At the Division of Electricity at UppsalaUniversitythere are ongoing researches, including a research concerning turbo generators.Turbo generators produce a large share of electricity in the world; however they are costly mainly due to the fact that the cooling and ventilation that are needed to eliminate the excess heat from the generators are expensive. Turbo generators work with high efficiency and in this project, the main task is to simulate a generator while taking into account that the generator must be designed against self-oscillation, centrifugal force, exhaustion and heat. The turbo generator must be simulated without being too expensive and complicated.In this project, the dimensions of the turbo generator depend on the efficiency of it, and where the losses are in the generator. Furthermore, the optimum values need to be chosen with the help of the ACE simulation program. The report begins with an introduction describing the project followed by a task description that is dealing with the project.

To meet the needs and demands of the costumer, accurate information about how much is available in stock is necessary. When the information in the system does not match the physical inventory, inventory inaccuracy occurs. Inventory inaccuracy is common among companies and may contribute to increased labor cost, excess inventory, production disruptions, waste of time, late deliveries, poor service and lost customers.The purpose of this study is to identify contributing factors to inventory inaccuracy for business with outdoor storage. The study also aims to investigate how efficiency factors can reduce the inventory inaccuracy for business with outdoor storage.A case study was conducted to answer the purpose. A company in the steel industry was chosen to examine inventory inaccuracy on business with outdoor storage.

The purpose with this study is to compare different systems of grain storage from a financial point of view. Grain that is supposed to be fed to laying hens. The systems that were compared were different airtight storage of grain and a system of conventional storage. To make this case study I choose to compare four different systems. In the case study there was one system with bin drying of the grain, two systems with airtight storage of the grain and one system where you buy dried grain during the season. I made several of capital investment appraisal where I found the cost of each system, then I took the cost and divided it with the total grain use and calculated the cost for each kilogram of grain, and also the cost of the feed. Then I compared the cost from my case study with the cost of buying feed. All the systems except for one, gave a lower cost for the hen feed than buying feed from a dealer The best system, witch were bin drying lower the cost with about 80 000:- SEK.

Companies that invest in e-learning have different expectations regarding the outcome of the investment. According to literature and articles it is common that companies see reduction of costs as the primary benefit with e-learning. Therefore we ask ourselves the question if companies have attained the expected benefit of the investment in e-learning and to what extent cost reduction have been a determining factor in the investments? The purpose of the thesis is to examine if companies that invest in e-learning have attained the expected benefits. We also want to examine what the reason for investing in e-learning is and if cost reduction is the primary reason for investing.

The aim of this study is to find a method to incorporate the energydemand of a building in the investment cost estimate.The study is based on an actual apartment block. The significant energyaspects are identified, and changed to more energy efficient options.These are then simulated using the energy calculation program VIP+.The calculated energy need is used in the investment cost estimate, andthe simulated alternatives are compared in regards to their economicalprofitability.Depending on the focus, different alternatives are the most advantageous.Since this study aims to show which alternative is the mosteconomically profitable, the annual profit is the parameter of mostimportance. This means that individual measuring of heating and hotwater use is the recommended change of the original house. A changeof the windows to new ones with a U-value of 1,0 as well as 0,8W/m2K also results in a positive change of the annual profit comparedto the original house..

The project was performed at SiemensIndustry Drive Technologies with theobjective to provide actual values forthe energy savings potential withinSiemens scope of practice.In Sweden the electrical drives standfor about 30 % of the total electricityconsumption and about 60 % of theelectricity consumption within theindustry. During the pre-study phaseelectrical drives with pump applicationswere identified as large energy users.Because of this a case study at one ofSiemens customers, Stora Enso Fors wasperformed. The system that was evaluatedduring the case study was a throttledsystem with a centrifugal pump forpumping pulp.The results yielded that a saving ofover 50 % could be achieved by replacingthe throttle valve with a variable speeddrive, a frequency converter. Thepayback period was two years and twomonths and the present value for thetotal life cycle cost of the variablespeed system was 662.566 SEK lower thanfor the throttled system. As aconsequence, Stora Enso Fors is advisedto invest in a frequency converter forregulation of the system.The general conclusion is that a focuson system efficiency is the mostimportant factor in energy efficiencyprojects and that the system regulationmethod has a large impact on the overallsystem losses and hence its efficiency.Energy efficiency potential forthrottled systems with centrifugal pumpsis large and significant economicalsavings can be made through investmentswith short payback time..

The Income Tax Act is enacted what criteria must be met to obtain a tax reduction of household work. Household work is the common term for ROT- and RUT-works. The purpose of the tax reduction is to increase job opportunities and to discourage that undocumented work performs.It is only for the labor cost as tax reduction is given for. The concept of labor cost is defined in law as it is not comprised of cost of materials, equipment or travel. The preliminary work provides no closer explanation what the labor cost includes.

