This thesis has been performed at Uddeholms AB with the purpose to investigate theparameters affecting the formation of inclusions during the manufacturing of a low carbonmanganese-steel.A follow-up, steel and slag sampling and evaluations in microscope have been done for a totalof five heats.The results for each heat have been evaluated in relation to the theory from the literaturesurvey and suggestions for changes in the process to reduce the amount of inclusions whichhave a negative effect on the steel quality have been given.The project extends over a large process where many parameters affect the formation ofinclusions. However, a tendency that a higher addition of alloys seems to increase the totalamount of inclusions before and after the vacuum degassing is seen.The majority of the studied inclusions seem to approach the composition of the top slag aftervacuum degassing. Ladle glaze may cause the inclusions which had a different compositioncompared to that of the slag.A high or low ladleage together with a high argon flow during vacuum degassing seems todissolve particles from the refractory which later on get trapped inside the inclusions.The floatation for two heats has been studied where a short floatation seems to give a higheramount of inclusions in casted material.In machined material so called stringers were found. The main composition of those stringerswas pure alumina. Inclusions with a composition of pure alumina were not found in the liquidsteel, thus the pure alumina inclusions must be formed during the casting.

The purpose of this work is to design and construct a device able to measure the mechanical attrition of oxygen carrier particles. Those particles are used in chemical looping combustion and in the present situation there is a lack of knowledge in how the attrition process work and in which extension. To find already tested solutions trying to answering this problem a literature study wascarried out and the best solution found was the so called Grace-Davison Jet-Cup method. This method is supposed to emulate the attrition caused by a cyclone separator and its advantages are that it is possible to use small test amounts, 5-10 g, and a thirty minutes long test will be enough to acquire useable results. An device was designed based on the Jet-Cup method with some slight modifications.

This report describes the development of a high-voltage connector at the request of Scandinova Systems AB in Uppsala. The development process is described from the making of a customer demand specification, to the making of drawings for the manufacturing of prototypes. Scandinova develops high-voltage modulators, hence the need for connectors that can handle very large power pulses. Their current connector has several weaknesses that may cause the connector to melt or catch fire. The development began with a number of studies that included the modulator structure and the current connector structure and functions.

This report describes the initial work intended for updating the car sharing service Roadmate. Roadmate is one of the services received by the car rental company Hertz First Rent a Car. The goal was to present the client with design- and structure proposals for a car sharing service that includes high usability and at the same time remains aesthetically pleasing.The work is based on an initial study with data collection, mapping the target user group and its needs. Subsequent structural and design proposals for Roadmates company carpooling service are based on the facts surrounding the target group's needs. The result are well developed and tested design sketches with accompanying visual identity and sitemaps that can be the basis for the further work on the development of the service..

This paper was made together withTechPay AB, by their request.The dissertation has been divided into two separate parts; one of which is fully theoretical, with the focus on the security requirements of a digital cash register, and how to meet these requirements.The second part covers the implementation of anAndroid-oriented Java-library,created with help from the security requirements found in the first part. The purpose of this library is to make it easier to develop a cash register that uses payment terminals from TechPay.This paper also covers different communication protocols, encryption techniques and recommendations from authorities, banks and Android. This paper also contains a small review of how users are validated in applications on the current market that handles money transactions..

Operators and Internet service providers invest in broadband to be able to deliver new services that require higher data transmission rate. A way to make this possible is to use ADSL, Asymmetric Digital Subscriber Line, as the access technology. To be able to handle this technology, the service providers should do a pre-qualification. Methods and tools are needed to analyze the local copper lines and decide if these qualify for ADSL with respect to service availability and possible bandwidth through the lines. This report brings up some methods for pre-qualification of ADSL, the important quality parameters and how to gather them from the available services today.

Research is a time-consuming endeavor which requires appropriate tools to manage often vast amounts of information. Militarization 2.0 is a research project aiming to explore Militarization in social media. The aim of this project is to design a user interface for supporting researchers in projects involving large amounts of data in qualitative studies. The project will follow the design process of the first version of the Militarization 2.0 research database interface. The design process involves user studies, interviews and design and testing of paper and digital prototypes.

Mattias MogardGustav von HeijneSammanfattningFör framgångsrika företag är det essentiellt att ha kontroll över sina resurser. Studien tar upp ett ämne som handlar om att skapa en överblick och en medvetenhet om resurseffektivitet inom ett företags produktion.Performance measurement är ett tillvägagångssätt för att kvantifiera aktiviteterna inom en produktion. Data struktureras genom nyckeltal, Key performance indicators (KPI:er), till övergriplig och användbar information. ISO 22400 är en uppsättning standardiserade nyckeltal med ändamålet att appliceras på automatiserad produktion. Studiens syfte är hitta vilka av nyckeltalen från ISO 22400 som är lämpliga att använda vid mätningen av en helt automatiserad produktionskedja som tillverkar motorblock.

