Objective: To investigate the experiences of ambulance nurses when using Boussignac CPAPcompared to their previous model, and their suggestions for possible improvements in the use of CPAP in the care of patients with pulmonary oedema. Method: A qualitative study with a descriptive and exploratory approach. Data was collected through ten semi-structured interviews with ambulance nurses, seven men and three women. The analysis was conducted using Lundman and Graneheim?s content analysis.

An often encountered problem when implementing a mass flow regulator in a rolling mill is the one with measurement of speed. The most widely used solution is to fit a pulse counter to a wheel that is in contact with the strip. Common problems with this design are for instance scratch marks on the strip and problems with the flatness measuring system.  One way of circumventing the aforementioned problems would be a non-contact measuring system. The market of today only offers systems based on the Doppler principle.This report evaluates three different systems for non-contact speed measurement. Important areas in the evaluation have been the ability to operate under normal rolling conditions, integration in existing control system and how well the sensor can be fitted to the rolling mill.

An often encountered problem when implementing a mass flow regulator in a rolling mill is the one with measurement of speed. The most widely used solution is to fit a pulse counter to a wheel that is in contact with the strip. Common problems with this design are for instance scratch marks on the strip and problems with the flatness measuring system.  One way of circumventing the aforementioned problems would be a non-contact measuring system. The market of today only offers systems based on the Doppler principle.This report evaluates three different systems for non-contact speed measurement. Important areas in the evaluation have been the ability to operate under normal rolling conditions, integration in existing control system and how well the sensor can be fitted to the rolling mill.

To meet the needs and demands of the costumer, accurate information about how much is available in stock is necessary. When the information in the system does not match the physical inventory, inventory inaccuracy occurs. Inventory inaccuracy is common among companies and may contribute to increased labor cost, excess inventory, production disruptions, waste of time, late deliveries, poor service and lost customers.The purpose of this study is to identify contributing factors to inventory inaccuracy for business with outdoor storage. The study also aims to investigate how efficiency factors can reduce the inventory inaccuracy for business with outdoor storage.A case study was conducted to answer the purpose. A company in the steel industry was chosen to examine inventory inaccuracy on business with outdoor storage.

Tacit knowledge refers to the knowledge that is located inside individuals; it is not expressed or written like explicit knowledge. Inherently, tacit knowledge is often limited solely to one person and consequently individually based. Project based companies need to acknowledge the importance of transforming tacit knowledge into explicit in order to preserve the knowledge inside the organisation. If the knowledge is not transformed, there is a great risk of losing the knowledge when a key individual leaves the organization.One way of transforming the tacit knowledge is through Nonaka?s and Takeuchi?s knowledge spiral.

The Production Manager at Atlas Copco AB Craelius wants to adopt a lean approach to become more competitive. This thesis is an exploratory study of the subject and what it means for the business activity and its implementation process.The objective is to provide a basic understanding of lean to the company, and what this means for Atlas Copco AB Craelius. The report describes the industrial revolution in brief. This is because the company itself must understand where certain ways of looking at production management is derived from. Furthermore, it provides an understanding of Lean's origins.

Background: The need for palliative care at home hasincreased in recent years as more people wish to die in their own homes. Toperform good palliative care by addressing patients' needs and desires of lifecare requires a better understanding of how nurses experience palliative careat home. Aim: The aim of the study was todescribe nurses experiences of caring for patients in palliative care in homecare. Method: The method was asystematic literature review and the article search resulted in elevenqualitative articles. An inductive qualitative approach was used where nursesdifferent experiences was identified. Results: Our results are reportedunder two themes:Opportunities and Barriers. Palliative carein home care experiencedby nurses in variousways in which personalgrowth, experience, guidance,trustful communication, cooperation and self-knowledgewas opportunies thatemerged. Barriers experienced by nurseswas ineffective communication,lack of time and abuseof power in palliative care at home.

The development of productivity in the construction industry has long been at a steady state compared to the manufacturing industry. Studies have shown that, amongst other things, waste on construction sites can reach up to one third of the total production cost. This has been observed from different aspects, and change is forthcoming.This thesis aims to provide a foundation for an increased productivity at production sites of building bridges. It is primarily based on a field study at Skanska, at a bridge construction site near Grängesberg. Via continuous interviews with the whole production crew, construction workers and management, information on interference and possibilities of improvement at the work site has been documented.

This examination paper is a lead in the educational program Industrial Management at Jönköping University. The paper itself contains an analysis of the warehouse organisation and its efficiency at the furniture company Voice AB in Torsvik, just south of Jönköping, Sweden. The report also contains propositions to raise the level of efficiency in the company warehouse and warehouse management.In the investigation of the warehouse a number of possible improvements were found. Examples are lack of a system for labelling shelves and racks, lack of an efficient location system and development possibilities in work routines. For the empirical investigation both qualitative and quantitative methods ware used.

