This thesis describes the new construction of a small house and it includes studies of three heating systems: geothermal heating, district heating and pellet. The purpose of this thesis is to project a small house which can manage Building Regulations, BBR conditions and then examine three possible heating systems for the small house. This thesis is a literature study which gives an understanding of the heating systems technical structure, properties and costs. An empirical study completes the literature study by giving a deeper understanding of district heating costs and pellet costs. The empirical study contains two interviews, one of which was conducted in a district heating corporation and the other interview was conducted in a pellet corporation.

The use of spread spectrum signals has increased dramatically in military applications. Finding methods for detecting and positioning of these signals have become interesting research areas for signal intelligence purposes. One method is to measure the time difference of arrival (TDOA) that occurs when two receivers are synchronous and spatially separated. Based on the TDOA-technique an audio-demonstrator has been developed and implemented. This report describes the theory for how sound received in microphones can be used to extract information about the transmitter?s position from the measured time difference.

The animal welfare act in Sweden states that dairy cows need to have at least a dim light present at night, but there are no recommendations for what intensity the light should have. It is unknown how cows perceive and react to low light intensities and earlier studies on this topic are limited. Red light as night light has also been suggested, based on the cows? inability to perceive red light. This have however been questioned. The aim with this study was to investigate how four different light intensities affect dairy cows behavior.

This report is a result of a degree thesis at Luleå University of Technology together with Stram AB in Växjö. The project aimed to develop a size reducible bed, that gets small when folded and has a new slim design. The development of the new folding bed had the purpose to give Stram AB new ideas of how guest beds can look like and be used in the future. Information about Stram´s products and also information of other similar products on the market was gathered. A visit at a store, internet and interviews gave grater insight of the market, and of customer needs.

Milk fat is an important feature in many different milk products and other foodstuffs and it is often crucial for the dairy plants that the milk fat is stable for different manufacturing processes. Lipolysis is the enzymatic degradation of fat and is the one of the causes for an elevated amount of free fatty acids (FFA) in milk. Further, the change in fatty acid (FA) composition in milk can affect the stability of the product and also the manufacturing process. Both internal and external factors, at farm level or at the dairy plants can affect both FA composition and content of FFA. Milking frequency (MF=number of milkings per cow and day) and the composition of feed are two examples of factors generally performed at farm level. The objective of the present study was to evaluate how FA composition of milk and amount of FFA are influenced by two different ingredients supplemented to concentrate.

Fog is a small-scale weather phenomenon that are fascinating to people. However, the presence of fog in road traffic reduces the visibility and increases the risk of road accidents. By the Swedish Road Weather Information System (VViS), the safety on roads could ameliorate and road accidents caused by fog and other weather hazards could be prevented. Fog is however a complex and usually local phenomenon, why fog formation generally is not easy to predict. For that reason, a statistical mapping of fog, especially along a motorway with high traffic volumes, could be useful in planning to prevent road accidents.

The Clinical Pathology Laboratory at SLU in Uppsala has analysed several blood samples from Dachshunds with severe anemia. As there are no previous studies on this topic, a study was performed to evaluate if Dachshunds are more prone to severe anemia compared with other breeds. In addition, a retrospective case study on Dachshunds with severe anemia was done to search for common risk factors or diseases. Hemoglobin values in samples from 1272 Dachshunds and 2269 German Shepherds analyzed from September 1994 to October 2007 were used to compare the frequency of severe anemia in Dachshund and German shepherd. The samples were identified by laboratory information system.

The aim of this study was to provide SCA Forest Norrbotten District with material to assist in their work towards decreasing the frequency of bucking splits in their saw timber logs. SCA Forest supplies the Munksund sawmill with pine timber. Periodically the sawmill experiences problems related to bucking splits in their logs. The purpose of this study was to find an available method to measure the occurrence of splits directly on incoming timber. The ambition was also to gain some knowledge about possible variations between different logging crews in terms of split frequency. If possible, this information could be used to investigate if certain crews produced more splits than others, and thereby making it possible to provide feedback to the logging machine operators. The study consisted of two major parts, a literature review, and a practical sawmill study.

