The purpose of this study was to describe senior nurses? expectations concerning how a digital information and communication technology systems (ICT) can contribute to the improvement of care leadership and how it can strengthen ties between the school's theoretical world and the practical clinical work-based training (WP) in nursing. The study has a descriptive design with a qualitative approach. The study involved seven leading care nurses. Data were collected through semi-structured interviews.

Drain water heat recovery is an uncommon measure in multi-unit residential buildings. There istechnology available for the purpose but the knowing and experience of the heat recovery systems islittle. The purpose of this thesis is to evaluate the future potential of drain water heat recovery inmulti-unit residential buildings.A major part of the multi-unit residential buildings in Sweden were built during modernismen andrekordåren (1940?1975). Many of the buildings have worn out drain and water supply systems andmany are in need of a general refurbishment.

Wastewater treatment is increasingly controlled by the Swedish environmental quality objectives, adopted by the Swedish parliament. There is a need for a sewage system that can fulfill stringent requirements concerning the environment, recycling and resource use and hygiene. Additional environmental aspects in recent years are the impact of climate change, new knowledge about the effects of pharmaceuticals in water, the need for improved wastewater treatment and increased recycling of nutrients to agriculture. This report has, from a future scenario of the year 2050, analyzed seven different systems for wastewater treatment and treatment of compostable biowaste from households in Eskilstuna. A future scenario was chosen based on that within a forty year period new challenges may arise which can result in higher demands on sewage treatment than those we see today. Another reason why the future scenario was established is that changes in wastewater treatment systems are slow to establish. The analysis is mainly focused on the economical aspects but environmental aspects such as emissions to receiving waters and potential recycling of plant nutrients has also been evaluated briefly.

The accounting information system comprises budgeting, accounting, and costing. The accounting information system has, traditionally, constituted an integrated system where the different elements collaborate. If ABC is introduced this order is disturbed, since ABC is based on another logic which cannot easily be integrated with budget and accounting. ABC, therefore, is usually used parallely to the conventional costing method. There are, however, companies that have taken its ABC one step further by letting it replace the old costing model and integrate it with the accounting information system.

This thesis aims to investigate SAAB AB´s possibilities to use synthetic instruments in their test systems. The reason for this is reducing costs and the risk of obsolescence which is common when test systems operate for several decades.The market around synthetic instruments has been explored in the search for suitable hardware and software. Software has been developed in LabVIEW and synthetic instruments have been created with the help of IVI-drivers. The hardware consisted of PXI-instruments (Waveform generator and Digitizer), connected to a computer using a fiber optic link and PXI-chassi. The created instruments was then compared to common instruments used today, and the comparison turned out well.

BackgroundDiathermy is the most commonly used surgical instrument in the surgical area today. Diathermy is used in surgery to cut and coagulate tissue. The use of diathermy releases chemical substances in to the environment in the form of diathermy smoke. Research shows that these chemical substances pose health risks to both staff and patient exposed to the smoke. To protect the interdisciplinary, perioperative team from the smoke, smoke evacuation systems can be used.ObjectiveThe purpose of the study is to highlight the work environment of the perioperative team when working with diathermy smoke.MethodThe study is meant to be implemented as an empirical descriptive sample survey.

This bachelor?s thesis report aims to investigate the problems that exist with the ticketing systems ofthe various regional public transportation authorities, specifically with regards to inexperiencedtravellers and cross-county travel.This is done in part through a comprehensive survey for all of Sweden where both the regional publictransportation authorities and passengers were asked about their opinions, as well as a throughin-depth survey focused on the counties of Stockholm and Uppsala. The results of these surveys arethen compiled and analyzed to identify the biggest common problems.The tree biggest problems prove to be a complicated implementation, lack of availability and lack ofinformation. In order to improve the ticketing system it is therefore proposed to implement asimplified ticketing system, as well as improved accessibility and information.         .

