Sök:

Sökresultat:

744 Uppsatser om Engine testing - Sida 9 av 50

Modellbaserad drivlinereglering

A cars powertrain consists of everything that is needed for its propulsion. The components in the driveline that transfer the power from the engine to the driven wheels are not absolutely stiff, hence they will wind up due to the torque and act as torsion springs. If you suddenly demand a bigger torque by stepping on the accelerator pedal, a so called tip in manoeuvre, and that torque is acquired from the engine as quickly as possible, the driveline will not be able to transfer that fast torque change due to its weakness and as a result it will start to oscillate. These oscillations will be transferred to the driven wheels and make the car to accelerate jerkily which will be experienced as uncomfortable by the passengers. Furthermore, there is a backlash in the driveline that will make the weakness in the driveline even more excited than it should have been if the backlash did not existed.To avoid too big problems with these oscillations there is a control system that controls the demanded torque.

Induktiv provning av ferritiskt rostfritt stå

The report examines the factors which may be a contributing cause to the problems that are present when ferritic stainless steel are eddy current tested in a warm condition. The work is carried out at Fagersta Stainless AB in Fagersta which manufactures stainless steel wire. In the rolling mill there is an eddy current equipment for detection of surface defects on the wire. The ferritic stainless steels cause a noise when testing and this noise complicates the detection of defects.Because of this, a study was made of how the noise related to factors such as steel grade, temperature, size and velocity. By observing the signal and with the possibilities to change the equipment settings the capability to let a signal filter reduce the noise level were evaluated.

Standardisering av funktionsblock for PLC

Automationscenter & Bråvalla Elteknik AB is a company that offers the market completed total solutions where the customer can operate and monitor their production from the terminal. In these total solutions they lack standard circuit which are developed by the company and which could manoeuvre/control/monitor controlled process objects. This report defines the work of developing the most common standard circuits.The report is initiated by a short theoretical part about PLC and the PLC system, with a connected terminal, which has been used. Thereafter, the turnout of the demands of specification is reported, after discussing with the supervisor in the course of the project. The report concludes with a disclosure of how the programming, the documentation and the testing have proceeded and a final discussion concerning the project and proposals on continuation.The result is a CD with the documentation of standard circuits and how they are implemented in a new project.

Söktjänster för akademiskt bruk: En utvärdering av Google och Argos med frågor från en akademisk ämnesdisciplin

The purpose of this MSc thesis is to examine the retrieval effectiveness of two Web search engines with queries from the academic discipline of Classical Studies. The two search engines are chosen to represent two different types Google as a broad general search engine and Argos as a specialised search engine for the subject of Classical Studies. The search engines are compared for precision among the first twenty results returned for thirty queries. In order to avoid bias in the study, the queries are based on real users' information needs. Due to the subjective character of the concept of relevance, the study is performed with five different experiments with five different definitions of relevance.

Small-worlds och rich-clubs bland bloggar : En nätverksanalys av den svenska bloggosfären under FRA-debatten 2008

Purpose/Aim: To find power structures within the blog network.Material/Method: Using keywords to find all available blog posts about the National Defence Radio Establishment from the blog search engine Twingly, and thereafter using the same blog search engine to find inlinks from other blogs, to those posts. The data is set into the context of the small-world networks models of Duncan J. Watts and rich-club models of Sergi Valverde och Ricard V. Sole.Main results: 5183 unique blogs have written about the subject in 22779 blog posts to which 28128 inlinks from other blogposts are made. Just over one fifth of the blogs are linkted to each other in one big network, where the remaining blogs stand without any ingoing or outgoing links.

Testverktyg för ett automatiserat system

Most often when developing a new system there is a need get a functioning testtool up and running. Including time, cost and resources the solution isn?t always obvious, developing your own or buy one ?of the shelf?. The purpose of this thesis is to study how a general testtool for executing functional tests should be designed to be reusable, be based on recognized knowledge and be able to fast and simple be customized for different types of systems. Key functions from the litterature is presented and used in the design of a testtool prototype.

En manualapplikation : Utvecklingen av en mobilapplikation

iProspect is a global digital marketing agency and work primarily with search marketing. They were the first search engine marketing agency in the world when the company started up 1996 in Boston, Massachusetts, and the first in Sweden to offer services in search marketing after establishing themselves on the Swedish market the following year. iProspect can be found in the södermalm office in south central Stockholm. They are a comprehensive agency within search and offer everything from search engine optimization and sponsored links to advertising on social media. They?re goal is to lead developments in search marketing and to keep ahead of competition.

