The way society categorize different people into groups is problematic in the sense that the categorization can seem stigmatizing and have social consequences for those being categorized. Immigrants are one of those problematic categories.The following essay studies this categorization of ?immigrants? based on a governmental investigation of structural discrimination that took place in 2002-2008. The aim is to study the use of the category ?immigrant? and the consequences that follows such a categorization.

I samhället Hults Bruk ligger en nedlagd brukshandel, från 1951, som idag fungerar som samlingslokal för de boende i området. Holmen Skog, som äger alla fastigheter i området, planerar nu för en ombyggnation av den gamla brukshandeln till familjebostad. Vår uppgift var att utforma ett planlösninsförslag anpassat till en tvåbarnsfamilj för den aktuella byggnaden. Utöver detta skulle vi även upprätta rumsbeskrivning och köksuppställning samt ge förslag på ledningsdragningar, tomtutformning och källarplanlösning. Holmen hade vissa krav och önskemål för ombyggnationen.

The purpose of this paper is to examine whether, and if so, how tourism effect the construction of a new city district with a stadium in focus. The study is based on a case study of Swedbank Arena and Arenastaden as nearby area. There has been an interest from the writers to study Swedbank Arena and Arenastaden, as it is a current subject, and both of them are under construction, which means that it was possible to see how the process works from the ground up. It has been shown that Swedbank Arena is built up in an entirely new district in which there will be new infrastructure that is tailored to the stadium and the crowd it?s expected to attract.

The product "urinal funnel" for women has fascinated me for a long time. Not only because it solves a practical problem in a simple way, but also because it challenges our definitions of gender and behaviour. This report describes the process of making a new design for a funnel, taking material, ergonomics and construction in consideration. It also includes structuring a launching of the product in Sweden. It starts up with a large amount of information gathering, both by interviewing testgroup-perticipants, but also by researching and evaluating the range of existing funnels.

VSEM project and the need for a more efficient way of handling requirements andinformation are highly apparent.The overall objective of this thesis is divided into two parts:1. To identify criteria/factors leading to a successful introduction of an informationmanagement system.2. To develop an implementation process for a requirement management system ?the first step towards a PLM system in EE development at VCC.This will be done through interviews with employees, a literature review and an analysisof studies of three earlier projects within VCC.The conclusion of this study shows the great need for change in work methods fordesigners handling information and requirements. An implementation process has beenidentified with guidelines on how to handle different phases of the process.

Nano materials can today be found in a wide range of consumer products and the number of new products on the market is expected to inrease. In the shadow of hope for nano materilas potential in various applications, low awareness of its health and environmental risks is hiding. Furthermore, the knowledge about people´s risk perception of nano materials is limited. Parallel to the situation described above, the scholls meet the challenge of incrasing the scientific literacy. To achieve this goal, skills in argumentation in science studies has been emphasized and the concept of socio-scientific issues has been emerged.

The aim of this study was to shed light on how journalists describe the child?s world and what gender labels are used in their descriptions. We wanted to get a better understanding of what happens when gender is constructed.In order to study how gender is constructed, we chose to examine how the children?s magazine Kamratposten describes children?s spare time. We chose Kamratposten because it turns to both girls and boys.

Title:Chillchain for cut flowers ? how the distribution works.Author:Anna-Maja Svarén, student at Lund Institute of Technology, mechanical engineering.Supervisors:Annika Olsson, Department of Design Sciences.Bengt Sahlberg, Bioett AB.Problem:How does the distribution of cut flower works regarding temperature, losses, responsibility, complaints, packaging and weak points?Purpose:The purpose is to map the distribution of cut flowers, with focus on losses in the temperature, from farm to store. The goal is to identify weak points in the chillchain and to se how wrong temperatures affect the flowers. The results can be a help to secure the chillchain.Method:The work started with a problem; map the distribution of cut flowers with focus on temperature losses. Data was collected on the basis of this problem, then analysed, and finally conclusions were drawn.Conclusions:The affect handling and distribution has on a cut flower is very complex.

