The aim of our Master´s thesis is to investigate the development of the different libraries in the former communities of Flisby and Lofta during the former part of the twentieth century. We ask the following questions:How did the libraries in Flisby and Lofta develop between the years of 1905 and 1952?How can we understand the libraries? dependency of funding of different kinds? We have used case study as a method, and we have adopted a source criticism approach. We have mainly used our local archives and among other things we have investigated various sorts of protocols, annual reports, auditor?s reports and the accounts that were sent to the Board of Education.

What traces of their actions are the Building Corporations in Sweden leaving in their archives and are they followingsome archival policies? This thesis is trying to answer that question. For that reason 25 archives fromSwedish Building Corporations have been investigated concerning their size, contents and age. Furthermore apoll performed by the Swedish National Archives in cooperation with the Swedish Employers? Confederationhas been analyzed.

Our study aimed at gaining insight of co-workers experiences of different factors that affects the verbal communication and leads to dialogue and misunderstanding between co-workers and their managers. The empirical material was gained from semi-structured interviews with co-workers at various departments within the same organization. We used a hermeneutic interpretive approach and our data was analyzed concerning different factors affecting communication. The result has been interpreted using the theories of deliberative conversations and dialogue competence. We have also used Illeris theory of learning. The result shows a number of factors that affects communication between co-workers and managers.

The purpose of this thesis was to investigate different methods do measure velocity of pistons in pneumatic cylinders at Bosch Rexroth Teknik AB. Through information of velocity the adjustment of a cylinders damping can be done easier.A future transducer will be used by salesmen, service personnel and customers. This requires a sensor that is easy to apply and use. It is also desirable that the sensor is cheap. A number of possible methods to measure velocity have been presented.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

The aim of this study was to examine if an organisation that strives for democracy and participation, also possess an open information culture. This study deals with the information culture in a social movement organisation, Attac Gothenburg. To achieve the aim, following questions were asked: What is the organisation culture like, is it open or closed? What is the information culture like, is it open or closed? What is the information culture like, in relation to the identity of the organisation? The focus has been put on earlier research in social movements, organisation and information culture. In this qualitative study I have collected material mainly from interviews.

Our social lives and where we live shape our choices in life. One of those choices is which party we vote for in the general election. The aim of this thesis is to see if there are any connections between the Swedish general election of 2010, demography, socioeconomic factors and geography. This is done with regression analysis and chosen variables. Another aim is to see where in Sweden the chosen variables aren?t enough to explain the results of the election.

The report aims to investigate how well a certain type of affordable embedded single board computer can hold up against today's more expensive computers in a computer system by doing various tests on a system with the specified requirements. The system has a Raspberry Pi as the single board computer which task is to control a camera based on coordinates obtained from a server as well as capture and stream a video signal on a network.The researches were conducted to check how much network traffic a single-chip computer sent in different video formats and how much CPU utilization was required. Studies were also made to ensure the accuracy of the camera control. The researches have been experimental, where several tests have been performed and analyzed.The results show that a sufficiently good accuracy can be obtained from the camera steering unit, in which two different servos have been investigated. When the video format MJPEG and H.264 are used, the single-chip computer is able to transmit a video signal up to 1280x720 at 15 fps.

The aim of this project was to look into ten small sewer systems in the municipality of Laholm, in Sweden, in order to work out common assessment grounds for them. The sizes of the systems for purification of wastewater were within the range of 25 to 2000 population equivalents. Our method was to study literature, the laws and regulations applicable and the files at the municipality. The conclusion is that every sewer system is different and every situation is unique. We concluded that based on laws and assessment grounds sewer systems equal in size and pollution load ought to have similar demands attached to them.

Aim:The study's aim is to examine whether and to what extent elementary school pupils aged 13 and 16 report that they ever have been forced to leave home by parents, have run away from home voluntarily or have seriously considered doing so. The aim is also to illuminate which circumstances contribute to these break-ups. Method: A quantitative approach is used; a survey material consisting of 1193 questionnaires is analysed. The data material has been used in earlier studies but the issue addressed here has not been studied earlier. The circumstances analysed are gender, ethnicity, the parents? religious belief and education, living conditions (sharing home with both parents, one of them or none), contacts with professionals (psychologist, school nurse or curator), physical and mental wellbeing, way of upbringing (liberal vs authoritarian) and communication with parents.

Abstrakt The yield curve as a forecasting tool for inflation has been thoroughly investigated. However, most of these studies considered only the major economies, such as the U.S. economy or the major European economies and not a small open economy such as the Swedish. The Swedish economy should be much more affected by the world economy then the bigger economies. The purpose with this study is then to investigate whether the Swedish yield curve, or the Swedish interest rate, can be used as forecasting tools for the Swedish inflation.

This paper exemplifies how the physical environment affects clients? experienced service quality and how companies work with the physical environment. In the empiric study, we conducted a case study and studied two hairdressing saloons. The study showed a connection between physical environment and experienced service quality in the business of hairdressing. Owners of hairdressing saloons perceive that a combination of the personal meeting and the physical environment influence the clients? general impression and their experience of quality.

The purpose of this Masters thesis was to examine women printers conditions in Sweden from 1483 to 1883. Women printers usually inherited their printing businesses from their husbands. We wanted to examine the circumstances surrounding women printers, how they managed to keep their companies and for how long. Of these 108 women we also wanted to focus on one in particular, Mrs Fougt. Mrs Fougts ownership of Kongl.

A substation must be properly protected against lightning and other external effects to the equipment in the station or staff, for that we use relay protection. They should also protect against internal errors which may occur as ground faults. There are different types of protection relays, but most common are overcurrent-, distance-, residual current- and differential protection.The purpose of this thesis was to deepen our knowledge of relay protection and to use the theoretical knowledge we got from the university studies in the work process. In the process we discovered which parameters were the most essential and calculated these for all relay protections on the substation. We also carry out a comparison between two brands of relay protection, ABB and Alstom.During our work we will test and simulate the over-current relays in a program called NEPLAN, the program will also calculate the fault currents.

This degree project handles acoustic measurements of the heat pump EcoAir 107, made by Enertech CTC AB. The sound from the three sound sources of the heat pump, fan, compressor and four way valve, have been measured to find out how they affect the total sound level of the product.Measures to attenuate the sound level have been developed and tested. By comparing these with the sound of the heat pump, in its original state, we have found out the measures which have best effects.The best attenuating measures came to be: taped openings and holes around the compressor space, isolating the top and the bottom of the whole construction, support of the fan bottom part and shielding of the sound source with a screen at a distance of 110 mmThese measures have been tested together and an average attenuation of the total sound level with 3,9 dB have been accomplished. In the front of the fan where the continuous sound is the strongest, the attenuation was 4,7 dB.This project is meant to be used as a guide by Enertech CTC AB:s during their future developing process..