The name of the study means ?The short arm - a study in diversity and arm?s length in the cultural collaboration model?. Right now there is a reform in the Swedish cultural administration where the responsibility for handing out state funds and grants to cultural organizations is changing from the state government to the local regional governments. The purpose of this study is to map the organisational changes caused by the reform and investigate how this affects the regional policies concerning cultural diversity and the arm?s length principle.

The EU has decided that it should be possible for consumers to get information about the origin of the electricity they buy. Therefore, there is a need to examine different systems for electricity disclosure. In this thesis two ways of disclosure have been studied:? Certificate system. A certificate system involves two parallel markets, one for trading electrical energy and one for trading certificates of origin.? Separated Markets.

Two ecological models of nitrogen processes in treatment wetlands have been evaluated and compared. These models have been implemented, simulated, and visualized in the Modelica language. The differences and similarities between the Modelica modeling environment used in this thesis and other environments or tools for ecological modeling have been evaluated. The modeling tools evaluated are PowerSim, Simile, Stella, the MathModelica Model Editor, and WEST. The evaluation and the analysis have been performed using McCall?s factors for software quality (McCall et al, 1977), a correlation analysis and the Constant Comparative Method (Glaser&Strauss, 1999).

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.

Previous work by researchers as Eugene F. Fama and Kenneth R. French, show that average return on stocks are related to a firms characteristics like size and book-to-market ratio. These kinds of patterns in average return is not explained by The Capital Asset Pricing Model (CAPM), and are therefore seen as anomalies. Fama and French have proposed a three-factor model, which captures patterns observed in U.S average returns associated with size and value.

This master thesis was made to validate hydropower models of a turbine governor,Kaplan turbine and a Francis turbine in the power system simulator ARISTO atSvenska Kraftnät. The validation was made in three steps. The first step was to makesure the models was implement correctly in the simulator. The second was tocompare the simulation results from the Kaplan turbine model to data from a realhydropower plant. The comparison was made to see how the models could generatesimulation result that was similar to the reference power station.

Hazel (Corylus avellana L.) is a common feature of meadows and pastures where it can grow in large populations and become very old. Is it possible to use the size of hazel stools for age determination and is it possible to use the size distribution of a population to provide information about how the land has been used? Hazel populations on ground where the lake-water level had been lowered, has been studied to validate an already developed growth model of hazel clones. Different hazel populations, on wooded meadows affected by mowing or grazing or overgrown meadows, were studied to evaluate the method utilizing hazel as land use indicator. The growth model was used to compare the size distributions of hazel populations with historical periods, which has been important for changes in agriculture or demography.

Svensk Växtkraft is the owner of the biogas plant in Västerås. The company is planning to increase their treatment capacity at their biogas plant. In connection to this work it is also possible to make some energy saving changes to the biogas plant. The objective of this study was therefore to make an electricity and heat survey of the biogas plant, a detailed study of the heat consumption in the sanitation step and also a comparison of energy consumption with the present sanitation method and an alternative strategy where the waste is treated in 55 °C during 10 hours (the current method is heating to 70 °C during 1 hour). The energy survey was conducted in close collaboration with staff at the biogas plant. The current during normal operation was measured, power was calculated and multiplied by the time of usage to obtain the energy consumed.

The consociational democracy model in Macedonia, which came out from a warcrisis and a peace agreement from 2001, in addition, putting an end to the violent conflict, actually admits the division of the society along the ethnic lines. Paradoxically, there is an attempt to bridge the ethnic gap with this model. As a result, the consociational democracy model holds solutions that can be abused if somebody misuses its power and desires to disintegrate the country. The future development depends therefore on the moderate attitude of the citizens, and first and foremost, on the political elites and their commitment to the values of democracy and human rights instead of their nationalistic goals. Furthermore, thepresent democratic consolidation in Macedonia is established on the execution of the peace agreement and the improved effectiveness of the institutions.

The Stockholm office market segment have for a long time been considered a safe havenwhen it comes to withstand negative turmoil in the form of rental compression due toeconomic fluctuation, especially in the CBD demographic. Recently however, a large numberof banks and institutions, amounting to some 200000 square meters, have decided to relocateto more peripheral locations with the aim of cost reductions on rent. This mass exodus isstudied with focus on rental dynamics as the result of increased vacancies. Other variables arestock changes and employment. The method is econometric combined with an interviewseries.

This thesis discusses model based tracking of radar echoes in tanks with liquid content. The errors in the measurements are not always random in these cases, and the interference that occurs when nearby echoes moves in relation to each other makes tracking difficult. The tracking problem can be broken down to four parts; track initiation, track destruction, association of the measured echoes to the tracks and to update the tracks with the associated echoes. The radar measurement is primarily made on the surface. However, additional echoes from the tank floor or other structures and double bounces are normally present.

3D-modelling in AutoCAD This thesis is done in cooperation with LB-Hus in Bromölla, and have aimed to establish a digital AutoCAD model of one of the company?s house types and to find out what opportunities there are to do visualisations in the form of images directly from the programme. Modeling has been carried out so that the very construction of the house is included. Interiors and installations, with the exception of the ventilation system, have been left out in the model. The model has been created with solid models after a comparative study made between solid models and surface models to find out which option in this case was the easiest to handle and took up the least space.

This thesis compares four relevance feedback methods. The Rocchio and Ide dec-hi algorithms for the vector space model and the binary independence model and Okapi BM25 within the probabilistic framework. This is done in a custom-made Information Retrieval system utilizing a collection containing 131 896 LA-Times articles which is part of the TREC ad-hoc collection. The methods are compared on two grounds, using only the relevance information from the 20 highest ranked documents from an initial search and also by using all available relevance information. Although a significant effect of choice of method could be found on the first ground, post-hoc analysis could not determine any statistically significant differences between the methods where Rocchio, Ide dec-hi and Okapi BM25 performed equivalent.

The report aims to describe the austenitic stainless steel Sanicro 25 from a thermomechanical point of view. The thermal and mechanical properties of the material make it suitable for use in coal ? and thermal power plants. By the use of Sanicro 25 it would be possible to bring the efficiency of these plants up while bringing the carbon emissions down.A material model is created from material testing and validated through simulation in the finite element software Abaqus. The model that has been derived describes the material behavior during loading and stress relaxation for the first cycle in a thermomechanical fatigue test well.

The government regulations for energy use in buildings will be tightened in the future. At the same time the interest in environmental classifications and certifications of buildings is increasing. This has meant a new situation for solar energy. The designs of solar heating systems are often based on experience and/or rules of thumb, rather than calculations and simulations. This thesis examines whether simulation tools, in this case Polysun, are useful in this work.