It is statutory that teachers shall document their student's development of knowledge in different subjects. The teachers employed by Sundbybergs municipality have been commissioned to do the documentation in the web-based electronic system Projekt- och Omdömesdatabasen, P.O.D.B. The purpose of this study was to investigate witch effect the IT-solution P.O.D.B has brought for the teachers in their task of student documentation. By conducting interviews and questionnaire studies I have been looking for answers to if the target achievements have increased by using the IT-solution, and if the teachers are aware of what they may or may not write about their students in the system. The conclusions I have been able to draw through my studies are that the teachers have accepted the commission to use P.O.D.B.

Syftet med denna studie var att undersöka attityderna gentemot PIM hos ett fåtal praktiserande gymnasiepedagoger. Jag ville även undersöka om PIM upplevs i samma positiva riktning som Skolverket anger i sin lägesrapport från 2009. Syftet är också att med fokus på gymnasielärare utreda hur innehållet i PIM-satsningen upplevs, huruvida ambitionen med satsningen införlivas efter deltagande och om dessa pedagogers undervisning och didaktik påverkas av att genomföra PIM. Uppsatsens huvudsakliga frågeställning är: Upplever gymnasiepedagoger i Malmö att deras medverkan i PIM bidrar till högre undervisningskvalitet? För att samla in information till studien genomförde jag kvalitativa djupintervjuer med sex gymnasielärare. Den genomförda studien är väsentligt mindre vad gäller informanternas omfattning i jämförelse med skolverkets lägesrapport.

This thesis examines and measures differences in effciency between L1- and L2 language use for solving referential problems. Quantitative measures used in the study were time and error frequency. Qualitative measures, such as how the tasks and the participants own performance were experienced, were measured by an post interview and two questionaires. Two different tasks, a sorting task and a construction task, in which each informant was given the role as a constructor or instructor, were used for data gathering. A total of 20 dyads, divided in two language groups (English and Swedish) participated in the study.

The report descripbs how a diplexer for a hybrid analog/digital filterbank has been constructed and tested. A diplexer divides the frequency band into two different bands that do not who doesn't overlapp each other. The sampling rate for the two ADC:s is 80 Msps, and therefore it is advantage to have zero at 80 MHz. The reason for this is that a proposed class of hybrid filterbanks with very good quality requires a zero at or close the sampling frequency to work well. The diplexer was made in three versions.

This Degree project summarizes how it is to work in the CAD program Revit Architecture. This was done because AQ Arkitekter in Eskilstuna is interested in how Revit works. Especially compared to AutoCad which is the software they are using today. Will their work become more efficient with the new software?The starting point was to find out how it is to work with Revit when you only used AutoCAD Architecture before.

One of the most crucial entries in the financial statements is revenue. Despite the importanceof revenue a lot of mistakes are made concerning this entry because of the extensive room forjudgements. Especially in the construction companies where a lot of differences exist due tothe fact that different standards are used for similar business transactions.The research concerning IFRIC 15 and the new upcoming standard for revenue recognition isnot very extensive. Studies including both IFRIC 15 and the new standard are even morelimited. Therefore this study aims to compare the effects of IFRIC 15 and the new upcomingstandard for revenue recognition, Revenue from Contracts with Customers, in three Swedishconstruction companies.

Stenebergs sockerbruk is a large log-timber construction, purpose built as a sugar refinery in 1739 and is one of Sweden's oldest industrial buildings constructed entirely out of wood. Despite receiving the status of a listed building (in Swedish: Byggnadsminne) in 1977, there exists today a surprisingly low amount of documentation of the building itself. In order to enhance the existing and lacking building documentation, this case study aims to shed light on the building's log-timber built frame, focusing on how it was constructed, how the long lengths of its walls were handled and what type of joinery and tools were used. A thorough investigation of the building is conducted on site, followed by gathering of information which is then presented through text and illustrations. The findings indicate the orientation of timbers, location of joints and scarfs as well as tool marks which together contribute to the forming of a basis of understanding of the building's construction..