This thesis examines the relationship between OECD-DAC and Civil Society Organizations (CSOs) within an aid efficiency context. The ability for these two actors to cooperate is highly important and determines the outcome for a major part of the development aid in the new millennium. The development agenda for the new millennium emphasizes aid efficiency as a key to a more successful aid, and this requires increased cooperation between all actors. The analysis made is a discourse analysis. The discourse of aid efficiency is analyzed, both its preconditions and results.The analyze finds out that there is a gap between OECD-DAC and CSOs in terms of how to handle aid efficiency.

To measure losses in a transformer with today?s methods is either slow or insecure. There s a new method developed by Alstom that hasn't been actualize in to a test-system and that has been the assignment in this project. The idea is built on a switched system and a CLR- circuit in the resonant frequency. The test-system has a calculated power-loss that make the efficiency to be as high as 99,8% and in reality over 95%.

The Swedish road transport sector relies almost completely on fossil fuels. In 2007, as much as 96 percent of the total sales of fuels was made up of petrol and diesel, while at the same time the share of total emissions of greenhouse gases in Sweden that came from road transports amounted to close to 30 per cent. Sweden is by no means worse off than any other European country in these respects. In order to address the questions of high oil dependence and CO2 emissions the European Commission has proposed a reinforcement of the legislative framework, with a 10 percent minimum for the market share of biofuels in 2020. Furthermore, the proposed target is binding for the member states, unlike the current voluntary target of 5.75 percent by 2010. More than doubling the usage of biofuels in only a bit more than a decade will most likely not be possible without policy interventions.

Abstract Tutor - Anders Richtnér History - Theories suggest that Lean Product Development strategies dramatically increase a company's performance through enabling faster T-T-M, Quality and Costs of Product Development. Purpose - The purpose of this paper is therefore to investigate whether the implementation of LPD actually affect corporate performance measurements T-T-M, Quality and Cost, in a positive way. Methodology - This Bachelor thesis is an exploratory investigation of the concept of Lean Product Development within a global IT- company, performed through four case studies, interviews and complementing corporate performance data. Findings - With empirical data and subsequent analyzes in mind, we note the following; it is clear that the project that produced the best results, in terms of T-T-M, Quality and Cost, also was the one furthest in the process of implementing Lean Product Development..

Title AB Volvo Pentas packaging system ?process and packaging logisticsAuthor Peter Powell, Lund's Technical CollegeSupervisors Annika Olsson, Lund's Technical CollegeJan Svensson, AB Volvo PentaProblem - Packaging requirements ? Which requirements are there, how do they affect each other and how are they fulfilled?- Packaging process ? what is the line of action when developing new packaging and making adjustments in existing ones? Who has the responsibility to do what?- Packaging logistics ? How is the packaging system adapted to transport efficiency and handling?Objective To create an overall picture over how the packaging system affects and is affected by different functions and players within and beyond the company boundaries, to give a clear picture of how changes in the packaging system is made today and how it could work and finally to give suggestions for cost savings affected by the packaging system.Method The methods used for this thesis has mainly consisted of action research and at some extent case studies. As a previous employee at the department of logistics at Volvo Penta I?ve taken part of the environment, information and prerequisites that this thesis discusses on a daily basis. Case studies have been used for the collection and analysis of data concerning packaging logistics as I?ve chosen to consider only specific markets and packaging.Conclusions This thesis has highlighted the demands that are placed upon engine packaging throughout all concerned units and how these demands affect each other, positively and negatively.

After the deregulation of the Swedish pharmacy market customers can be lost due to stock-outs. Optimization of pharmacy inventory levels has thus become increasingly important. To minimize inventory costs while considering the cost of shortages the latter must be estimated. However, the shortage cost is very difficult to compute. Thus, the aim of this paper is to estimate the pharmacy-specific shortage cost parameter and its relation to other inventory costs.

The structure and performance of grocery distribution in Sweden has changed profoundly since the second world war. Increasing access and usage of the private car, in combination with an accommodating town planning has enhanced the exploitation of scale economies within distribution firms. There is, however, some ambiguity concerning the overall efficiency of the distribution system when the costs associated with travelling and purchasing performed by households are treated as an integrated part of the total distribution cost function. The purpose of this master thesis is to develop the foundation of a spatial optimisation model, which defines the most efficient distribution system. The underlying idea is that the optimal localisation and size of grocery stores is a function of economies of scale within the firms weighed against distributions costs within the households, such as transportation costs.

Companies that invest in e-learning have different expectations regarding the outcome of the investment. According to literature and articles it is common that companies see reduction of costs as the primary benefit with e-learning. Therefore we ask ourselves the question if companies have attained the expected benefit of the investment in e-learning and to what extent cost reduction have been a determining factor in the investments? The purpose of the thesis is to examine if companies that invest in e-learning have attained the expected benefits. We also want to examine what the reason for investing in e-learning is and if cost reduction is the primary reason for investing. The study is founded on a qualitative method that is based on a case study in eight companies.