In this thesis a number of energy saving methods for a multiplier on algorithmic level are investigated. For the investigation a multiplier is constructed in VHDL, after which the circuit's performance is investigated. A number of techniques for reduced power consumption are introduced in the circuit and are then evaluated. The conclusions are that all investigated methods, pipelining, interleaving and voltage scaling, should be maximally made use of in order to minimize the power consumption..

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

To fulfill the climate target that EU and the Swedish government have decided to apply, it becomes increasingly important that the energy efficiency of existing buildings and making new buildings energy efficient as possible. Of Sweden?s total energy consumption in 2011 was 40% used by residential and service. Of the 40% of the energy consumption was 60% used for heating and domestic hot water. A report from year 2012 shows that one reason why the heating volume is so great could be due to underestimating on the energy consumption for the heating in the planning of the building.

Feedback tools support electricity users within the Swedish residential sector to increase their knowledge of electricity and the electricity market as well as to become more aware of their electricity consumption, which in turn encourages a reduction and an increased flexibility of electricity use. The primary aim of this study is to identify and analyse how existing feedback tools can be improved, to ensure that they contribute efficiently to the achievement of the EU objectives congruent with a more sustainable energy system in 2030, emphasizing: greenhouse gas reduction, increased energy efficiency and an increased share of renewable energy. In order to reach the primary aim of this study, existing feedback tools have been identified and mapped and interviews with feedback tools providers have been conducted. The study is limited to three research areas: the practical functions of feedback tools, available technology and the use of feedback tools.The use of more efficient feedback tools will provide an increased success rate for energy management, which includes both behavioural changes and energy efficiency. According to the results from the interviews conducted for this study, an increased use and user frequency is important to utilise the energy management potential.

This thesis is based on a case study for the real estate manager Mimer in Västerås. Mimer provides a great deal of this city?s rental apartments. Many of their buildings have ventilation systems with a type of heat-recovery called ?heatpipe?.

The aim of this study was to quantify the productivity and the costs of different harvesting systems (teams), containing harvesters equipped with accumulating harvester heads and forwarders, in first commercial thinnings were an integrated harvest of pulpwood and energy wood were performed. In the beginning the plan was to study and measure 20 sites before and after harvest. Due to storms during the summer of 2010, complete data could only be obtained from 8 of these 20 sites. Seven of these sites were privately owned and one was owned by UPM, all of the sites had been pre-commercially thinned. The mean stem density before harvest was 2578 stems per ha and the mean stem volume was 0.074 m3solid over bark.On average 1518 stems/ha was harvested.

In this essay, we have compared a conventional house to a passive house. The housesshared the same local conditions; they have the same living area and the same layout. Thedifferences between the houses were the different construction solutions for the roof, theouter walls, the floor and the heating system. Both the houses qualify the standards fromBBR and the passive house also lives up to FEBY?s special conditions.The purpose with the essay was to examine if it really is profitable to build small hoses aspassive houses.

This thesis provides a good introduction to the American environmental certification system LEED, Leadership in Energy and Environmental Design, and trough compar-isons between Sweden and the United States an explanation to the systems design is given. The work is closely linked to a LEED Core & Shell project in Stockholm, Swe-den, where the goal is to reach the second highest rating in LEED - Gold.This thesis gives a broad description of the LEED system and a more profound study of the energy sector, Energy and Atmosphere. Here, for example, an analysis has been made of how the energy consumption of an imaginary building designed according to the requirements of the BBR (Swedish building code) performs in comparison to the Baseline building in LEED.The existing model of Borgarfjord 3, which served as a case study in this work, has al-so been modified to investigate the energy savings that could have been achieved by adding extra insulation to the building. A description of the problems, regarding how the Swedish district heating system (DES) is treated in LEED, is given as well as the suggested modifications. This is an issue that will be pursued during the process of shaping a new, international, version of LEED due to be launched 2012..