The division of Engineering Materials at Linköping University, department of Management and Engineering, conducted a research project concerning Fatigue life of thermal barrier coatings during 2009. During this project equipment to provoke these fatigue failure by rapidly heating and cooling test subjects in cycles, was ordered.Design and manufacturing of the equipment was handled internally at LIU.The equipment was built using a furnace that is lowered and raised over the table where the test subject is placed. To keep the temperature of the furnace a lid slides in place to close the downward facing opening of the furnace when it is in the raised position. On this door there is nozzle that is used to cooling of the test subject by air.To make sure that the equipment can work independently you need an automation controller that can evaluate if movement can occur without danger of collisions. The control system also needs to monitor that all elements are performed according to plan.This degree project is based on a modular system from OPTO 22 and includes the configuration of a PLC that will be supplied with logic and a user interface.The degree project resulted in a graphic interface in which a user can set desired values for different parameters and get information about current values for them.

Uppdraget som gavs av Brimer VA Produktion AB i Osby var att ?föra fram deras nya vattenledningssystem i ljuset?, göra en FEM-beräkning på en detalj i systemet och ta fram en ekonomisk samt teknisk jämförelse mot det traditionella vattenledningssystemet. Bästa lösningen på uppgiften var att visualisera vattenledningssystemet med hjälp av animerade filmer. Detta med tanke på att visualisering har ingått till stor del i utbildningen Virtuell Produktutveckling & Design..

Syftet med examensarbetet är att ta fram förbättringsförslag som höjer leveranssäkerheten för transmissioner och axlar vid Volvo Construction Equipment Components (CMP) i Eskilstuna. För att möjliggöra detta har en tydlig bild över företagets situation idag skapats. Enligt kunderna anser CMP vara en av de sämsta leverantörerna, vilket verifierades när den genomsnittliga leveranssäkerheten uppmättes till 30% i den utförda undersökningen. Den dåliga leveranssäkerheten är till stor del egengenererad och skapas genom en ond cirkel av länkade problemområden. Den onda cirkeln börjar med dålig leveranssäkerhet vilket medför svängningar i produktionen som förstärks genom sättet att planera och anskaffa material.

Aeroseum is an aviation museum located in an old military underground hangar. The ventilation system in the hangar is designed for the military purpose of the hangar. This design includes a solution with air flowing through the space between the construction of the hangar and the rock surface. The solution is intended to avoid a buildup of inflammable gases. This design leads too high humidity levels in the hangar.

Funktionshindrade personer har möjlighet att få sin bostad anpassad så ett de kan leva ett självständigt liv i ett eget boende. Anpassningen betalas av kommunen genom ett bostadsanpassningsbidrag. De senaste åren har, inom Norrköpings kommun, kostnaderna för bostadsanpassningsbidrag ökat kraftigt och överstigit den budget som tilldelats. Syftet med den här rapporten är att undersöka hur andra kommuner arbetar med handläggning och upphandling av bostadsanpassningsärenden. En del frågor rör även åldersfördelningen.

During the past years Building Information Modelling (BIM), which is a digital way to work, has begun to spread amongst the parts of the construction process. At the construction phase the larger companies has started using the new way to work. This expansion has not been developed amongst smaller companies leading to the purpose of this report, to investigate in which ways the smaller companies can implement BIM by changing their way to work. The thesis is delimited to work preperations with the objective to define how the work preperations should be structured to enable the implementation of BIM. To achieve the objective of the report, information about the subject has been collected by interviews and literature studies.

As a result of increased energy prices more and more energy-efficient homes are coveted. An energy-efficient alternative is passive houses, which is characterized by an extremely well insulated building envelope that recovers the heat without the use of radiators or under floor heating. But a passive house requires a higher investment cost than a conventional building project, since it will require more construction materials, training of construction workers, greater land area, and long construction period. But the lower operating cost expects to pay back the higher cost of investment. We therefore question how profitable a passive house is in relation to houses built according to modern conventional building techniques.The aim of our study is to investigate the viability of passive houses compared to convent­ional houses.