Husums plant has a selection of different pulp pumps at bleaching plant 4 and 5. The displacement- (HC-pump, Sund Defibrator PTD-60) and centrifugalpumps (MC-pump, MCA 42-200, MCP 30/20) are of interest in this report. The centrifugal pumps are controlled by throttle valves, which result in an energy loss. Chemical mixers are used to mix ClO2 into the pulp before proceeding into a holding tower where the bleaching process occurs.The energy demand of the different positions has been measured or calculated to be used in comparisons against new equipment. Quotations were requested and delivered from Valmet and Sulzer.

The purpose of this thesis is to examine how investments are justified in the Swedish data center industry, with a focus on cooling equipment. This is achieved through semi-structured interviews with 20 different interviewees. These interviewees represent different facets of the industry and facilitate an understanding of which factors, such as: investment costs, operating costs, reliability, environmental impact and the influence of external and internal actors, come into play and to which degree they impact the investment decision-making process. The results show that primarily low operating cost in the form of low energy consumption is the driving factor when it comes to the procurement of new equipment. A lower environmental impact is a positive side-effect of lower energy consumption.

The purpose of this thesis has been to determine experimentally how good a peltierelement is to convert waste heat from wood burning. Three different peltier elementswere used in a comparison study. The comparison was mainly done to know howmuch power could be obtained from each element. Even, a circuit with a step-upfunction has been created to give a higher output voltage than the peltier elementitself. The result of the experiments was a low output power, the highest valuereached 2.18W.

Efficient energy use in the housing sector is crucial for achieving a sustainable society. The expansion of this sector only represents a fraction of the existing houses, hence it?s within the existing houses the potential for energy savings lie. This potential has been analyzed in order to determine if it?s possible to cut the current energy demand in half.

This report is about logistic efficiency in companies without own production. The authors have interviewed employees working at two companies, Telias store in Skärholmen and Orion Diagnostica AB. The purpose of the report is to find out which logistic functions the two companies are using to create efficiency.Today?s markets are more global. Different parts of a product can be made in different parts of the world.

The Goal with this Master of Science thesis is to expand the possible turbine efficiencymeasurements on an exhaust turbocharger. It was done as a part of the CICERO competencecentre. To feed the turbine with air a special flow rig has been used. Instead of loading theturbine by just restricting the compressor flow a docking system for an electrical dynamometer isdesigned to use the dynamometer as an additional loading source. By using an electricaldynamometer as loading device for the turbine, measurements are not depending on compressorperformance.A large part of the work consists in designing accessories for the dynamometer.

As a result of globalization, multinational teams are being more frequently used in today´s businesses. This specific type of team can be described as heterogeneous when it comes to nationality and linguistics. The aim of this study was to explore the concept of multinational teams. This was made using culture as a main concept, and nationality, linguistics, and organizational culture in order to describe it. We intended to say something about how this type of team´s efficiency; when it comes to satisfaction and performance; was affected by national and linguistic heterogeneity within the team.

We have chosen to write our essay in collaboration with Varbergs kommun, where our starting point is to improve energy efficiency by management control. Their occupation separates from a pure profit driven corporation and therefore the management controls have to be adapted accordingly.  The reason why we have chosen to write an essay about the management control opportunities to improve the energy efficiency depends on two different reasons. The first reason is that we find it very interesting, how with support from the management control it is possible to improve different parts of the operation. And the second reason is that Varbergs kommun expressed a wish that they wanted to improve their energy efficiency process.The purpose of the essay is to describe and analyze the opportunities with support from the management control to help improving the process of energy efficiency in a municipal operation.

This thesis is performed in collaboration with Kraftpowercon AB in Surte, Sweden. Focus has been on to identify the powerlosses in one of Kraftpowercons halfbridge DC-DC converters. First theoretical calculations are made, the calculations is verified with measurements of six different operation modes. In a later stage, methods like soft switching and synchronous rectifying are proposed to increase the efficiency for the converter. To achieve softswitching for the halfbridge, the LLC resonant converter topologies are implemented and examined.

When traffic in large cities increases, it becomes more vulnerable to disturbances such as accidents, stalled vehicles or construction; therefore, traffic jams are more likely to occur. For better control of the traffic at a disturbance the Swedish National Road Administration (SNRA) has traffic equipment which can be controlled from a command centre. This traffic equipment consists of gates and signs with variable messages. This report will discuss the system used for traffic control in Stockholm. It will present proposals designed to improve it.

We have chosen to write our essay in collaboration with Varbergs kommun, where our starting point is to improve energy efficiency by management control. Their occupation separates from a pure profit driven corporation and therefore the management controls have to be adapted accordingly.  The reason why we have chosen to write an essay about the management control opportunities to improve the energy efficiency depends on two different reasons. The first reason is that we find it very interesting, how with support from the management control it is possible to improve different parts of the operation. And the second reason is that Varbergs kommun expressed a wish that they wanted to improve their energy efficiency process.The purpose of the essay is to describe and analyze the opportunities with support from the management control to help improving the process of energy efficiency in a municipal operation.

The relatively poor economy in European dairy farming might be improved from efficient feeding systems and dietary management. Increasing herd sizes and transition to loose housing systems in Sweden, increases the possibilities for other feeding systems than separate feeding that is the traditional feeding system in Sweden. Other possible feeding systems are partial mixed ration (PMR) and total mixed ration (TMR), where the TMR system sometimes is associated with overfeeding and thereby increased environmental impact and high feed cost. Diets providing nutrients above or below animal requirements are considered as unbalanced, which in turn are associated with reductions in health, fertility and milk production. On the other hand, a balanced feed ration improves feed efficiency, nitrogen utilization and profitability.

Hypothermia during anaesthesia is a well-known phenomenon that may cause several side-effects such as greater risk of postoperative wound infection and increased risk of heart complications. The most efficient way to avoid this is to prevent hypothermia from occurring. The aim of this paper was to compile the research on the most efficient way to prevent hypothermia during anaesthesia for cats and dogs, and to compare these results to how Swedish animal hospitals prevent hypothermia today. To investigate this, a survey was sent out to several animal hospitals around Sweden to see what methods they used to prevent hypothermia in their clinics. It is difficult if not impossible to prevent the body temperature from falling slightly when anaesthesia is induced because of the drug interactions in the body that follow from the drugs given. A 1-1,5°C decrease in body temperature is to be expected and is difficult to avoid.

Too high levels of noise lead to various health problems and cost society billions of SEK peryear. In this thesis we have examined a model of the A40E articulated hauler at VolvoConstruction Equipment in Braås. We have tried to reduce cabin noise in an articulated hauler,while also providing a way on how to proceed with a machine when the cabin does not measureup to the sound requirement. The best way to find leaks were with a reference source of model4205 and its speaker HP 1001 from Brüel & Kjaer in the cab and then walk around and listen towhere the reference source was more prominent. In this way, we found that the edges and theplugs were sensitive areas.

Abstract In high voltage substations there is an increasing demand for computerized equipment, and automation of operation and supervision. The future primary equipment will provide the possibility to collect more information and to provide better control for improved effectiveness. Since ABB has got a large customer target, each product must be custom made to fulfil the customers (often from different countries) demands. Later these products will be configured by engineers who may not be familiar with the tools used at ABB. This is a very expensive and time consuming.