The purpose of this essay is to investigate if the companies listed on Nasdaq/OMX Stockholm Large Cap use the earnings management phenomenon Big Bath Accounting to a greater extent when a change of management (CEO) is made.Management tends to use earnings management when there is a bonus plan linked to the result of the company. To gain maximum bonus the management will try to manipulate the result in a way that in a long term maximize their utility. Through the earnings management technique Big Bath the management is given the possibility to take one large cost as a one-time expend, even though the cost is supposed to run over several financial years. This, of course, within the legal framework. A big bath may occur when there is an impairment of goodwill, tangible and/or intangible assets or larger provisions for future expense, or both of them at the same time..

A one-cylinder research engine has been used for studies with a Diesel Dual Fuel concept (DDF). DDF is a concept that utilizes a pilot diesel injection to ignite a homogenous natural gas/air mixture. Emissions and engine efficiency have been analyzed in an emission cycle called European Stationary Cycle (ESC) and the knock/pre-ignition problems with this type of engine have been investigated.At low and mid torque levels, an early diesel injection around 60 crank angles degrees (CAD) before top dead center (TDC) was used. At these loads raw NOxemissions was below EURO 6 level (0.2 g/kWh). NOxwas at EURO 5 level over the complete ESC without after treatment and with SCR at high loads it should be possible to reach EURO 6.One issue with DDF is the high HC emission levels.

Profit in first commercial thinnings of today is hard to achieve. This is because of prevailing pulpwood prices and because of high costs of logging and transport. To reduce these costs higher productivity is advocated. One way to increase the productivity is the use of multi-tree handling harvester heads. The aim of this study was to calculate logging and transport costs in first thinnings, where multi-tree handling has been used.

The aim of this study was to develop a load prognosis model for Uppsala district heating system to be used as a tool for heat production optimization. The methodwas to build three models for the different customer types; housing, industry andoffices and then scale them for the total system using data from Uppsala districtheating system. The heat load consists of two parts, one that is temperaturedependent and one that is dependent of the social behavior of the customers. Thetemperature part was modelled with an ARX model using an outdoor temperatureprognosis as input signal. The social behavior part was modelled using the mean ofthe social behavior from some days before and additionally by distinguishing betweenweekdays and weekends.

In Sweden whenever trains or maintenance workers want access to the railway system, their requests of usage and movements are being supervised, granted and handled by train dispatchers. The profession holds a key role in making the complex railway system work in terms of efficiency, safety and delivering on-time arrivals. This master thesis, delegated by the Swedish Transport Administration, has been carried out at the Division of Human Computer Interaction at Uppsala University and at the train traffic control center in Gävle. The aim has been to map what information the train dispatchers use in order to make safety-related decisions concerning their working goals. And further to describe and analyze how the train dispatchers, visavi their tools and systems in the work domain, gather necessary information.The result indicates a complex, diverse and spread out setting of different programs, procedures and tools that make satisfactory fulfilment of efficiency, safety and punctuality in relation to the time table hard.

During the autumn 2009, a 15 hp degree project was accomplished. The objective of the study was to describe different equipment alternatives, suitable for fresh market apple harvest. A field study was conducted during the harvest period to evaluate the efficiency (kg / person/ hour), using the different equipment. Four different systems are described in the study; Pick-ing-bag, Picking-train, Pluk-O-Trak and the Conveyor Harvester. The information about the systems is based on interviews with growers together with previous studies.

This thesis has been focused around the Diels Alder reaction with the goal to design an enzyme catalyzed reaction pathway. To achieve this goal computer aided enzyme design was utilized. Common traditional methods of computational chemistry (B3LYP, MP2) do not do well when calculating reaction barriers or even reaction energies for the Diels Alder reaction. New calcu- lation methods were developed and tested. This was the focus of the first part of the thesis, by choosing a small system, extensive and heavy calculations could be done with CBS-QB3.

Feedback tools support electricity users within the Swedish residential sector to increase their knowledge of electricity and the electricity market as well as to become more aware of their electricity consumption, which in turn encourages a reduction and an increased flexibility of electricity use. The primary aim of this study is to identify and analyse how existing feedback tools can be improved, to ensure that they contribute efficiently to the achievement of the EU objectives congruent with a more sustainable energy system in 2030, emphasizing: greenhouse gas reduction, increased energy efficiency and an increased share of renewable energy. In order to reach the primary aim of this study, existing feedback tools have been identified and mapped and interviews with feedback tools providers have been conducted. The study is limited to three research areas: the practical functions of feedback tools, available technology and the use of feedback tools.The use of more efficient feedback tools will provide an increased success rate for energy management, which includes both behavioural changes and energy efficiency. According to the results from the interviews conducted for this study, an increased use and user frequency is important to utilise the energy management potential.

