With the globalization, companies in the West chose to shift production to developing countries to cut down costs. This had a major impact when child labor and very poor working conditions in these factories were discovered and led many companies to take responsibility for their suppliers and the employees by adopting voluntary so-called Codes of Conduct.There is a subtle balance to enforce improvement of working conditions for employees at suppliers´ factories and to keep costs down. On the one hand, companies would like to conduct extensive audits at their suppliers to ensure code of conduct compliance and thus protect their legitimacy. On the other hand, audits are expensive so companies would like to minimize audits to keep costs down. Companies thus have to strike a delicate balance in relation to how many and what suppliers they choose to audit.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

This master thesis was a subtask of a project called EMIR-1. The goal with the thesis was tobuild a system for particulate mass measurements in one of the engine test cells at KTH. Theparticulate mass measurements are planned to be measured with a TEOM.The exhaust gases must first be diluted with air before the sample is sent to the TEOM.Therefore an ejector diluter for this matter also was designed and evaluated in the thesis.Emissions measurements have been done both with and without dilution to determine thedilution ratio. Tests have been done for different speeds and loads.Problems with stability of the dilution ratio have been an issue throughout the process andpressure pulsations in the exhaust pipe are believed to be the cause. More tests have to be done tomake sure that this is the problem.One idea is to make the inner diameter of the diluter nozzle smaller and see if it changes thedilution ratio stability.

Work-Life Balance (WLB) is defined as the ability to manage both work-life and non-work life successfully. WLB can be evaluated by examining individual?s experience of Work-Family Conflict (WFC) and Family-Work Conflict (FWC), both of which can be assessed by a questionnaire developed by Netemeyer, Boles and McMurrian (1996). The aim of this study was to explore if responses to the questionnaire, the amount of time spent on studies, household chores and sick leave, were gender related or not, among civil-accountants students. The survey included 138 respondents (74 woman and 64 men).

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

In this thesis an energy analysis of ethanol production at the ethanol plant of Lantmännen Agroetanol in Norrköping has been performed. The ethanol plant has been studied in combination with Händelöverket, the combined heat and power plant which provides the ethanol process with steam. The purpose of this study was to determine the energy consumption for the whole production chain from grain to ethanol. The analysis has included the energy consumption for cultivation of grain, production of chemicals, the production chain for wood chips, the steam production and the ethanol plant. The grain and wood chips are both considered raw materials there for the energy content in these are not included as energy input in the system.

This study is about how a swedish brand within the food industry that experiences a crisis following a product failure. It focuses on three areas following the crisis and these are crisis management, recovery strategies and brand management. This study seeks to explain how these areas interact in relation to massive exposure to mass media and how they interact restore the brand's potential loss of reputation. This study was conducted as a case study with a deductive and qualitative approach. The data gathered to this study was mainly based on newspaper articles and complemented with semi-structured interviews with twelve local retailers of the brand..

Coreträning består av statiska och dynamiska övningar för bålmuskulaturen. Syftet med studien var att ta reda på om det fanns ett samband mellan bålmuskulatur och balans samt om en träningsperiod med Coreträning kunde påverka balansen. En litteraturstudie har gjorts där åtta artiklar granskades. Dessutom bestod studien av en empirisk del där nio försökspersoner fick sin statiska och dynamiska balans testad före och efter en 4-veckors period med Coreträning. Som mätmetod användes unilateral stance test med NeuroCom® Balance Master® 8.03 och dynamic balance test med Biodex® Balance System.

Work-life balance är ett ämne som det har forskats mycket om de senaste åren. Denna undersökning har applicerat de befintliga teorier som finns inom work-life balance och relaterat dessa till yrkesgruppen sjuk- och undersköterskor. Denna yrkesgrupp är intressant då det för närvarande råder brist på sjuk- och undersköterskor på dagens svenska arbetsmarknad. På grund av denna brist ställs denna yrkesgrupp på höga krav både vad gäller flexibilitet och tillgänglighet. Denna undersökning har redogjort för de samlade teorier som finns inom work-life balance, flexibilitet och tillgänglighet.

Following is a study of fathers 'experiences of balance between work and home life. The method the researchers used was based on qualitative interviews aimed at describing father?s own experiences and values, which affects them. The researchers chose to specifically study situations where the fathers were faced with situations where their children needed to be cared for in the home because of a cold or similar illness since this is a situation that directly affects the time that was meant for work, but now risk being moved to areas of life that the researchers define as home life. This is to see whether the respondents felt that this situation affected the balance between work- and home life.

I approach the subject of adult readers of young adult fiction through an analytical framework influenced by Cultural Studies, implicating that young adult fiction is caught up in a system of distinction between popular literature and high literature. I contrast this with theories that suggest that there has been a loosening of this hierarchy and that they now coexist, even borrowing features from one another. I also examine questions of ideology, namely the ideology of mass culture, the ironical attitude and the ideology of populism. I also use Andreas Huyssen?s theory of mass culture as a woman, seeing as popular literature often tends to be categorized with feminine traits.

At Degermyran landfill, situated in the municipal Skellefteå, a leachate treatment system was installed in 2005. One of the aims of this study was to investigate how well the treatment system works by using data from chemical measurements made on the leachate before and after treatment. Further this study had the purpose of investigating how the predicted climate changes of the 21st century will affect the amount of leachate generated at Degermyran by using a modified version of Thornthwaites water balance model. The treatment system has the ability of reducing manganese by 90 %, nitrogen by 73 % och TOC by 79 %. By the turn of this century the amount of precipitation that percolates the waste at Degermyran will be between 254 and 298 mm, depending on the amount of greenhouse gases that will be released in the future to come.

The purpose of this thesis has been to develop a tool for modelling and simulating the nuclear plant Ringhals 3. The model should be used to improve the knowledge on the dynamics of the plant. Ringhals 3 is being upgraded to produce more power and a tool for analyzing the new operating conditions is needed.The work in this thesis has consisted of improving and developing an existing model of Ringhals 3 made with the modelling tool Dymola. The model has been validated by comparing the results of a simulated house load transient with data from the actual plant. Validation shows good agreement with data from the real plant.