Many buildings are now nearing the end of their service life. This applies to both the older houses from the 40's and 50's to the million project houses that did not prove to be as sustainable in the long run. Often there is a desire to extend the service lifetime, but to do that you need to make detailed inspections. The Folkets hus in Gävle is one of those buildings that is in need of renovation and to fulfill the new requirements that must be met in today's buildings. It is desired to make the buildings rentable space more attractive and to extend the building with two more floors.

Lansen Technology develops and sells alarm systems. The communication between the system devices are wireless. The radio protocol used by the system is developed by Lansen with the purpose to be energy efficient. The alarm systems target groups are individuals, businesses and government agencies. The current system is installed, configured and controlled from a control panel for all audiences.

Evaporation is a part of the chemical recovery department at wood pulping mills. The purpose of evaporation is to remove water from the black liquor, which makes the liquor combustible. The process is very energy demanding, and having a well-functioning model of the system is of greatest interest. The model can then be used to study energy consumption and to test different control strategies. Two models have been developed during the master thesis.

This thesis considers the use of an oldrock cavern as thermal energy storage.With a large system of differentchillers a model was created to find anappropriate future system. There aremainly two trajectories to take. Eitheran installation of chillers needs to bemade or the rock cavern can be used tomeet the future demand of districtcooling in Solna, Sweden. Additionallythis thesis investigates the possibleuse of different techniques to utilizethe phase change energy of water.Simulation shows that it?s possible toutilize the phase-change energy of afluid; however it?s not economicallyfeasible due to the thermodynamiceffects on the Carnot cycle.

My Finnish grandfather had a passion for architecture, eventhough he wasn?t an architect. In the end of the 1950s he builta wooden summerhouse on a lot outside of a small villagecalled Lempäälä, close to the city of Tampere. Today the lotbelongs to my mother. Every time I visit our summerhouse, itmakes me want to do as my grandfather did ? to build a smallhouse next to it.My project is a proposal for a wooden house on mymothers lot.

Through analysis of the work of scheduling the doctors at the hospitals of Sundsvall,Gävle and Karolinska in Stockholm this thesis presents some conclusion about howand why a computer system would benefit these very tasks. The reason for doing thisis mainly to save money through more efficient scheduling, but also to minimizeerrors and maximize comfort for scheduler and doctor alike.Scheduling consists of collecting doctors? requests, assessing the need of staff,distribute the available doctors and make sure all tasks are covered throughout thescheduled period of time. The work is often very complex and involves manyvariables ranging from competence to personal whishes and economical constraints.Solving these problems takes a lot of time and energy which could be better spentcuring patients.The conclusion of this thesis is that there is reason to develop such a system to savetime and optimize resources. A description of the system is found in numerous lists ofroles, tasks and prototype sketches which combined shape the content andfunctionality.

My questions at issue for this report has it´s beginning in the growing problems of thenegative effects of burning fossile fuels and the rapidly growing energyprices.1. Is it possible to design a micro scale powerplant?2. Is it economically interesting for a potential customer to by such a product?The aim with this report is therefor, with the help of design work and calculations, to answerthese questions and to create a platform for building a fully functional micro scale powerplant.The material used in the report is mostly product catalogs from various industries but alsostudy course littrature about steam engines.The result of the report is that it is fully possible to design a fully functional micro scalepower plant.

Abstract This degree project examines how much carbon dioxide that emits during the construction phase of a road project. This is to make it possible to compare how the amount of carbon dioxide differentiates between traditional road construction and Swepave construction, which is PEAB?s alternative way to design roads. To make the comparison a calculation tool has been produced. To compare the amount of carbon dioxide emissions a reference project was needed.

Kandidatprojektet Urban Building vid Hornsbruksgatan med undertiteln Hornsbruksgatan 2012 är ett arkitekturprojekt bestående av ett mindre antal sammanlänkade byggnationer i vilka bostäder, kontor samt kommersiell verksamhet inryms. Den övergripande volymen består av en tydligt långsmal kropp som är placerad längs med gatan. Stor vikt i projektet har lagts vid den arkitektoniska upplevelsen, materialval och beständighet. Gestaltningsmässigt har inga hinder funnits för eklektiska och anakronistiska influenser..

This Master thesis is about a postal- and telegraphic building in Eskilstuna, Sweden. The construction methods for the specific building and buildings in general from the same time are described. The purpose of the report is to describe the loads acting on the building and how it has been built and why it has been rebuilt during the years. After this, possibilities of reconstruction and adaptation for today?s demands can be evaluated.

This study deals with Swedish nuclear-energy politics from 1980 to 2006. The purpose is to trace and to explain change and stability in three political parties? rhetoric concerning the phase-out of Swedish nuclear-energy and the Swedish government?s nuclear politics. Two hypotheses based on path dependency theory are tested to analyze if rhetoric and politics are developing in separate directions. The first hypothesis is based on the idea that earlier promises from the political parties affect what promises they can make later on.

In this thesis is studied the electrical load of Paradisskolan with respect to power quality and energy consumption. The school's owner Trollhättans Tomt AB is also interested to know if they can reduce their costs by changing to smaller meter fuses. A recurring ground fault that?s been recorded from powerpanel A1A has been investigated. The school's equipped with an electrical bonding system, harmonic filters for the third harmonic currents, TN-S system from feeding transformer and groundfault monitoring.

The economic development and competitiveness in Europe is heavily dependent on an efficient transport system. Movement of goods and people is essential for a competitive industry and successful trade. As a result of an intensified transport business, consumption of fossil fuels has increased dramatically. As a consequence, there are increased emissions of dangerous greenhouse gases. Transports are often mentioned as an area with high impact on the environment.

The purpose of this study is to compare the energy related and environmental consequences of implementing optical sorting as a means of waste collection with those of reducing food waste. In addition to studying the possibility of implementing optical sorting in downtown Stockholm, the yielded amounts of energy from waste collection and reduced wastage will be calculated. This is done by way of literature reviews and interviews. The amount of energy that can be generated through optical sorting and biogas production via anaerobic digestion in downtown Stockholm is 29-44 TJ/year, compared to 118 TJ/year saved by completely eliminating food waste. The generated biogas can replace fossil fuels, but the required food waste contributes to increased greenhouse gas emissions as well as reduced bio diversity and eutrophication during the wasted food?s lifecycle.

The thesis consists in two parts. The purpose of the first part is to analyse how the court may interpret rules, principles and legal cases to decide whether a reconstructor bears liability towards the debtor and the creditors. In the second part it is discussed and argued for how the reconstructor´s damage liability should be drawn up and applied so that it according to economic theories should be as efficient as possible. In the thesis it is shown that it is not a non-contractual liability or a liability based on authority mission. The reconstructor´s liability is instead based on a commission concerning an intellectual service.