This Degree project summarizes how it is to work in the CAD program Revit Architecture. This was done because AQ Arkitekter in Eskilstuna is interested in how Revit works. Especially compared to AutoCad which is the software they are using today. Will their work become more efficient with the new software?The starting point was to find out how it is to work with Revit when you only used AutoCAD Architecture before.

This report is a study in voltagelevel in connection with regeneration of brake energy from the tramtype M31 in Gothenburg.In the act of braking, the tram M31 uses electrical braking where the electrical motors generates energy and if possible send it back to the overheadline, where other trams in the nearby can use this regenerated energy for its own driving force. In cases where no other energyconsumers are located in the same section, there is a resistance witch task is to convert this energy into heat. The regulation of this resistance appears to cause an increase in the voltagelevel into far too high levels.Investigations of the trams regulationequipment and its construction have been done. Further have measurements on the overheadline been performed in order to map the voltagevariations during a longer period of time.The result have been showing that the voltagelevel during regeneration often is as high as 880V-920V, more extreme values have not been observed in a large scale. The values are especially high compared to the nominal voltagelevel.

One of the main tasks of the Swedish Armed Forces over the past few years has been International assignments, which increased the importance of the Lessons Learned process. Methods of simulator training with computers have become more frequent and the technical ability to collect digital data from sensors has been developed as well. This work demonstrates how the experience of Lessons Learned can be communicated with the computer simulator StriSimPC and how modern technology in future support experiences from the Lessons Learned process at the tactical level in the Army.Currently knowledge sharing consists of several processes and strategies in the Swedish Armed Forces. This is done by written reports, oral presentations and different practical exercises.This case study shows the functions of the simulator StriSimPC, methods of training and how it is used today. The study also describes the future opportunities, where digital metadata acquired from the modern combat vehicles could contribute sharing of experience in the Lessons Learned process.The summarized conclusions indicate that StriSimPC can combine the two strategies for personalization and codification of knowledge transfer to reach a higher level of learning.

Syftet med examensarbetet är att undersöka om användningen av digital teknik i undervisningen har en positiv effekt på elevers motivation, vilka för- och nackdelar undervisningen med IKT kan ha med hänsyn till inlärningens effektivitet och om pedagogens roll i klassrummet förändras när digitala medier används. Jag har upprättat en kunskapsöversikt med relevant litteratur för att belysa undersökningens frågeställningar. Undersökningen av litteraturen har visat att digital teknik kan ha en positiv inverkan på elevernas motivation, men att det ofta är den yttre motivationen som gynnas, och inte den inre som ger en större inlärningseffekt. Arbetet med IKT i undervisningen har många fördelar, bl.a. är möjligheten att arbeta med olika sinnen stor och att det gynnar olika inlärningstyper.

Today, about 15 to 20 percent of Sweden?s total emission of carbon dioxide can be traced to the household sector. By examining apartment blocks in a life cycle perspective, the origin of the carbon dioxide emission has been charted and analyzed. This information has been used to create a computational model that calculates the total emission of carbon dioxide from a specific apartment block. The results from the analyzed apartment blocks indicate that both the use of energy and the emission of carbon dioxide have been reduced since the 1960s. Through the examination of building materials, it is possible to lower the emission of carbon dioxide that origins from the construction phase of an apartment block.

The production costs have steadily increased within the construction industry during the 21st century. Voices are raised meaning that the construction industry is too unsuccessful in making the production more efficient and to develop it?s way of working. One way to deal with the production costs is to minimise the waste, with waste meaning activities that doesn?t add value to the finished product.

The production costs have steadily increased within the construction industry during the 21st century. Voices are raised meaning that the construction industry is too unsuccessful in making the production more efficient and to develop it?s way of working. One way to deal with the production costs is to minimise the waste, with waste meaning activities that doesn?t add value to the finished product.

Because society?s demand for quality, efficiency at low cost is constantly increasing, companies are increasingly choosing to invest new methods to achieve these points. Those who manage to find ways to improve their processes are often the companies that have the greatest chance of becoming a winning player in the market. BIM is a new method that can reduce the internal costs while increasing communications between different parties. However there is disagreement about what BIM is and its purpose.