Aeroseum is an aviation museum located in an old military underground hangar. The ventilation system in the hangar is designed for the military purpose of the hangar. This design includes a solution with air flowing through the space between the construction of the hangar and the rock surface. The solution is intended to avoid a buildup of inflammable gases. This design leads too high humidity levels in the hangar.

In Sweden, a big part of the energy use is used in the housing sector. Political goals and targets are set up which the housing sector needs to work towards. Apartment buildings are a major part of the housing sector in Sweden and therefore reduction of energy use in these kinds of buildings are key to lower the energy use in Sweden. But there are not only political incentives to reduce the energy use. Some energy?saving measures are directly profitable and should thus be performed.

Today most ice rinks in Sweden use secondary refrigeration systems with a solution of calcium chloride and water as secondary refrigerant. Due to the large amount of energy such a system uses more efficient systems would be desired.An earlier study concluded in the possibilities of using carbon dioxide as secondary refrigerant with copper tubes as the loops in the ice rink. Since then 3 ice rink refrigeration systems has been built with carbon dioxide in copper tubes. Excluding the ones being direct involved in those projects there is still very little knowledge about how these system works. This study has been made primarily with the aim of adding to the knowledge concerning availability and cost and secondary to look at possibilities for improvement.A comparison between systems with carbon dioxide, calcium chloride respective ammonium solved in water has been made by using Decision Matrix.

Clostridium difficile is a pathogen for both humans and animals and is often associated with antibiotic-associated diarrhea. Recently, several human cases of C. difficile-infection with increased mortality and morbidity have been reported. In studies performed in different countries C. difficile has been found in meat.

The purpose with this report is to make a contribution to Bodycote heat treatments workshop in Värnamo, how to introduce, establish and constantly improve its environmental system. The rapport will help Bodycote with there certifying in ISO 14001: s demand standard. Organizations who continuously work with environmental issues have a lot to gain. Two things an active environmental development process will convey are, building of thrust within the circle of customers, and great financial savings. An increasingly numbers of organizations realize the importance to introduce a functioning environmental system into their activity.

This study is a part of a Swedish research and development project that is about heat-treated wood and is led by the Swedish University of Agricultural Sciences and Luleå University of Technology. Products that are heat-treated already exists on the market, foremost the Finnish brand ThermoWood®, bur the project group want to find out if it would be possible to start a Swedish production with somewhat different applications than what is common today. The heat-treated wood has many attributes that have changed in the heating process. It becomes more biologically durable, it gains stability in form and dimensions and it becomes darker and looses several unwanted extractives such as resin. Disadvantages that can be mentioned are that the wood becomes fragile and the strength properties changes. My main purpose with this study is to look into customer involvement in the early phase of product development. I also want to find out if the customers I interview think that the product is worth working with, which means start a Swedish production.

Sverige och EU har man som mål att halvera energianvändningen fram till 2050 och det arbetet måste starta nu. Det är 15 miljoner kvm byggyta som måste halvera sin energianvändning varje år och i 40 år framåt. Redan idag är 70 % av alla hus till 2050 byggda, vilket innebär att även om vi skulle bygga passivhus fram tills dess skulle det inte räcka för att nå målet. Det är alltså en stor utmaning att halvera energianvändningen till 2050. En jämförelsestudie har genomförts mellan två värmeåtervinningssystem.

This report is focusing on problems with introducing standard enterprise resource planning systems (ERP) in businesses. A study has been carried out on a service and support department at a Swedish heat metering company, SVM North Node. The study aims to help the company become a better customer in choice and customization of a new ERP system. We make a description of the department studied and the work carried out there, on the basis of learning, knowledge and cooperation. As a final point we present some ideas on how computer systems could support their work, hoping that this will result in them making adequate demands on a new ERP system.

