Brytspänningen är den spänning som uppkommer när överkopplingsmotståndet i lindningskopplaren lämnar sitt föregående läge vid omkoppling. Storleken på brytspänningen i lindningskopplaren beror på hur stor läckinduktansen är. Är den inte känd så kan brytspänningen istället beräknas med hjälp av FEM-programmet ACE (internt ABB-program) i samband med Mathcad. I ACE beräknas först reaktanserna i p.u-enheter mellan lindningarna och hur stora de är beror på lindningslayouten. Det är tidskrävande att använda ACE och Mathcad och uppgiften är att utreda de parametrar som påverkar storleken på brytspänningen samt att ta fram en förenklad beräkning av densamma.Genom simulering i ACE av en mängd olika lindningslayouter visar det sig snart att det är alltför många parametrar som påverkar reaktanserna.

The purpose of this study is to better understand patients suffering from psychotic illness along with their family members, and to identify treatment factors that have been helpful for these patients and their families by investigating how their relationships have been affected by treatment. In this way, treatment methods can be put in a theoretical context, treatment efforts can be clearer, and the therapist can develop professionally.The research method used is a semistruktureted interview conducted with tree patients and their families. One conclusion one can draw in the successful treatment with psychotic patients is strongly based on the therapist?s ability to build a safe and secure treatment alliance with both the patient and his family members. Meeting with patients in situations outside of the therapy room have been of great importance for the therapeutic process.Important themes for recovery that come forth during the interviews with the patients are the quality of the therapy session as healing factor.

AbstractThis report intends through a case study to investigate if lightweight concrete isappropriate as main material in the outer wall of a seven storey residential building.A technical design is carried out in accordance with the definitions and requirementsfor passive houses, given by FEBY?s1 ?Demand specification for passive houses?.A literature review is also carried out for a comparison between regular bolt wall andlight weight concrete wall, with a focus on the safety of moisture.The lightweight concrete block used in the report is as a celblock produced by thecompany H+H Sweden AB.The methods used have resulted in compliance with requirements andrecommendations from authorities. Calculations of energy, noise and moisture riskassessment has been carried out.The work has resulted in the conclusion that the lightweight concrete itself is notable to isolate in the extent necessary to obtain chosen U-value of 0,1 W/m2 ° C,without getting to thick. Therefore additional insulation is needed. There are fewrelevant reference objects built with only light weight concrete.

The control of indoor temperature must be able to handle large time constants and both measureable disturbances like outdoor temperature, and non-measurable disturbances, like waste heat from appliances. Due to cheaper microcontrollers (small computers with designated tasks) with better performance, more advanced and computation-demanding methods for control can be used.In this thesis, Generalized Predictive Control (GPC) has been implemented and tested on a theoretically derived model of a house. GPC states that a model of the system is estimated in every sample, and the control is carried out simultaneously, based on predictions of the model. Disturbances like solar radiation can be estimated and used in the control as well. The control signals are determined by quadratic programming, which makes it possible to consider conditions, for example limitations on the control signals.GPC requires a number of parameters to be defined, like model order and control signal penalty, but is relatively robust for variations in them.

Glass has sophisticated front properties and are used as facades in high buildings. During cold periods, these glass facades could cause thermal discomfort, due to cold downdraught. Cold downdraught can be countered by placing heaters under glass surfaces. Nowadays technology offers highly insulating windows, which is why there is an interest to investigate the indoor climate with only underfloor heating. The research in this area is limited, and few empirical methods are available.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

Detta examensarbete har utförts på Sapa Heat Transfer i Finspång och har tagit upp frågan med hur den interna hanteringen av produkterna kan orsaka defekter. I arbetet har en typ av defekt undersökts särskilt och denna defekt kan ses som ett exempel. Företaget tillverkar aluminiumband till värmeväxlare, främst till fordonsindustrin. Banden levereras på rullar med en diameter upp till 1700 mm, och en bredd mellan 12 mm och 1440 mm. Syftet med detta examensarbete är undersöka en defekt som är orsakad av den interna hanteringen, det vill säga det som sker mellan produktionsstegen.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

The requirements of good quality and appetizing fast food increases continuously as a consequence of a community where food is always available. The crispiness of French fries is an issue that must be considered in this context, since it tends to decrease and give the fries a soft surface not appreciated by the consumer. To prolong the crispiness, the fries can be coated by a batter, a mix of starches. The batters used often consists of modified starches, e.g. cross-linked, acetylated and dextrinizated to increase and prolong crispiness, flour to stabilize the batter and sodium bicarbonate to make the batter ?rise?.The cross-linked starch keeps the granules in a swelled state and prevents them from breaking when exposed to heat or processing: therefore, it delays the gelatinization and decreases the stickiness of the batter.

This report is focusing on problems with introducing standard enterprise resource planning systems (ERP) in businesses. A study has been carried out on a service and support department at a Swedish heat metering company, SVM North Node. The study aims to help the company become a better customer in choice and customization of a new ERP system. We make a description of the department studied and the work carried out there, on the basis of learning, knowledge and cooperation. As a final point we present some ideas on how computer systems could support their work, hoping that this will result in them making adequate demands on a new ERP system.

The workplace is for many associated with joy and commitment, for others it is associated with fatigue, inadequacy and cynicism that is explained as the three dimensions of burnout. A general view of burnout is that it is an individual problem that many companies ignore, because a preventive task does not generate immediate profits. This has been a growing problem for years. Burnout costs not only money but also time and knowledge. Unfortunately, the popular belief is that "If it ain?t broke, don?t fix it." Organizations that think this way are sacrificing future benefits for short-term gains.

Det övergripande syftet med arbetet är att undersöka och studera ett läsinlärnings projekt med fokusering på arbetet med storböcker. Med arbetet vill jag få reda på orsaken till att man har startat ett kommunomfattande läsinlärningsprojekt och vad läsinlärningsprojektet innehåller. Syftet är vidare att ta reda på vad storböcker är för något och hur man arbetar med dem. Genom arbetet vill jag hitta ett sätt som både inspirerar mig som lärare och mina kommande elever till att lära sig läsa. Arbetet inleds med en litteraturgenomgång där läsaren får bekanta sig med vad läsning är och med olika begrepp som nämns i resultatdelen.