Future emission legislation puts great emphasis on increasing the efficiency of the engine, thereby reducing fuel consumption. The tribological contact between cylinder liner and piston ring is where an great amount of energy is lost due to friction, and by reducing these losses an reduction in fuel consumption can be achieved.The aim of this thesis was to evaluate the tested piston ring coatings against a plasma sprayed cylinder liner and rank these combinations of materials for friction and wear resistance. The coatings that were tested was Cr + Al2O3, (Al,Cr)N, two types of CrN and WC / C.The experimental tests were performed with a so-called pin-plate, where used oil with addition of an acidic mixture of sulfuric and nitric acid to mimic the acidic condensate formed when exhausts recirculate, were added with a continuous flow. The results were then analyzed by weighing, studies by optical microscopy and scanning electron microscopy (SEM) and profile measurements.The results from each material combination were that the plasma coated cylinder liner wears too aggressively in order to yield a ranking of the piston ring coatings based on the parameters of friction and wear resistance. It is therefore proposed that an alternative coating on the cylinder liner should be developed, lacking the large abrasive wear on piston rings and that can withstand the corrosive environment resulting in engines equipped with EGR.

Abstract The aim of this paper is to investigate whether Vara municipality has a continuous picture of their identity, profile and image. Globalization has contributed to the increasingly growing of place marketing. Therefore, the study goes on to using the concepts of identity, profile and image to find out if Vara Municipality communicates similar throughout the whole organization and find out their all through core values. Globalisation will be an interpretive framework for the work that describes why the place marketing is becoming more pressing. The sense of place will be a central part of this study as it is the feelings and images of different places that will be described by the municipality together with the identity, profile and image.

Sepsis (blodförgiftning) är ett allvarligt tillstånd och behöver en snabb diagnos som fastställs genom blodprov. Blodprov från hela Stockholms Län skickas till Karolinska Universitetslaboratoriet (KUL) för analys, där biomedicinska analytiker och läkare fastställer arten på infektionen och beslutar vilken antibiotikabehandling är optimal.Målet med arbetet var att identifiera eventuella problem som skapar flaskhalsar hos Klinisk Mikrobiologi i Solna som är en del av KUL. Därefter skulle lösningsförslag framföras och möjligheten att införa blodprover i ett nytt automatiskt system, BD Kiestra Total Lab Automation undersökas.Verksamhetskedjan för laboratoriet analyserades genom observationer och läsning av metodbeskrivningar. Utifrån verksamhetsanalysen identifierades sedan problem. En utbildning med BD Kiestra TLA gav en översikt av hur systemet fungerar samt fördelarna med att använda det.Genom litteraturstudier samt öppna intervjuer kunde förslag på lösningar och förbättringar framföras. Resultaten behandlar de lösningsförslagen för de identifierade problemen, och sammanfattas i en tabell. BD Kiestra TLA behandlades separat med en systembeskrivning, följt av de problem som finns för införandet av blodprov och hur dessa problem kan lösas..

Purpose: The purpose of the investigation is to give an insight to hot the EU legal environment in the field of vertical relationships influences the competitiveness of the 2nd tier of the automobile industry. Conclusion:It follows that European legislation has succeedded in raising the competitiveness by breaking down the powers of the predominantly more powerful companies that the 2nd tier players do business with and by giving companies sufficient leeway to act. The comment must be made here that serious problems due to a power misbalance might still exist yet are not uncovered. In the course of my research I have found a lack of issues in my subject field. These problems however would have a more structural and economical cause, dealing with these problems would fall outside the boundaries of the competence of European competition legislation.

The public sector has through the years been exposed to a rather radical alteration. The aim with this alteration has been to make the public sector more effective. It?s a dynamic society that Norrbottens läns landsting (NLL) operates in today and it is therefore of great importance that the managers get a solid foundation to rely on, since they have a central role in the ambition for efficiency. Another reason to educating the managers is that NLL can secure the future pension losses.

Sweden is a world leader in listed private equity and ranked fifth in the world in market capitalization. The sector is attracting increasing interest from the investment community. However, the private equity industry in Sweden has historically poor reputation and is criticized for creating value through high leverage, multiple riding and severe cuts. This study analyzes value creation drivers in buyouts from the perspective of the private equity firm using a dataset of 15 realized buyouts by private equity firms listed on NASDAQ OMX Nordic Stockholm. The methodology used separates the value contribution of leverage on the private equity firm's return from internal operational improvements and external variations in transaction multiples.