AbstractThe indoor environment affects the human performance. Noise pollution, poor lightning and coloring are some of the factors that affect our work performance. The human is also affected by the air change and temperature, these factors are in most buildings possible to adjust and through this make economic savings. To find out about the indoor environment in the O-building a questionnaire was handed out, measurements/surveys and an interview was also made. 108 questionnaires where handed out to employees and students.

The report begins with a general inventory of possible technical faults in a hydropower plant and of possible fault indicating measurements. Then an investigation is made concerning a few different faults. Based on this investigation a choice on seal box condition and water leakage is made as problem for a more thorough examination, in which it is concluded that the turbine water leakage is larger when the turbine is put into operation. The examination ultimately results in a computer alarm for faults related to the seal box. Finally a few things are mentioned about flow measurement and pressure measurement in relation to the project as a whole..

ABSTRACTThe discussions about energy use have increased year by year everywhere in the society, and so also in the healthcare sector. But what is actually energy use in a hospital facility, and what affects it?The typical way today to express the energy use is in kWh/m2. The problem with a key performance indicator that is expressed as energy use in relation to a specific area is that it does not take into account the activity in the building. Even though the activity to a very high extent affects the energy use.

The energy consumption in the sectors of residential and public buildings is 40 % of the total energy consumption in Sweden. The main part, 85 %, of the energy use in these sectors is for operation of the buildings. The rest is used in the building process. When energy-efficiency measures are taken the energy use during the operation time decreases and the fraction of energy consumption during the building time increases. This project is carried out in cooperation with JM AB and concerns the energy use during the building time of production of blocks of flats at the building site.The main part of the electricity that is used during the production of apartment buildings goes into the heating of portacabins and illumination of the building during the construction phase.

Projektet behandlar det sublima i relation till arkitektur; både som händelse, diskurs och institution. Genom ett event som dynamisk förskjuter arkitekturens parametrar och sätter dessa i kontinuerlig förändring i relation subjekt-tid och objekt-rum. Ett gränsöverskridande erfarande av arkitektur..

The competitive nature of the automotive industry has always implied a necessity to improve product development concerning time-to-market, cost and product quality. As capacity of computer-aided engineering (CAE) tools has evolved, so has the strive for simulation-driven design. Virtual durability testing using full vehicle models is one of many challenges posed in front of vehicle manufacturers when computer simulations are given a key role in product development.This thesis has been initiated as a preliminary step towards implementing dynamic virtual durability testing in the development of buses and coaches at Scania. The objective has been to assess the predictability of a full vehicle coach model and to what level of precision structural loads can be predicted. Previously performed proving ground testing of a Scania Touring coach has been the basis for the modelling and simulations in this thesis.A virtual model of the Scania Touring coach has been created in multi-body simulation software package MSC.Adams.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

The development of solar photovoltaic (PV) is increasing,with declining module prices and with a strongenvironmental profile. Policies are developed around theworld to achieve the targets set for renewable energy.In Helsingborg, the local power company Öresundskraft isworking with solar PV to achieve the goals of the city.With their vision: - Energy for a Better World and Powerfor the Region, their work with developing the local solarPV market is continuing and the next step is to create asolar PV policy. Today their offer is 1 SEK/kWh for theexcess electricity delivered to the grid.It turns out that compensating the customer is a vitalpolicy and it has to be dynamic to follow the decisions ofpolitics. The same survey shows indeed, thatenvironmental and technical part is of interest. Solar PVwill be supported locally to act on environmentalsustainability and locally produced electricity and withthis Öresundskrafts vision will be achieved..

Today there are commercially available databases with active features, i.e. active mechanisms are available for development of information systems. But the usage of active mechanisms is low in practice. This is due to the insufficient methodological support in analysis and design for developing ECA rule based software. It has been proposed that one of the most suitable ways to tackle this problem is not to develop new methods but to extend existing methodologies.In this thesis an extension of the Object Modeling Technique (OMT) is developed, called OMT-A, which is able to model active rules.

This master?s thesis describes the development of a model of the catalystsystem aiming at control by an MPC. A well functioning model, which is suitable in control purpose, is important while emission legislation become more and more hard to fulfill for the car manufacturers. Much research has been done in the field of physical modeling of the system, but in this work a linear adaptive time discrete ARX-model is developed and validated.The systems tendency to change its dynamic during usage implies that the model must be adaptive. The developed model proved to be well functioning and shows promising conditions for the MPC design.

The purpose of this study has been to examine how the media presents policymakers from a gender perspective. We have made an analysis on the basis of genderdichotomies. We have studied images from the Swedish newspaper Svenska Dagbladet as well as the French newspaper Le Monde in order to achieve a greater understanding in which way the both medias contributes to the reproduction of gender in the media.The conclusion of the study has shown that the gender system is somewhat confirmed by the way in which men and women are presented in the medias. Men are presented with more traditional gender related associations than women who is shown in a more dynamic constellation, this is mostly evident in the Swedish newspaper Svenska Dagbladet..

This thesis work is executed at Business Unit Ericsson Test Environment (BETE), in Linköping. BETE is the department at Ericsson, which is responsible for the operation and maintenance of the company's Operations Support System (OSS). Their management system was outdated and they wanted it to be updated and it also required new features. The database needed to be replaced and the data migrated to a new database without licensing costs. The system also needed a part where employees could manage existing users.As a programming language PHP was chosen for its dynamic possibilities, platform independence and good support for database intergration.

I denna rapport redovisas modellbyggande av ett aktivt stötdämpningssystem till en formulabil. Stötdämparna som har använts i modelleringsarbetet är av MR-teknologi (Magneto Rheological). Dämpningskaraktäristik för MR-dämparna har tagits fram genom tester samt databehandling med mjukvaran Matlab. Genom användandet av modellerings- och simuleringsprogrammet Dymola (Dynamic Modelling Laboratory) med dess olika komponentbibliotek har flera delmodeller skapats för stötdämpningssystemet. Dessa modeller är baserade på fysikaliska relationer och de sätts sedan samman till en hel modell av systemet.

This report describes a synchronous machine model with magnetic saturation in d-axis, neutralconnection and electrical exciter interface for the transient simulator PSCAD/EMTDC. It hasbeen designed and verified in comparison to the regular machine model in EMTDC.The performance of the model is very good when incorporating a linear as well as a saturatedmagnetising inductance. The dynamic deviation is only thousandths to ten thousandths perunit. By using a cubic interpolation of the saturation curve, the model gives a good representationof the saturation effect. The open source code implementation of the synchronousmachine model gives the possibility to easily adapt the model to specific requirements.The derived model makes it possible to simulate a synchronous machine with its excitationsystems, e.g.

In today?s consumption society, the image and core values of a company have become more important in order to secure the attention on the market. All entrepreneurs have to distinguish themselves in the extremely tight competition.This thesis examines how product photos can reach out to the consumers successfully. Both students have previous experiences from model shoots ? but now want to study the possibilities to sell a product without a human model.The purpose of the thesis is to examine how to convey core values by commercial product photos - how to best capture the attention of a customer.