This technical report describes the master thesis in material engineering called ?Testing of surfaced hardened materials conceivable for gears and shafts?. The work extents 20 academic points. Land systems Hägglunds manufactures and sells different kinds of combat vehicles and terrain vehicles. Since the demands for bigger and stronger vehicles increases all the time, so are the demands on shafts, gears and other transmission details.

Logistics and supply chain management in the construction sector is an area with great potential for improvements. Today, a lot of the workers time is spent on non-value adding activities. Research has shown that waste is a large proportion of the total production cost in building projects today.The purpose of this report is to analyze problems concerning logistics in the construction sector. Two of Skanska?s construction projects in Uppsala have been analyzed to identify problems.

The filters used today to purify water are often expensive and the need to find new filter materials is substantial. Studies of pine bark have shown that this is a material that may be used as an alternative to conventional filter materials, such as activated carbon. However, the study of pine bark has shown that a leakage of phenolic compounds may occur when using the material for water purification. Therefore, the purpose of this report is to investigate the release of phenols from pine bark, in order to evaluate the use of pine bark as a filter material. Another assignment is to investigate the amount of metals adsorbed by the filter material.

From January 1st 2011 the use of Eurocode will be mandatory for all constructionprojects. Eurocode is the common European set of struc-tural design codes which willreplace BKR (Boverkets Kon-struktionsregler). BKR is the Swedish set of structuraldesign codes that was used up until December 31 2010. For consulting firms this willcre-ate a need for them to invest in the standards and in education for thecoworkers. This will involve both time and costs for the company.The purpose and aim of this master thesis is the development of compute examplesand calculations aid by dimensioning with Euro-code.

In the construction industry the number of female managers is very low, only four percent (SCB, 2010). In fact, women with management positions has risen by six percentage overall, the last seven years (SCB, 2010). If women in managerial positions continue to grow at this rate, the proportion of women managers will be equal to that of male managers in 2033. More women are needed in the maledominated construction industry in particular because it is deemed that they have a different way of thinking and acting (Granér, 1994). Nelton (1991) believes that companies can take advantage of female managers to be more competitive on the market, the reason why is because women can see other possibilities when solving problems. Rapacioli (2010) argues that the recruitment of women into management positions not only benefits the individual itself but also the company. We have used a qualitative study with a deductive approach. Six respondents from the same company were interviewed, two of them have management positions and the other four were underemployed.The research question of this paper is: What differences and similarities are seen between male and female leadership in terms of their characteristics in the construction industry?The purpose of this paper is to examine similarities and differences in leadership in the construction industry where the focus is on the female and male characteristics. To fulfill our purpose we chose a qualitative study. We have interviewed six respondents at one company in the construction industry. Two of the six respondents have management positions and the remaining four are employed. In this paper we have concluded that there are some differences and similarities between men and women´s leadership in terms of their characteristics.

This qualitative research is about how Swedish media constructs immigrants in articles. The focus of the study will lie on ten Swedish articles and how they stereotype immigrants, but the demarcation will be for young immigrant boys related to crimes. The purpose of this paper is to highlight how media achieves its goal to construct a group as inferior. This will be implemented with the help of articles from different newspapers that reported on immigrants who have committed crimes. We have chosen to look at different newspapers to see if there is a curtain pattern in the construction of immigrant boy.

The main purpose with this study is to describe teachers? use of textbooks and other teaching materials in upper secondary school (gymnasiet) in Sweden, and to discuss the use according to school subject and teacher style. Data was collected in two different ways. At first twenty classroom observations were made during lectures concerning the subjects Swedish (mothertounge), English (foreign language) and religion. Then four open interviews were carried out with the teaching teachers.

This report is the final step in the Bachelor of Science program in Building Construction Engineering, Department of Engineering Sciences, Uppsala University.The purpose of this study is to highlight the difficulties and possibilities that could involve the introduction of new energy efficient technologies and changing work around this technology. This study focuses on energy use at a construction site or other temporary workplace where so-called portacabins are in place to address the need for temporary facilities.The method for obtaining knowledge on the subject was mainly interviews with site managers working in Svevia AB's various activities. In conjunction with the interviews I visited construction sites and portacabins if it was possible.My most important suggestion to Svevia AB concerns a better organization in order to make poratacabins more efficient on energy and costs. The company should also evaluate and monitor the energy efficient portacabins that are in operation.Expected energy savings of new technology may not materialize if there are gaps in information, education, technical services and technical maintenance. It is very important to utilize the experiences of new technology.