Matematiska kunskaper är en central del inom digital spelutveckling. Metoderna hur man lär ut matematik och dess innehåll har dock inte utvecklats i samma takt som hur lär ut hur man utvecklar spel. Jag vill med den här uppsatsen och mitt kandidatarbete utveckla ett unikt kursupplägg av tillämpad matematik for spelutveckling i 2-D. Detta upplägg baseras på analys av tidigare erfarenheter av matematikstudier och samtal med övriga kursansvariga. Den be?ntliga kurslitteraturen som används på tekniska högskolor är väldigt avancerad i sin forklaring av teori.

Allt större och större andel företag väljer att presentera och förmedla varor och tjänster via e-handel. En viktig aspekt vid e-handel är att kunden känner förtroende för e-handelsapplikationen och företaget. Denna rapport redogör för vilken inverkan multimediala inslag har för förtroendet av en e-handelsapplikation, vid initialt användande. En undersökning har genomförts med hjälp av en kooperativ utvärdering av fyra e-handelsapplikationer vilka innehåller olika typer av multimediala inslag har.Resultatet av undersökningen visar att multimediala inslag inverkar positivt på förtroendet för e-handelsapplikationer. Däremot finns indikationer på att för hög grad av multimedialt inslag inverkar negativt på förtroendet för e-handelsapplikationer..

This study aims to investigate how and why teachers use social media to reach their students, and how they handle different levels of computer literacy among students.The purpose of this study is to investigate the experience of teachers using social media in their teaching. I have done interviews with two teachers, who use social media in different ways. One of the teachers makes her students publish their work on the Internet on wiki-spaces, and the other one use Facebook for discussions and teamwork. This report uses the pedagogy theories laid forth by Vygotskij as a vantage point to analyze the answers from the teachers. I have also looked at some of the published student texts on the Internet.This study concludes there are students who don?t have access to computers and Internet at home.

I denna rapport undersöks hur elektroniska böcker (eBooks) enligt standarden Open eBook Publication Structure kan komprimeras på ett effektivt sätt. Anledningen till att området valts är att en välanvänd standard för eBooks inte finns för tillfället. Standarden är relativt ny och senaste versionen av specifikationen har kommit ut under 2002. Med i utvecklingen av standarden finns många stora företag som exempelvis Adobe Systems Inc. och Palm Digital Media.

Quality assurance for Scania engine componentsScania engines have become one of the world?s most renowned corporations in themanufacturing of engines. This is mostly due to the quality and performance thatScania have shown. However, this does not stop Scania from trying to achieve moresuccess in the fields of development and research to assure the quality of theirengines.The purpose of this thesis is to show how Scania ensures the quality of the enginecomponents, both those who made externally and internally at Scania, also inclusivethe manufacturing and assembly process.Three engine components were examined: D16 block engines, water pump andXP-Iinjectors. The study included the whole process from the step of supplying therow materials to the last step in production functional test.In this thesis an investigation of how other companies are working with qualityassurance was conducted.

Society today is characterized by the transforming effect IT has had, the majority of the activities we perform on a daily basis involves one way or another digital technology. One area which has not yet seen the positive effects of IT is education. Despite the progress of technology, the school education has barely changed since it first saw the light of day. Our goal with this study is to investigate the possibility of implementing Gamification elements in educational environments and examine whether it could increase our young students learning motivation. We believe that this kind of implementation will have a positive effect for these young people since they have been interacting with games since they were small and are familiar with the driving force of a reward system.With this study we want to examine the opportunities and challenges that Gamification implementation brings out in a learning environment and therefore encourage and motivate our young ones to study even harder..

AbstractUniversity of Växjö, School of Social SciencesCourse: POC 536, Political Science 41-60Title: The U.S. military intervention in Iraq ? A study of how the intervention corresponds with the UN CharterAuthors: Andreas Malmgren & Johan SchneiderSupervisor: Lennart BergfeldtDate: 2006-09-26The aim of this essay is through a qualitative literature study examine the main arguments of the Bush administration to justify a military intervention in Iraq. The theories used to explain the actions of the U.S. are system level analysis, hegemonism and realism while the UN Charter will be applied as a normative theory.