Results have shown that flow batteries may be a solution in the future as an effective and environmental friendly method to an energy storage system (ESS). The technology is reliable and has a high efficiency that comes with low energy losses and a long lifetime. The range of possible fields is suitable for cutting energy peaks in the power grid, by always have a ready and available energy storage that balances the production. By comparing the advantages of flow batteries with conventional batteries it is mainly the fact that they can conserve energy for a long time without being self-discharged thanks to that the storage capacity is in principle endless and limited by the size of the electrolytes tanks that makes them a great energy storage system. The batteries won?t take any damage or decrease in performance when charging or discharging it or if you exhausts it to 100 % and leave it discharged for a long time.

This master thesis is an in-depth study of an existing heating system at a household cooperative in Uppsala that has been converted from district heating to a bedrock heat pump system. The study focuses on an economical system optimisation of the building?s complete heating system. The aim was to determine how well a heat pump system in large buildings actually work, find out possible ways to optimize the existing system and point out important system parameters for new heat pump installations in larger buildings.The project points out a possible energy cost reduction of 45 % without investment and further cost reductions with equipment investments. A reduction by 30 % is possible by improvements in the regulation system and 15 % is possible by maintaining the brine system.

With a larger awareness of the climate changes and increasing electricity prices, Energy efficiency measures in the industry have become more common. By rationalize the activity and by the same time decrease the emission of greenhouse gases the company can both save money and reduce negative environmental impact. For the Swedish industries the electricity price have traditional been relative low, which has resulted in a considerable larger usage than other European countries. By a deregulation of the European electricity market the electricity price will level off between the countries, which will cause a higher electricity price in Sweden than we are use to. To prevent that the Swedish industry don?t lose competitiveness against the other European countries, it will require Energy efficiency activities in all different forms.ABB Sweden has decided to decrease their total energy usage with five percent in two years.

ur society is today in a phase of development in environmental and sustainable thinking. Alarming reports show changes in climate caused by our load and exhaust of resources. The energy usage contributes to a big part of it, by its emission of carbon dioxide. The built environment uses around 40 % of the total energy consumption in Sweden and requests to strongly reduce it are presented from both EU and national level.This thesis brings up the subject of green building with a focus on how we can create more energy efficient buildings in projects of new construction. Since the construction industry today often fails to pass on the knowledge between different projects, as a return of experiences, the construction company Skanska suggested the topic for this thesis.

Energy issues are constantly increasing attention in today's society. People's impact on Earth isentered in more contexts. Many discussions are about how the entire social structure needs to bestreamlined in order to achieve sustainability. The residential and service sector accounts for 39 % oftoday's total energy consumption in Sweden and the increasing electricity prices have made buyersmore interested in energy issues.There are many buildings in need of refurbishment today, including all the apartments that werebuilt in the 1970s to reduce the housing shortage at the time. 650 000 apartments of one millionapartments were built during the so-called the one million program and is currently in need ofrefurbishment.

This report is the result of a degree project in building engineering, at an advanced level. The project evaluated a building from a technical and historical point of view, and focused on its energy consumption, particularly the energy used for heating. The building in question was a small apartment building in Strömsholm, Sweden. It was made in 1902, from vertical logs, a not so common form of the traditional log house. The goal of the project was to evaluate if the energy consumption could be reduced in accordance with building preservation regulations, that is without damaging any of the building?s cultural or historical values.The building was surveyed with the help of archive and literature studies, interviews and inspections.

In Uppsala, Sweden, Vattenfall has a combined heat and power plant. On the premises there is an engineering workshop with old fluorescent and mercury lamps that need to be replaced. This provides a great opportunity to save energy and money by installing more efficient lighting. The main purpose of this study was to present two functional and energy efficient lighting systems including control system. The lighting systems were designed by investigating the working environment, measuring illuminance and by simulations in the software DIALux.

The construction industry has demands on energy use in permanent buildings. How much energy that is permitted to use during the time the building is produced has no requirements. The purpose with this study is to learn how far Skanska has come with the work of making the building site more energy efficient.A literature study has been performed in the beginning of the study to survey what energy efficient arrangements that can be applied and how they operate. Using site visits and interviews the situations on the building sites have been studied as well as the energy efficient measure that are in use.Skanska has come a long way with the work of energy efficient building sites and they keep improving. They have improved half of their cabins so they use 50 % less energy.