To design new and high tech products the engineers rely more and more on computer based simulations to investigate the properties and behavior for a component or system.To verify these computer based simulations the dynamic properties for the components of the drivetrain needs to be verified. Therefore measurements of the stiffness and vibrations for the rear axle has been performed. This report show how the measurements has been implemented and evaluated, along with some interesting results for the rear axles properties.The static stiffness for the drive shaft along with the axle-gear has been determined. It is found that the stiffness for the whole rear axle is near the stiffness for the drive shaft, which means that the drive shaft becomes the dominant component of the system and affects the rear axle stiffness the most. The measured stiffness of the driveshaft is close to its theoretical stiffness.The stiffness for solely the hypoid-gear have been calculated using the stiffness for the rear axle and driveshaft, and thus has a range for the stiffness of the hypoid gear been determined.The backlash for the whole rear axle and for some individual components has been determined, where the backlash between pinion and crown-wheel has negligible impact on the total backlash.Measurements of the crown-wheel and pinion movements have been conducted, where the direction of movement is consistent with the theoretical direction of the forces.The vibration measurements show that the vibrations are more severe at certain rotational speeds.

To identify the exchange and adaptation that takes place in the business relationship between electricity suppliers and electricity customers and analyze how these factors affect the strength of the relationship.The investigated concepts create synergies. The strength of the business relationship in the current situation is dominated by weak reciprocity in adaptation and an inefficient exchange of information with low frequency..

This thesis describes the new construction of a small house and it includes studies of three heating systems: geothermal heating, district heating and pellet. The purpose of this thesis is to project a small house which can manage Building Regulations, BBR conditions and then examine three possible heating systems for the small house. This thesis is a literature study which gives an understanding of the heating systems technical structure, properties and costs. An empirical study completes the literature study by giving a deeper understanding of district heating costs and pellet costs. The empirical study contains two interviews, one of which was conducted in a district heating corporation and the other interview was conducted in a pellet corporation.

This Master´s thesis aims to aquire knowledge about volunteers attitude toward work. It emphasis is on the differences between volunteers and non volunteers. There are four research questions used in order to fulfill the aim in a scientific manner. The essay aims to get in depth knowledge regarding whether or not the respondents feel that they have gained advantages in work life due to the fact that they are involved in volunteer work. One of the pivotal questions is if there is a possibility to see a pattern that binds together the reasons for volunteer work and the attitude toward work.

This essay is an analysis of the objects made of bronze found in an excavation Västergarn parish, Gotland, in 2010, conducted by the University of Gotland. The studied material presented in this essay comes from contexts inside, as well as nearby the foundation of a medieval building which purpose is still not certain. The first purpose of this study is to present the bronze-objects found inside and nearby the foundation of house 6, and to see if there are any datable objects. There is also a discussion whether there has been any bronze-crafting in the area. The second purpose is to make a contextual analysis to see if there are any differences between the material found outside and inside of the building, and what conclusions can be made regarding the function and use of the building.

The Energy Market Inspectorate is implementing a new tariff regulation in Sweden. A small part of the new regulation concerns effectible operation costs and originally they where intended to be calculated using a modification of equivalent comparison standards, in Swedish Ekm. This thesis is intended to analyze if Fortums grid in Stockholm could be described correctly, using equivalent comparison standards. In Ekm every part of the distribution grid is designated a weighting in relation to 1 km 0.4kV over head line. These Ekm-measurements are intended to simplify comparison between different grid areas with different structure and geographical conditions.

This Master?s Thesis is an evaluation of the software Xilinx System Generator (XSG) and blockset for Matlab. XSG is a module to simulink developed by Xilinx in order to generate VHDL code directly from functions implemented in Matlab. The evaluation was made at Saab Avionics AB in Järfälla, north of Stockholm. In order to investigate the performance of this new module XSG to simulink, a model of a frequency estimator often used in digital radar receivers were implemented in Matlab using XSG.