This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

In order to reach the environmental targets, set up by the EU, there are many measures taken to make Sweden more energy efficient. In the housing and real estate sector, an installation of an exhaust air heat pump that reuses the heat in the exhaust air in order to lower the amount of acquired energy, is an example of such an action. The recovered energy can then be used for heating of radiators and tap water. This report aims to evaluate and compare three different systems using exhaust air heat pumps regarding COP, degree of coverage and cost savings. This study was delimited to only account for apartment buildings.The theory chapter describes the different conditions and factors that affect a building?s energy balance.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

This diploma work has been carried out in collaboration with the building contractor Sh Bygg Fastighetsutveckling AB in Uppsala with the intention to investigate how the height of a building affects various energy aspects such as transmission losses, infiltration, and the specific energy usage. Three different reference objects have been studied. The reference objects have been simulated for four different heights in the calculation program VIP-Energy.The results show that an increase in floor number can lead to both advantages and disadvantages. As the number of floors increases, transmission losses per square meter floor area decreases. However, as the height of the building increases, the reduction rate decreases.

An increased awareness about the global warming has created a demand for more information on how the climate is affected by different activities.This master thesis was initiated by Tricorona, a Swedish company that offers its customers analysis and calculation of their climate impact. Tricorona also supplies climate neutralisation with CERs, in accordance with the Kyoto protocol and controlled by the UN. This work demands updated emission factors for greenhouse gases. An emission factor gives information about the greenhouse gasintensity of a service or a product [kg CO2-eq./ functional unit].The purpose of this thesis is to examine how electricity, district heating, hotels, taxis, food and materials affect the climate and how emission factors for these areas can be calculated.This was done by reviewing and comparing different studies and by interviewing experts. The information was evaluated and recommendations on calculations and emission factors were made.The consumption of energy is the main source of greenhouse gas emissions for district heating, electricity, hotels, taxis and materials.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

This project investigated the current market regarding wireless net and the communication between the tools used for diagnostics/maintenance and an embedded system. Based on documentation obtained through interviews a demo system was created based on Bluetooth Low Energy (BLE) communication between an embedded system and an Android device.This report intends to describe the tools and methods used in the design of the demo system and the result of an analysis of the BLE communication.Bluetooth Low Energy is an exciting protocol with wide applicability within the industrial field. This project investigated the communicational possibilities between a Smartphone and a Raspberry Pi and based on the results that emerged the conclusion can be drawn that BLE is a protocol with many beneficial applications within industrial IT..

The purpose of this master thesis is to investigate how nearby forests affect the energy production in wind turbines. To reach the purpose a case study is performed on three wind turbines sited on a field in a north-south line at Andersfält in the municipality of Halmstad, Sweden. Approximately 100 meters south of the southern wind turbine a forest is situated. The case study is divided into three sub studies where the difference in energy production, the affect of the forest and a wind meteorology model, WAsP, is studied. The result show that the forest have a significant influence and that the WAsP-model gives an incorrect result of the energy production in wind turbines sited near a forest..

På uppdrag av Sweco Systems i Umeå har detta examensarbete utförts under våren 2013. Syftet var att undersöka huruvida något av de energiberäknings-program som används på företaget kan anses vara lämpligt vid energikartläggningar av befintliga fastigheter.Inledningsvis utfördes en energikartläggning av fastigheten Odin 12 i Umeå, som i huvudsak utgörs av gallerian MVG. Med resultaten från denna energikartläggning som grund beräknades därefter fastighetens energianvändning i två olika program ? VIP-Energy och IDA Indoor Climate and Energy.Resultaten från den inledande kartläggningen visar att fastigheten har ett lågt behov av fjärrvärme, vilket förklaras av fastighetens höga elförbrukning. Den stora användningen av el genererar stora mängder internvärme som, förutom att sänka fjärrvärmebehovet, även medför att fastigheten under hela året har ett kylbehov.Utvärderingen av de två beräkningsprogrammen visar att VIP-Energy är ett lämpligt program att använda vid energikartläggningar.

This study concerns the energy future of the county of Stockholm up until 2050 and describes how the energy consumption can be compared to today with the use of scenario methodology. Within energy future studies the backcasting approach is well known and has been put to use in this study. Due to the characteristics of backcasting the study is self-fulfilling, i.e. the future energy scenarios presented in this study satisfy the targets set up in this study. In the light of what may be the largest challenge of our time ? the climate change - the aim of this study is to describe how the energy consumption in a fossil fuel free Stockholm county in the year of 2050 may be.

The purpose of this study was to investigate the association between physical activity and perceived stress, energy and musculoskeletal disorders among office-workers and warehouse-workers and also to see if there were any differences depending on work-place and gender. The method that was used to collect data was three different validated questionnaires that measured stress and energy (the Stress-Energy questionnaire), musculoskeletal disorders (intensity and localization of pain, a Pain Drawing questionnaire with a VAS-scale) and physical activity (IPAQ ? the short version). Eighty-eight workers participated in the study. Forty-seven of them were office-workers and forty-one were warehouse-workers.

To be able to handle tomorrows need for limited energy consumption we need to reduce our use of energy. The building sector stands for around 40 % of all energy consumption in the society. The government has put up a goal to reduce the energy consumption in our buildings with 20 % by year 2020 and 50 % by year 2050 compared with year 1995. To be able to do reach that goal we need a more energy efficient building stock.The main part of the energy used in our buildings is used for space heating. By installing ventilation systems with heat recovery on the exhaust air it is possible to use the heat-energy in the exhaust air to warm up the incoming air.

The harmonization within EC Company Law has been relativley successful. Despite its relative success; important differences still remains in European company law.The freedom of establishment itself, and the ECJ?s interpretation of the freedom provides European companies with a substantial cross-border mobility. As a consequence of this mobility, together with the differences in national legislation; mandatory rules in company law can be easily evaded. A typical example of this is that a Swedish enterprise, by running their business through a British private limited company, can escape the Swedish legislation on capital contributions when forming a company with limited liability for its members.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

The purpose of this study has been to investigate advantages and problems with distributionsystem metering in substations. This report is a study in cooperation with Göteborg Energi.The analyses in this report are made for GENAB, a subsidiary company of Göteborg Energi.To analyse advantages and problems in advance is interesting information for GENAB. Theresult of the report could be based upon whether installation of metering in distributionsubstations will be implemented and in that case which kind of measurement that is relevant.The most relevant and strategic place to implement measurement is at the distributionsubstations on the secondary side (400V), this is due to the placement of the currenttransformers. The measurements in this study involve current, voltage, power, power factor,temperature, energy and power quality.Measuring instruments that are relevant to implement are intended to measure current,voltage, power, power factor, energy and, possibly, power quality in the same measuring unit.It is desirable to have a measuring instrument that measures both energy and power qualitybut since it is most often a cost question, it can be established that energy meters have a lowercost.Metering in distribution substations gives a better illustration of the power network. Thisresults in many advantages for GENAB.