Provmetod för olje- och partikelöverdrag från kompressor till tryckluftssystem

Compressed air is an energy source that is widely used in today's trucks and buses.Compressor located next to the engine supplies the pneumatic system with the compressed air and is lubricated with the engine oil. Some of the oil follows the air flow in both liquid and solid phase. The solid phase, namely the carbon particles are created due to the high temperature in the compression chamber.Oil- and particles carryover softens and destroys the rubber material in the air valves and disturbs the mechanical function of various components in the pneumatic system. In order to reduce oil- and particles carryover is an Air Processing System (APS) set downstream the compressor.No method for establishment of oil- and particles carryover from the compressor exists at the moment. Therefore the filtration efficiency of APS is currently unknown.

H2 För racing

AbstractMotor sports have been around as long as motor vehicles have been. Sports are often seen as costly polluter but in the same time the motor sports have encourages a large part of development, both for vehicles and other industries. Inventions like rear mirror and ABS brakes come from motor sports. One way to once again drive development forward while making motor sports carbon-neutral is to run the race cars on hydrogen. In this thesis, the goal is to convert a spark ignition engine for hydrogen operation.

Likvida tillgångars påverkan på lönsamhet och aktievärde : En studie av svenska företag på Nasdaq OMX Nordic Stockholm mellan 2008-2011

Objective: The study will investigate whether cash liquidity have a negative affect on profitability and share value of companies, listed on Nasdaq OMX Stockholm 2008-2011. Part of the purpose is also to show if the industry risk is of importance for treasury management of these companies.Method: The methodology for the study is key analysis through hypothesis testing and regression analysisConclusion: The liquidity ratio affects profitability in a negative direction on the entire sample. No other conclusion can be drawn..

Mjukvaruplattform för riggstyrning

Today the competition in the automobile industry is getting all tougher. The technology behind cars becomes more advanced. To get ahead of competitors car companies has to look into new areas of innovation.One important area is vehicle safety. Bigger companies have come so far in vehicle safety that difference between cars more depends on the car type (size) than the technology behind it.There is one area where vehicle safety that still has great opportunities for improvement, which is in active safety. The term active safety states that the car has the ability to identify treats and automatically respond to the treats.

Hokus Fokus - gestaltning och utformning av rum för barn i sjukhusmiljö

In this project I have worked with creating a new kind of room in a hospital enviroment for children. The main purpose of the project has been to form a secure and positive experience for the patient while visiting a specific room at the department of childrens physiologi, at Drottning Silvias Children- and youth hospital in Gothenburg.The project was based on questions like how it is possible to move the focus from the unsecure and scary, to something secure and positive, when the patient is going through an testing situation.The target gruop included a wide age span (0-16 years old), therefore I have worked with a theme, H2O, that works for diffrent ages. In the room, I have applicated the theme in different levels that is changeable depending on the age of the patient.During the project I have presented my ideas for the staff at the hospital. We have discussed their problems, what they wish in their working enviroment and how they experience the situation for the patients. I have also asked the patients how they experience the specific room today.The result of the project is a visual idea of how you can create a room, that you don?t exepect to find in a hospital..

Konstruktion av en autonom vindstation

Construction of an autonomous wind station was a project with the goal of creating a product that could collect wind data from a sensor and then transfer this data to a server wirelessly over the GSM network. The device would be powered by batteries and solar cells and function fully without requiring external power supply. This required that a small computer was constructed and programmed to store and send data at predetermined cycle times and programming of a server that received the sent data. The project also required optimization of power consumption and dimensioning of solar cells and batteries based on this. The construction of this station demanded research both for the selection of hardware and programming software. The computer was based on a microcontroller and a GSM module that sent the data over the 2G network.

Heuristisk detektering av trojaner

The heuristic methods used by the anti-trojan application TrojanHunter have been evaluated. The evaluation shows that the heuristic scan engine of TrojanHunter has a very good detection ratio and that the detection ratio can be even further improved by implementing the suggested improvements, the most important of which is a white list to avoid misidentifying files that are known not to be trojans..

Utveckling av en webbaserad donationstjänst för företag  som involverar medarbetarna i processen

In recent years, employees at large companies have started to demand that their employer should work more for good causes. The money the company wants to donate to charity is distributed mostly through a vote to decide where the money will be remitted. The purpose of this design case is to develop a design concept for a web-based donation service that involves all employees at a company. Furthermore, the authors of this study intends to explore how the motivation for employees of a company can be affected by participation in this service. In this design case, the service function, quality and concept was tested and evaluated.

<- Föregående sida 9 Nästa sida ->