The purpose of this report is to investigate the possibilities with drain water heat recovery (DWHR) in residential buildings. Information and relevant theory has been collected and summarized in this report. Calculations have been done for given scenarios to evaluate profits. DWHR heat exchangers use simple technology and have long life-time. The heat exchanger is connected to outgoing drainage pipe and incoming cold-water supply so countercurrent flow is accomplished.

The Homogeneous Charge Compression Ignition (HCCI) engine is promising in terms of lowNOx, low particulates and high efficiency. Due to its homogeneous charge, where thecombustion starts almost simultaneously from a number of points in the combustion chamber,only lean mixtures are possible to burn because of the resulting rapid combustion, which is muchfaster than the combustion in an SI-engine or a diesel engine. When richer mixtures are used thecombustion will start earlier and also be more violent.To phase the combustion later and lower the combustion speed, external cooled EGR can beused. The EGR-system used in this thesis uses a divided exhaust channel where one channel andits corresponding valve are used only for transporting EGR back to the intake system.Consequently the EGR-valve is connected to the intake pressure. This system is called Direct-EGR (D-EGR).Engine tests verified that the CA50 indeed is phased later when cooled EGR is used.

The sound part is mainly practical and is dependent on concepts that have been tested through measuring with a sound level meter. The design part is more theoretical and has been verified with CAD models and finite element analysis.With a sound damping hood on the compressor the sound level is reduced with up to four dB. An optimized absorbent for the compressor space gives a reduction with three dB. By using the insulation for the heat water tank as absorbent we can see a sound reduction on the lover octave bands. A reduction like this is elsewhere hard to achieve as at it requires thick absorbents.By changing the today?s insulation to the heat water tank to a form of polystyrene polymer insulation the weight from the heat pump above can be transferred to the stable heat water tank.

Göteborg Energi has a surplus of district heating during spring, summer and fall. The heat surplus is due to a constant production of waste heat from oil refineries and heat from waste incineration over the year. It would be desirable to increase the demand for heat and the uptime for the newly built combined heat and power generation plant, Rya Kraftvärmeverk. One alternative could be to integrate Rya Kraftvärmeverk with a pellet production facility. By producing heat, electricity and pellet in a joint process the energy use can be decreased.

My questions at issue for this report has it´s beginning in the growing problems of thenegative effects of burning fossile fuels and the rapidly growing energyprices.1. Is it possible to design a micro scale powerplant?2. Is it economically interesting for a potential customer to by such a product?The aim with this report is therefor, with the help of design work and calculations, to answerthese questions and to create a platform for building a fully functional micro scale powerplant.The material used in the report is mostly product catalogs from various industries but alsostudy course littrature about steam engines.The result of the report is that it is fully possible to design a fully functional micro scalepower plant.

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

En hanteringsutrustning för att underlätta förberedelser av gips på sjukhus.

Latent heat storage is a way to store thermal energy when a phase change material undergoes a phase change. The advantage of latent heat storage is the capability to store more energy per mass unit than other heat storage methods. The most commonly used phase change in latent heat storage is the transition between solid and liquid. Phase change materials can be divided into organics, inorganics and eutectics.In the Nordic electricity market the price of electricity is set every hour by Nordpool spot, which leads to price fluctuations because of changes in demand. The main goal of this report is to create a latent heat storage system in a single-family home and investigate the possibility to save money by charging the latent heat storage system when the price of electricity is low, and discharge when the price is high.The thermodynamic model consisted of a ?tube-in-tube? heat exchanger with phase change material in the outer tube and water as the heat transfer fluid in the inner tube.

The thesis describes a completely new biofuel system to generate particle-free heat from combustion of ash-containing biofuel particles at high temperatures.The suggested system gives opportunities to introduce biofuels in new areas.Main components in the suggested system is a heat radiating combustion chamber intended for pulverized wood, combined with regenerators to extract heat from flue gases and simultaneously preheating the combustion air.The thesis contains a description of the suggested system, theoretical considerations, calculations regarding the combustion, and includes results from tests performed.The results from calculations and tests performed concludes that the system is workable and possible to apply..

Understensho?jden is Stockholm's largest eco-village which was built in the early 1990s with the vision of enabling ecological living for people. However the ecovillage is no longer considered as environmentally friendly because of its relatively high energy consumption, and non-updated energy system. The purpose of this study is therefore to investigate how Understensho?jden should reduce their energy consumption and upgrade its energy system by using Blower-Door, IR-camera and Design Builder.

Every year, KTH participates in the Shell Eco Marathon, a competition whose goal is to design a vehicle that can go as far as possible using only the equivalent energy of one liter of petrol fuel. This year, one of KTH?s contributions to this race is the Agilis prototype; a car powered by a uniquely configured HCCI-engine developed at the university. The engine is dependent of several subsystems in order to work properly, among other, systems for cooling and lubrication.Combustion engines are in need of a cooling system that reduces the heat developed during the combustion. In general, two main types of cooling systems are employed; either air cooling, where the outside of the cylinder is exposed to a flow of the surrounding air, ore water cooling, where water flows in tubes around the engine, and the heat are transferred by the water to the surrounding air through a heat exchanger.The purpose of the lubrication system is to prevent the friction that builds up in the interference between moving parts in the engine.

Humanity stands before a huge challenge to lower its emissions of carbon dioxide and its use of energy at the same time as the global population is rising and the developing countries are being industrialized. A lot of newly built buildings are due to this challenge, designed to be more energy efficient but also use renewable energy resources instead of pollutant fossil fuels .Solar energy is one of the purest forms of energy that exists in abundant amounts, which is why it is most likely that it could come to play a major part in the future energy market. The main purpose of this report is to investigate the possibility to implement a sustainable energy system with solar thermal heat and  heat storage as main sources of energy in the neighborhood ?kvarteret Lagern?, which is the area where the old football stadium ?Rasunda Stadion? was located. New developments within different heat storage techniques have opened up new approaches to enable buildings an all year round heat supply from solar energy. This report will focus on heat storage in boreholes. At the present here is only a preliminary plan of how the neighborhood is supposed to be designed.

För att tillgodose den studerande KTH byggnadens framtida krav kommer det befintliga ventilationssystemet att bytas ut. Två olika möjliga värmeåtervinningssystem har jämförts ur fjärrvärmebehovssynpunkt. Det befintliga systemet med vattenburen batterivärmeväxlare har en låg värmeåtervinningsgrad och Akademiska Hus önskar system med högre värmeåtervinning. I byggnaden har roterande värmeväxlare och frånluftsvärmepump för uppvärmning av tilluften jämförts. Då värmeåtervinning från dessa system inte är tillräckligt kommer fjärrvärme att används.I beräkningarna jämförs fem roterande värmeväxlare mot varierande antal frånluftsvärmepumpen.

The study took place at a food corporation in Växjö, Sweden. It describes a building that contains four tanks in which glucose syrup is stored. The purpose of the study was to calculate the amount of heat that leaves the building and the amount of heat that is supplied by the installed heating equipment. Before the calculations could be implemented, all the systems that supply the building with heat had to be examined. With a small amount of information from earlier studies, the work to gather all the data necessary for the calculations began.

The borehole heat exchangers of today suffer from poor thermal and hydrodynamic performance. The purpose of this thesis is to improve the performance of ground source heat pump systems and thermal energy storages by increasing the energy efficiency of the borehole heat exchangers. For this reason, the annular coaxial borehole heat exchanger (CBHE) has been analyzed. This type of heat exchanger is interesting in terms of both thermal and hydrodynamic performance. A model has been set up in the program Comsol Multiphysics in order to investigate the heat transfer characteristics along the borehole.