The cost for forestry logistics in Sweden is about 25 percent of the total cost of getting the raw material to industry (Anon., 2010). There might be much to gain by taking a look at your supply chains on the logistic side in your company. In this report the logistic chains by Mellanskog for ENA Energi AB in Enköping has been looked in to. ENA Energis plant is a combined power and heating plant and about 99, 5 percent of their fuel consisted of bio energy in year 2009 (ENA Energi, 2011, länk A). The main purpose with this report is to look at three questions: 1. How does the supply chain look today? From forest to industry. 2.

The Swedish energy company Vattenfall is currently the owner of the district heatingsystems in Nyköping and Motala. To be able to also offer cooling solutions tocustomers are becoming more and more important. This report describes the resultsof an investigation of the cooling market in the two cities and the potential needs forcooling today and in the coming 20 years. The total potential for the coming 20 yearsis estimated to be roughly 17 MW for Nyköping and 9 MW for Motala.Two possible district cooling systems for each of the two city centers was modeledand a comparison was made between different cooling techniques namely absorptionand compressor chillers.Absorption chillers driven with district heating during the summer is one way ofincreasing the load in a combined heat and power plant and thereby the possibleelectricity generation. The cost of heat production must be low for absorption chillerto be able to compete as an alternative.

In this project a simulator has been developed (in C++) with the purpose of illustrating how changes in environmental regulations, tax levels and other policy measures affect the composition of an energy system. The aim of the project was to investigate how energy companies? investment strategies are affected when changes in economic and environmental conditions occur. A standard scenario has been created based on current Swedish conditions, but the user can create new scenarios and set parameters freely. The user is tasked with building power plants to supply the city/region with district heating and electricity during a pre-set number of years. When the simulation is finished the result is graded in the following categories: economy, environment and quality. To evaluate the simulator three scenarios were created (?early 20th century?, ?reduced environmental control? and ?future?) in addition to the standard scenario and these were compared with each other by examining how a select group of power plants perform under the given conditions.

Denna rapport beskriver arbetet med utvecklingen av en ny modell för kaplanturbiner. Utvecklingen bygger på två kopplade differentialekvationer som under arbetets gång anpassats och implementerats i turbinmodellen.Modellen beskriver hur vattenflöde och turbinmoment påverkas av avvikelsen från den optimala kombineringskurvan för vinklarna på turbinens ledskena och löphjul, och är anpassad för ett referensaggregat med tillgängliga provdata. Även övriga enheter i vattenkraftaggregatet modelleras och sätts samman med frekvensregulator och elnät för att simulera aggregatets reglerstabilitet i önätsdrift.Verifieringen av turbinmodellen sker genom försök att återskapa de befintliga verkningsgradskurvorna med hjälp av modellen. Resultatet visar en god följning av de verkliga kurvformerna, dock med något lägre maximal verkningsgrad.Verifieringen av önätmodellen sker genom att prova stabiliteten i nätfrekvens och turbineffekt vid stegpålastningar. Resultatet ger en stabilare reglerstabilitet än i verkligheten, men uppfyller ändå förväntningarna på en fungerande modell.This report describes the development of a new kaplan turbine model.

Energy-wise houses in Järinge - technical follow-up The company JM built energy-efficient houses in Tensta in Stockholm. They have built a total of 16 houses divided into two parts of A-houses and B-houses. The buildings are an attempt by JM to minimize energy-use of the buildings without affecting the comfort and living standards. The project aims to examine the data for the 16 houses on the basis of data and produce a report showing how the buildings worked through a technical perspective. JM approximates that the purchased energy will not be higher than 95 kWh/m2 per year.

Värmekollektor in Sunne is a company whose main occupation is to collect the gas produced inlandfills. The gas contains about 50 % of Methane which is a greenhouse gas 20 times worse than CO2and should therefore not be allowed to leak into the atmosphere. The Methane is in as large amount aspossible used in different plants for example heating of households. But there are occasions when aflare is needed to burn the excess gas at standstills or testing of new landfills. The Flare only burns themethane to reduce the hazarder?s effect of the environment, it does not take advantage of the energy inthe gasThe goal of this master thesis was for me to create a foundation for an in-house production offlares for Värmekollektor.

The housing sector of today represents for almost 40% of the energy consumption, an energy consumption of which the major part consists of non-renewable energy sources. This is not sustainable and utilization of new energy-efficient technologies in buildings can be a step in the right direction, towards a sustainable energy society.This report has been made on behalf of and in cooperation with Älvstranden Utveckling AB in Gothenburg to examine how future energy-efficient technologies can affect the energy demand in energy-efficient multi-dwelling buildings.The report is based on Älvstrandens passive house, Hamnhuset, a house whose energy consumption is far below the BBR's requirements. The report looks at the opportunities for improvement within windows, insulation, solar energy technologies, as well as white goods. Computer simulations are then made to apply the selected technologies into a reference building. Technologies are selected from an energy efficient perspective and no account has been taken of other aspects such as the economy.