The purpose of this thesis is to assist the Swedish energy company NIBE Energy Systems in their studies of adaptive regulation applicable to electrical water heaters. Due to coming energy classifications of these appliances in the European Union, NIBE Energy Systems needs to use adaptive regulation, called Smart Control, to keep their products in the best possible energy class and remain competitive to the market. By using this Smart Control regulation a 2-3 % improve-ment of efficiency can be credited the system. This is a small number, but heavily needed, since the energy classes are based on the idea that the European Union is provided with electricity from coal condensate power resulting in a 40 % maximum efficiency. Furthermore, doing noth-ing will result in some water heaters not being approved to use on the market from 2015 due to low efficiency.

Higher demands of competitiveness and efficiency have led to increasing sizes of farms, with more land, more capital and more comprehensive logistics. The aim is to gain benefits of scale economies that reduce the production cost per unit. However, a greater extent of the business exposes the farm of increased risk where small deviations rapidly can erase the benefits. A modern dairy farm thus put high demands on the farmer?s ability to coordinate, plan and manage the forage production through the whole process until storage to obtain silage of the desired quality and quantity at the right price. The objective of this study was to design a simple model, i.e.

The aim of this study is to examine and analyze how management control mechanisms evolve within an organization when a requirement of return on equity is imposed, as well as why the mechanisms evolve the way they do. A case study was performed on Samhall, a Swedish state-owned company, which has the aim to help people with disabilities develop by providing meaningful work. The framework provided by Samuelsson, defining five means of control in organizations was used to structure the study. Further, theories within New Public Management have been used to provide the reader with a proper background to the research area. Theories from the institutional field of organizational research have also been used to provide further depth to our analysis.

Water logistics has long been a problem in order to effectively carry out stump treatment in both thinning and final felling. It is important that the stump treatment? equipment is configured as well as a sufficient amount of water is carried out on the harvester to get a cost? effective treatment. The flow control of the equipment has improved and water can be dispensed more efficient, but still the amount of water on the machine is a crucial factor in the total cost estimate. The knowledge of the tools available to bring water as well as the internal logistics of loading and transport to the felling site is deficient. Increased focus on "smart" solutions to manage water cost is of great importance in order to combat Hetrobasidion spp in both thinning and final felling. The purpose of the study is to describe and summarize different solutions of water logistics at stump treatment in final felling.

The climate changes that are occuring in the world have resulted in that the EU callingfor a 20 % reduction in energy consumption to the year 2020, to reach that goal theEU want the public sector to go forth as a good example. Västfastigheter owns andmanage the hospital buildings in the Västra Götaland region. To be able to reducetheir energy usage Västfastigheter has hired several consulting firms to chart out theenergy consumption on each hospital building. The biggest energy savings potentialhave been calculated and what the cost will be to perform each action. The energyaudit have been completed and stand as the decision basis for Västfastigheter?s choiceon which action packages that should be implemented.

In Sweden the residential and commercial sector is a major user of energy, why the Swedish government has set a specific goal to half the energy usage in buildings by 2050, compared to 1995. The Swedish Energy Agency has therefore started the campaign ?Halvera Mera? to encourage demonstration projects that will show how to renovate in an energy efficient way, and in doing so prove that it is possible to reduce a building?s energy usage by half and still make a profit. These projects are intended to serve as good examples and give inspiration to residential owners to perform energy efficient renovations. To make sure that these projects serve their purpose, it is important to know what will inspire and what will impede a residential owner to invest in energy efficiency improvements.

This thesis, in the field of healthcare logistics, has been carried out at Hjärt- och Medicincentrum (HMC) at the University Hospital in Linköping during the fall and spring of 2012/2013. The thesis is done by two students at Linköping University at master?s level within the framework of Industrial Engineering and Management.As Sweden's county councils should not make a profit or loss, it is important that the councils are aware of how much care processes cost. Kardiologiska kliniken at HMC in Östergötland?s county council is one of the clinics that are profitable.