As an amateur it can be difficult filming from several angles at the same time as this requires several cameras. It´s also hard to film at occasions when it´s not appropriate to manoeuvre the camera manually. Systems for solving these problems already exist, but it´s either more expensive, professionalsystems or cheaper systems with limited functionality.The purpose of this project is to develop a cost efficient solution to the problem above that offers a better functionality then existing commercial systems. The biggest difference from existing products is the wireless video feedback from the camera to the remote unit.The result of the project is a system consisting of two units, a manoeuvre unit with a cradle for the video camera and a remote unit from which the operator can control pan and tilt of the video camera.Communication between the two units is wireless.On the remote unit there is a joystick and a display mounted. In addition to this, there is also an IR receiver that is capable of reading the signal from the cameras own remote and sending it to the manoeuvre unit.The manoeuvre unit is equipped with one motor to control the tilt function and one motor to control the pan.

A Geographic Information System (GIS) is about presentinginformation with the map as a base. This is increasingly being used on internetsites and in mobile apps. With a GPS it is possible to see where you are andhow to reach a destination or check if the bus is in time. A question to ask isif this technology is possible to implement in ordinary primary schooleducation. If it is, learning history, geography, religion and so on with a GISlearning tool might be possible.

Sandvik Wire needed a review of the administrative part of the order fulfillment process and especially the work around packing and the inventory of finished goods. Therefore we acquired the assignment to investigate the administrative part of the order fulfillment process in the company with the purpose to identify potential for improvement. This investigation was performed with focus on the terminal and packing functions. The purpose with the investigation was also to identify critical factors for an efficient order fulfillment process and investigate if information quality is such a factor.Data was collected through interviews and observations on Sandvik Wire. With the help of this data the information and material flows was mapped, the work within terminal and packing, and adjacent functions was investigated.

This report is the result of a thesis conducted at the consulting firm Bjerking AB andis the final part of the Bachelor Programme in Construction Engineering at Universityof Uppsala. The work aims to investigate the costs and how the choice of ventilationsystem affects building projects during a long-term period. This report covers costssuch as investment, maintenance and energy but also how they affect residents andbuilders. Building regulations for energy consumption are expected to be tougher;therefore a comparison of two different heat recovery ventilation systems(HRV-system) was made. One system is based on a centrally placed unit that coversthe whole buildings ventilation through vertical shafts.

This reports purpose is to give a general view on how to handle information collectedthrough photogrammetry and laser scanning with the help of UAS. The report ismade in collaboration with WSP Group and will briefly describe howphotogrammetry and laser scanning, also known as Lidar, works and how those areused in the construction business today. Then the focus will be on how gathered datais handled today, how outsourcing of data should be approached and if there are anyconsequences if data is handled in the wrong way. Interviews have been made with allparts in the UAS business. That includes authorities as Transporstyrelsen,Försvarsmakten.

I det moderna samhället utför många privatpersoner ekonomiska handlingar på Internet. Vi handlar i större utsträckning via Internet vilket kräver att vi skyddar oss mot olika datasäkerhetshot för att vår personliga information inte hamnar i fel händer. I studien gjordes en kartläggning på privatpersoners medvetenhet av datasäkerhetshot genom enkätundersökningar. Vidare undersökte vi vad två e-handelsföretag gör för att skydda privatpersonens personliga information. Resultaten visade att datasäkerhetsmedvetenheten var hög hos många privatpersoner men det fanns ett samband mellan ålder och medvetenhet.

Abstract: The world in which companies are acting today offers challenges in the sense that it is rapidly changing and that a vast amount of information is available. In order to ensure the competitiveness and survival of the company, an effective and efficient environmental scanning is essential to the company. Our aim with this Master's thesis is to investigate what factors constitutes important and basic conditions in a well functioning environmental scanning and how companies strategically can go about to achieve this. In order to highlight and specify how these factors can be applied on a specific company Thule has been our focal point. Thule.

Scania Top Team is a competition where the best mechanics in the world are competing against each other. In 2011, the world final was recorded and this material is now used to see which problem solving strategies these top of the line teams are using to solve the realistic problems assembled in front of them. To help them, the mechanics are allowed to use two of Scanias IT-systems: Scania Multi and Scania Diagnose and Programmer 3. This report consists of two parts. The first part is the development of a method to analyze the recorded material.