Nanotechnology, one of the most interesting sciences today will no doubt have an enourmous impact on tomorrow's society and industry. One of the most interesting nanomaterial that has been discovered is the semiconductor quantum dot (QD). This material shows interesting novel properties such as a size-dependent band gap, which is an effect caused by the quantum confinement effect in all three dimensions. Due to this phenomenon the absorption spectrum can be tuned to the desired value by adjusting the size of the QD.This thesis aims to investigate how the solvent ratio of H2O/Ethanol affects the optical and structural properties of copper sulfide QDs manufactured in a chemical synthesis way using modern microwave heating. The process of manufacturing QDs using chemical synthesis often involve a capping-agent to prevent the QDs from agglomerate into bigger structures.

The swedish national board of housing, Building and Planning,recommends that all stakeholders in the construction industryperform a moisture control design to make sure that the buildingachieves good moisture resistance. Since June 1, 2006 there are nospecific requirements or quantitative values for air leakage.Although the swedish national board of housing does presentrequirement that the building envelope must be sealed so that theclient?s requirements for specific energy consumption and installedelectric power for heating purposes are met. Despite this, studiesfrom SP shows that few buildings meet the client?s requirements inspecific energy, which increases the risk of occurrence ofcondensation-related moisture damage.This study aims to evaluate curtain walls connections from airsecurity and moisture safety.

Calesco Foil AB is a manufacturer of thin flexible circuits for heating or electric conduction.The plant is located in Kolbäck, Sweden.One of the company?s products, the conducting polymer pasta is in present situationunpredictable. Unpredictable in the way that the same type of heater shows differentresistance, depending on which time they have been produced. The desired repetitivelyprocess is almost non-existing.The aim of this master thesis is to primary identify those parameters that effects theresistance, observe and if possible to perform tests on them. The results from this analysisstand as base for recommendations to achieve a repetitive and standardized printing process.The results and the observations from the tests indicate that a repetitive process is possible toachieve.

If you have access to wood, a wood burning boiler is a cheap way to heat your home, but it is certainly not the most convenient option. Wood requires many operations and management, which takes time. One way to reduce this workload is to have a modern boiler with automatic ignition. Enertech/CTC has a desire to create an accessory with automatic ignition to a modern wood burning boiler. Today there is no boiler on the market that can ignite firewood automatically without the introduction of paper and sticks.

Everyone has to take a greater responsibility in energy issues, both individuals and companies. There have been some major developments in the construction industry but there is still a lot to be done. This diploma work thesis presents different methods of making existing construction shed establishments to use less energy. What is possible to do and how much energy is there to be saved? A shed establishment consisting of 8 shed units were studied in this project and the building simulation tool VIP-Energy was used to simulate different types of material in the sheds. An infrared camera was used to locate thermal bridges. There are several factors that can be improved to make a construction shed establishment to use less energy.

This thesis is about a part of the marquetrytechnique, scorching. Scorching is made by heating up something, put a veneer into the heated substance and make a controlled burning. This technique is old but still used today and have according to me great potential for development. In my work I wanted to give the scorching greater room then I earlier have seen. I wanted the scorching to be the dominant ingredient for a decorative element in a piece of furniture or an interior.

With rising energy prices and the threat of climate change, energy costs and energy savings havebecome a central and important part in building. Therefore it is interesting to explore different andnon-conventional methods of energy conservation. Building Earth sheltered houses is such a method.Earth provides good insulation and provides the ability to both reduce the total heating needs and toreduce the maximum power demand. The aim of this study was to construct a house in Malmö and seeif Earth sheltered houses can be a cost effective alternative for the construction of sustainable andenergy-efficient houses.Previous studies have shown that Earth sheltered houses have reduced their power requirement with upto 25% and their use of energy with 10%. Numerical calculations in Comsol Multiphysic 4.2, wasperformed on a house with different degrees of earth covering.

Microwave is a time- efficient device for heating and reheating of foods. Despite the fact that its effects on foods have been evaluated during a long period of time, without any more negative effects shown compared to conventional cooking, one third of the Swedish population believes (in 2010) it accounts for a higher loss of nutrition. This literature review aim to compile studies regarding how food is affected by cooking in microwave, with respect to cooking losses, nutrition, secondary metabolites as well as sensory and textural aspects and compare it with conventional cooking. The compilation shows that different combination of effect (W), time and amount of water during microwave cooking have different effects on foods. The contents of proteins, vitamin B and carbohydrates are generally higher after microwave cooking, while anti-nutritional substances are affected much less during conventional cooking. This also depends on if it is of animal or non-animal origin. However, for the majority of nutrition values the differences are quite small.