This report describes a new foundation method and compares it with a traditional founding of concrete. This new method is called the Koljern technique and uses cellular glass which is called Foamglas. The Foamglas is compounded to founding elements by lightweight steel beams. Foamglas is an insulation material with high compressive strength, and is rot, insect, vermin and acid proof. The cellular glass is also fire proof and watertight, which makes it a very good construction material.The report contains a study of a number of cases for which the Koljern technique is compared with a foundation of concrete.

Light pollution in urban areas - How to prevent light pollution at construction Jakob Sjöling Light pollution is a relatively new but rapidly growing form of pollution. Society's increasing demand for light coupled with the pace at which lighting technology evolves is accelerating that growth. The purpose of this study was to analyse how the construction industry plan and design outdoor lighting when erecting new buildings, specifically with regards to the issue of light pollution. It also investigated how local authorities work with these issues during urban planning. In both cases special interest was placed in ways to improve the planning and use of outdoor lighting in order to minimize light pollution.

In order for construction projects to be completed within the specified time limit while at the same time be financially sustainable it requires thorough preparation and an extensive planning. Most essential is the groundwork and the design that determines the project's progress. There are many aspects to consider in order to avoid inconveniences such as delay, litigation, unexpected cost etcetera. If mistakes are made in an early stage it is very likely that the error will follow the process and become an expensive correction cost towards the later part of the project. In other words, it is expensive to rectify defects later on.

Our everyday life is becoming more active and the activities we perform influence the way we dress. Due to an increase in activities undertaken in an urban environment, demands are changing and the need for active wear that meets the new demands follow suit. The four characters represented in the research can be seen as a reflection of the functional features needed, including base layer, mid layer/insulation and shell.Despite the increase in activities, most of our clothes are still constructed on static dummies or drafted on a table in 2D and the main developments within the active sportswear field is driven by material innovation. By creating garments on a body in movement, my aim is to develop new functions and expression in active sportswear through construction.Construction methods in active sportswear are examined and understood through observations and reconstructions and constitute the foundation of a study of movement for a design recovery.The movement and features required for leading an active urban life sets the direction of the development of new func- tional garments. A series of trial and error sessions and draping fabric on a live model in movement created the prototypes used in functionality tests to establish their feasibility.

Bakgrunden till examensarbetet är att det existerar ett behov inom Sandvik Materials Technology att komma tillrätta med problemen avseende dålig leveransprecision och antalet reklamationer genom ett förbättringsprogram som kan angripa alla bekymren inom företaget. Företaget har i dagsläget inlett ett internt förbättringsprogram kallat Lyftet Ledtid, med övergripande syfte att sänka ledtiderna i processerna för att minska kapitalbindningen samt uppnå bättre kvalitet. Andra företag har implementerat förbättringsprogrammet Sex Sigma och en undersökning av dess lämplighet för Sandvik Materials Technology bör ske. Arbetet syftar till att undersöka förbättringsprogrammet Sex Sigmas utrymme inom det interna förbättringsprogrammet Lyftet Ledtid. Det bör även ange hur en eventuell implementering kan ske.

The development of productivity in the construction industry has long been at a steady state compared to the manufacturing industry. Studies have shown that, amongst other things, waste on construction sites can reach up to one third of the total production cost. This has been observed from different aspects, and change is forthcoming.This thesis aims to provide a foundation for an increased productivity at production sites of building bridges. It is primarily based on a field study at Skanska, at a bridge construction site near Grängesberg. Via continuous interviews with the whole production crew, construction workers and management, information on interference and possibilities of improvement at the work site has been documented.

The purpose of this report was to identify the current waste management of non-hazardous construction and demolition waste in a few Swedish construction companies, based on the different steps in the waste hierarchy with a focus on waste prevention, reuse and recycle. Additionally, the purpose was to attempt identifying opportunities, obstacles and as well as to propose possible solutions from an environmental perspective. The method used was a qualitative study using interviews conducted through emails and phone with employees occupying positions that could answer this reports questions. The results of this report indicates that waste management of construction and demolition waste has improved, and less waste goes into landfills. The concern is that the overall amount of waste being produced is not decreasing, thus calling for actions preventing the production of waste.