SAPA´s resource of waste heat is the basis for this thesis to investigate the possibility of energy assets in their cooling water and possible uses for it. The energy in the waste water is greater than the current need which has three uses which are (1) heating the factory, (2) converting liquid propane to propane gas and (3) local domestic heating. The average energy load that is available is 1, 7 MW and the average temperature in the cooling water is 41°C. The total energy load at dimensioning out side temperature is approximately 1,6 MW for the three current uses. The temperature is currently too low to be used directly in the existing systems so an upgrade is needed.

The hospital in Varberg has a somewhat outmoded solution regarding the state of preparedness in its water sustentation. Today?s solution is both cause to a number of mishaps and high energy consumption.The report is initiated by looking into the present situation to get an insight to the problem.Today?s media depletion is measured and analyzed.Furthermore, it also looks into some earlier performed studies. These studies are followed up in order to see if measures have been taken.The report presents a number of arrangements which should be taken, amongst those a minor re-build of the current solution and a number of arrangements which leads to decreased water consumption..

Abstract The extraction and usage of energy give rise to immense environmental problems which helps to accelerate climate change. Energy is an important resource for the community and there are a variety of different types of energy sources available, that are either classified as renewable or non-renewable energy sources. The usage of renewable energy sources cause less environmental impact than the usage of non-renewable energy, which in turn means that the energy?s strain on the environment is strongly affected by the type of energy source used.The aim of the study is to describe to what extent attitudes towards renewable energy are affected by whether the individual is male or female, by examining the hypothesis regarding how women have a closer connection to nature and to a larger extent shows on an pro-environmentally friendly behavior than men, and if it also can be detected on issues related to renewable energy and thus imply that women have a friendlier approach towards renewable energy than men. A number of ecofeminist believe that women have a stronger bond with the nature through her embodiment as a woman and by her maternal role, which according to previous research also leads to the fact that women shows on a more extensive environmental behavior.Through a qualitative research method in the form of semi-structured interviews has three female and three male respondents been asked questions with regards to the environment, individual responsibility and energy.

Shopping for groceries often means that, as consumers, we travel to the grocery store ourselves, by ear, bike or on foot. At the store we pick out the groceries that we want, go the register and pay for them. During the last couple of years consumers in Sweden have been given the opportunity to let someone else select and transport the groceries to their home instead, so called home shopping. As this report is being written, the possibility to buy groceries this way is somewhat limited, but many forecasters believe that in the near future it will increase immensely. Because of the large volumes of groceries that are being transported, there is great transport work being done in the supply chain.

The purpose with this report is to examine how the implemented energy efficiency measures on Bokelundskolan in Växjö have had impact on the energy use. The measures which have been implemented are, new ventilation system, new heating system, optimized adjustment of the heating system, new windows with U-value 1.2 and lower window height, insulation under windows and in the crawl space. The school's energy use before and after rebuilding has been calculated with the calculation program, Vip-Energy 1.5.5.Calculations of energy use for the school with windows on U-value, 0.9 and 0.7 have also been done. The replacement of windows has been studied from a cost perspective. The conclusion is that the exchange of heat and ventilation system was the biggest contributor to reduced energy use on Bokelundskolan.

In today's society, the availability of energy plays an integral part in our everyday lives. Unfortunately, the price of energy in Sweden has increased in recent decades. A large part of our energy consumption goes to heating modules for houses, where heating methods that depend on energy sources such as electricity, district heating, fuel oil, gas and biofuels are the most common ones. During the winter period, the increase in energy costs becomes significantly evident, especially for small property owners. This increase in energy cost is most noticeable for home owners with electric heating.This thesis is written at the Halmstad University, in cooperation with a company, which makes parts of this thesis confidential.

The number of people in the world and the urbanization increases. This leads to a bigger need of space for the built environment, space that soon doesn?t exist. A large portion of humanity?s energy disposal is used for heating of buildings.