The Swedish pulp and paper industry meets higher demand for Energy efficiencyi mprovements with increasing energy prices and changes in the Swedish renewable energy certificate system. One action of Energy efficiency improvement is by using secondary heat, that otherwise would have been treated as waste heat, for use in a system with lower temperature demands. The aim of this Master´s thesis is to identify possible secondary heat sources in a typical Swedish pulp and paper mill and to investigate what economic benefits the secondary heat will provide when being used for pre heating of wood chips to a kraft digester.The Master´s thesis focuses on three secondary heat sources; dry warm air, warm water and moisture saturated warm air located inside the pulp or paper mill. Two types of kraft digesters are simulated within this study, a typical Scandinavian digester and a modern twin vessel steam phase digester.Due to quality aspects and low temperature level drying is the drying technology with dry warm air rejected. Using warm water in direct contact with wood chips increases the quantity of water to the evaporation plant and thus reduced pulp or paper production and is therefore also rejected.

Roughly 130 000 dwellings have been officially registered since Norway as of summer 2009 passed their bill ?Energimerkeforskriften? on energy performance certificates in buildings. The main objective is to decrease the total amount of national energy consumption by producing a methodology of calculation of the integrated energy performance of buildings as well as proposing cost effective measures to lower each building?s energy consumption. As the measures should not contravene nor be incompatible with the intended quality and character of the building, the ?Energimerkeforskriften? exempts buildings that due to their historical and cultural values are protected cultural heritage legislation. The current system offers a couple of professional certification alternatives, but when two online semi-automatic methods developed specifically for non-professionals are by far the most used, and since the methods of calculation primarily have focused on modern building materials and construction, the rest of the historical building stock stands literally unprotected by incorrect performance certificates and high-risk energy efficient measures. The objective of this thesis is to identify if the current Norwegian energy certificate system poses a threat to older buildings.

The energy use in a workshop company has been examined in this work in order to find areas for Energy efficiency improvement. The combined oil and electricity heating in the company were compared with other alternative heating systems including cooling of the premises in following combinations:Ground source heat pump for heating and coolingDistrict heating and absorption coolingDistrict heating and low temperate surface water coolingEnergy use, operation costs and carbon dioxide emissions were calculated for the current heating systems and the three alternatives including cooling. The ground source heat pump for heating and cooling decreases bought energy with 34 MWh annually compared to current heating only. The district heating and low temperate surface water cooling has the largest reduction of operation cost and carbon dioxide. The operation cost decreases with 42 kSEK and the carbon dioxide with 43 metric ton CO2 annually.

In today?s modern age, energy consumption has become a major issue, both from an environmental viewpoint and cost perspective. Because of a rapid technologic change and increased costs of production of electricity, the demand to develop effective methods for Energy efficiency industries have grown.The electricity-intensive industries, such as plastic industry, the demand to reduce energy consumption has grown significantly over the past 10 years, which have led to the development of different methods to determine and locate energy-consuming parts in the industry. This also means being able to prioritize and organize activities in the industry.In this study the measurements of voltage, current, power and PF performance on injection molding machines (K-TEC 275 form Ferromatik Milacron in Germany) with a focus to locate, within a machine, various measures that could improve energy use in the plastics industry, in this case RostiGP in Gislaved. These measurements have been carried out with the help of a power quality clamp meter to carry out time logs of the machines for some time during normal word rate.

This study has been carried out in the spring of 2014 on behalf of PQR Consult AB in Stockholm. The aim of the study has been to analyse the energy usage of the building Skarpövägen 1 in order to explore the possibilites of saving energy by using appropriate equipment. These possible solutions have been simulated by using the programe IDA Indoor Climate and Energy, combined with a life cycle cost analysis. The laundry building, Skarövägen 23, has also been analysed due to its high amount of energy usage. The result of the energy analysis showed that the energy usage was much higher than the energy declaration.

AbstractThe Municipality Council decided in 2010 to develop a comprehensive Energy efficiency strategy with financial and methodological support from Energimyndigheten (The Swedish Energy Agency). The strategy should include 3 major parts: an inventory of the 2009 energy use defining the current situation, the 2014 and 2020 goals for energy use, and an action plan for goal achievements. According to Energimyndigheten, the strategy must include all municipal administration premises, vehicles, and all majority-owned companies (as Laholmshem, the municipal housing company).The report describes the inventory work in order to obtain the 2009 energy use and the sources of information used. The inventory values are used as the base year values for the 2014 and 2020 goals. The inventory showed that information about the vehicles is dispersed in the municipal administration and no clear structure exists with respect to mileage and fuels used.

pelago. There is an old inn that is located on the island that has become a very popular attraction in the last couple of years. The inn has both a well-known restaurant as well as conference facilities that are used by tourists as well as the people of Stockholm over the summer months. The inn was built 1908 and has since remained in the same condition.make islands in the archipelago more environmentally friendly and promote sustainability. One of their project islands is Grinda.