Works on transparent paper, also commonly known as tracing paper, have been described as ephemeral or temporary working documents and they usually number large quantities in archival and museum collections. They have therefore previously been considered of lower priority and can be found in poor condition due to a lack of treatment or suitable storage prospects. In addition, transparent paper can be very sensitive to moisture and reacts by deformation or loss of transparency. Due to the volume of these works and the necessity of treatment, there is a call for simple and efficient conservation methods. A common solution in archives for the treatment of water-sensitive works on paper has been the use of heat-activated tissues as they can be applied without the introduction of solvents. There is little published about the use of heat-activated tissues on transparent paper and is mentioned only briefly in existing literature.

The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.

In recent years it has become more and more evident that man has contributed to much of the climate changes that have taken place during the last century. A major challenge today is to reduce emissions and energy usage at the same time as the global population is growing. To contribute to a better environment, Stockholms Stad has set at target of becoming fossil fuel free by the year of 2050. The construction of new districts is done with this goal in mind; energy efficiency and renewable energy sources are examples of methods to achieve this.Solar energy is considered to be a sustainable energy source and the most common techniques to harvest solar energy in Sweden are solar cells and solar collectors which produce electricity and heat respectively. This report aims to investigate whether an investment in any of these systems would prove to be economically beneficial at Kvarnholmen, a district under construction in eastern Nacka, Stockholm.Since the finished blueprints only cover a small portion of Kvarnholmen, the report examines the possibilities for a house where construction has already begun, Nya Kvarnen.

I want to look at the possibilities to start selling hot water from a small district heating plant with bioenergy. My reason for doing this project is to look at a new business opportunity for our farm. Our company have less work during the winter time compared to the spring and this project will give us more work during the winter. I also want to take as much material as possible for heating from our farm in order to increase the value of the products from the farm. The project is in a village near us, where we should support a school, a churh, a home for the aged, a kindergarten and a parish hall with heat. In my work I have compared two different alternatives with each other. The first alternative is to put a central heater in one of the buildings, the home for the aged, in which we will burn oat.

Emission of nitrogen oxides as well as carbon monoxides is an inevitable result of combustion. A Swedish law "Law of environmental fee for emissions of nitrogen oxides as a result of energy production" (lagen om miljöavgift på utsläpp av kväveoxider vid energiproduktion (SFS 1990:613)) controls the emission of NOx from energy production by a system of fees. The system has resulted in a strong approach toward less emissions of NOx among the energy production plants. High emission levels, today exceeding 52 mg/MJsupplied fuel, leads to costs for energy production companies. This paper examines possibilities to reduce the emissions of NOx by optimization of the SNCR-technique in a biofuel fired heat and power plant.

Turning solar collectors, heliostats, is certainly not a new idea but has been explored for at least two decades. Projects on this subject have resulted in more or less realistic constructions, in a commercial point of view. Far too often the technical goals have had higher priority than the economical, which has resulted in a few constructions having the ability to compete with conventional, fix solar collectors. The economical issues have been given high priority in this project, without decreasing the demands on reliability. The system has been given the following mechanical and electronical properties: One-axis movement, fix heat carrying fluid system, microcomputer controlled movement and automatic protection from overheating.

The aims of this project were to describe the circumstances around dogs being left alone in cars, to investigate owners? knowledge of the risks associated with leaving dogs in cars and the relevant legislation and, finally, to study how changes in the air temperature and air composition in the car affect the dog. The project consisted of a survey of the literature, a questionnaire part and an experimental part. An important conclusion is the importance of the level of knowledge of owners, since there are several ways in which an owner can prevent their dog from heat stroke and, in the case of an eventual accident, their action can have direct consequences in minimizing the long-term damage to the dog and even whether or not it survives. Fewer than half of the owners in the study knew that for a dog suffering heat stroke, the most important thing is to bring the body temperature down. Only a third of dog owners knew that if a dog is left in a warm car and showing signs of heat stress, then the police should be contacted and the dog quickly helped out of the car.