree to which the area is worthy to protect are made for each contaminated site (object). The assessment classify the objects into four risk classes in which risk class 1 denotes a very large risk, 2 large risk, 3 moderate risk and risk class 4 little risk. The work of surveying using MIFO is divided into two phases.

Sweden had in the early 1930's the lowest birth rate in the world. Population Commission which was established in 1935 concluded that one of the biggest social problems was the working women?s heavy workload. To deal with the low birth rate reforms and programs were founded both in order to help the women but also in order to support the inadequate motherhood. Government grants were set up to start the so-called vacation home for housewives where the government?s visions of the vacation homes were active rest and recreation.     Based on the Leisure Inquiry report regarding vacation homes for housewives - the purpose of this paper is to examine how the government visions regarding vacation homes for housewives were practiced and how the future of prevailing gender contract affected the holiday home.

Natural disasters are becoming more common due to climate change and it is important to adapt the society and its infrastructure to withstand events such as extreme rainfall. Precipitation is an important climatic factor affecting the transport and annually generates the cost of millions in damages, over the past 40 years heavy rain has increased and will continue to increase in the future. The extreme rainfall that occurred in Kramfors municipality in September 2013 led to flooding and destroyed several roads, including highway 90, which recently both had been rebuilt and given a new stretch of road. Extreme rainfall had also occurred in the municipality earlier.  The aim of the thesis was to examine how the Swedish Transport Administration handles new knowledge gained after natural disasters and how this is used in the planning of new roads.

The parallel bars is used in physical therapy and is mainly used for patients who have to train walking and balance after a stroke or an operation. It consists of two long handrails with two legs on each handrail. These legs go down into two ground-plates and are locked at the wanted height with a pin. The parallel bars is an appreciated device and is used on a daily basis in many care units.The main issue with the manual parallel bars is that it is very difficult and heavy for a single person to adjust the height of it. If a larger adjustment of the height has to be done, the legs have to be adjusted one at a time otherwise the they will be locked.

This essay will examine the historical picture of the island Rapa Nui as it is portrayed in popular science and in ecohistorical literature of the university of Gothenburg. This historical picture states that the inhabitants of the island cut down a lot of trees in the process of transporting the big and heavy statues, moai, from the quarry to the platforms along the coastline of the island. During this process all trees disappeared and resulted in soil erosion. The cultivation was destroyed and brought hunger to Rapa Nui. The following rivalry for food led to a situation of war followed by a cultural collapse.

As a small and land scarce country, effective waste management is ofoutmost importance in Singapore. In this study the production of biogasthrough anaerobic digestion from the organic fraction of municipal solidwaste (OFMSW) was compared to incineration of the waste. At the momentalmost all of the OFMSW in Singapore is incinerated. Three differentscenarios were compared to the reference scenario (incineration): one with alarge scale biogas plant that can treat half of all OFMSW in Singapore, onewith a medium scale biogas plant about 15 times smaller than the large oneand one with a small scale biogas plant that can treat waste from e.g. ashopping center or a food center.By using life cycle assessment (LCA) the different scenarios were comparedin terms of global warming potential (GWP), acidification, eutrophication,energy use and land use.

Background: Increasing globalization has changed the business environment and also resulted in increased awareness of the consumers and demand for higher standards of social responsibility. The companies brand strategies has gain in importance in order to strengthen their brands. A part of a company's CSR, CRM, cause-related marketing, which is a relatively new marketing strategy and created when companies choose to partner with charities and market it. Garment/clothing industry has as many others come to be shaped by the effects of globalization, but has also endured heavy criticism over the years. This criticism is largely because of the outside world's reaction to the exploitation of developing countries.

Scania is among the leading companies in the heavy vehicle industry. Scania also assemble engines for their trucks and buses, as well as to external marine and industrial applications. Wrongly assembled parts leads to quality problems, which makes it important to secure that the assembly is correct. To do this Design For Assembly (DFA) is used to describe how parts should become easier to assemble. Scania?s production unit for engine assembly has had a working method for DFA in the shape of a checklist, which is not used.

Occupational Health Service (OHS) has an important role in society. It is designed to prevent illness and strengthen the health of workers. OHS operations and development are currently being studied at the School of Technology and Health at the Royal Institute of Technology in Sweden. One of the industries studied is the home maker service. During the 2010s were such employees one of the most ill groups in Sweden.This master's thesis in occupational environment development and change management focus on examining the special knowledge an OHS and its clients in one home maker service need to strengthen the workers of the industry and find out how the interaction between OHS and home maker service works and how it could be evolved.A qualitative study was conducted in a Swedish city on the basis of an organizational perspective.

Severe floods caused by heavy autumn rains in year 2000 raised the question whether measures to reduce the damage from high water levels, in the area surrounding lake Glafsfjorden and along the river Byälven down to lake Vänern, are possible. One option is to reduce flow resistance along the river and thereby lower the maximum water level a given inflow would cause. Good knowledge of hydraulic and hydrological conditions is necessary in order to estimate the effect of such flow-reducing measures. In order to quantify such effect a 1-dimensional hydraulic flow model has been set up for the river Byälven using the software package MIKE 11. The model is more detailed, especially concerning topography and bathymetry, than earlier models used for studies of the river.