Ever since ABB has begun diecasting their rotors instead of permanent mold casting it,variation in the quality of the cast has arisen. Diecasting is performed in three differentmachines, M1, M2, M3 with 400, 660 respectively 800 tons of die locking pressures.The aim of this thesis is to answer the following questions:What is the ?right? cast quality? How is the right quality achieved?For sizes 160-180 solutions will be proposed that consider eccentricity between thelaminate and the short circuit ring as well as elimination of the thin Al film that appearson the outer periphery of the rotors.Through considering the statistic material the most often diverging rotor type has beenidentified and one of the actual rotors has been sent to a laboratory to be analyzed inorder to establish the current defects. The result of the analysis shows that there areplenty of gas- and oxide-porosity.It has been proved that every time the dies temperature decreased below 120°C thecontent of gas porosity increased. It is due to rapid solidification of metal that flowsthrough the ?cold? laminate.It has confirmed that enhanced porosity in squirrel cage causes high impedance in therotors.

This thesis has been carried out in New Zealand in collaboration with the University of Waikato. In association with Dr. Mike Duke the purpose of this work is to investigate whether two different software for modeling of photovoltaic systems are useful in the teaching of solar energy.The next ten years grid-connected photovoltaic systems are assumed to increase and therefore also a rising demand for people with engineering knowledge are to be predicted. For engineer students with a focus on solar energy a more practical teaching with design software´s can be a good method to make the students comprehend more when it comes to large scale photovoltaic systems and be more prepared for working life.The software´s used is called Transient System Simulation (TRNSYS) and Photovoltaic Systems (PVSYST) which are both well used throughout the world. To assess the reliability of the software´s, a reference solar power plant at 16.1 kWp installed capacity are used, which consists of photovoltaic modules from four different manufacturers.

From being an exotic small religion that has existed at a fading presence in southern Iraq and Iran mandeism has moved to the West and Sweden. As more and more Mandaeans encounter a new culture and a new society in Sweden it affects not only them as individuals but also their religion mandeism. In this essay, I have begun to examine how Mandaeans think about their identity and religion. I have taken my starting point in a broad theoretical discussion of identity, religion and secularisation. Mandeism is a gnostic religion that probably has its roots in today?s Israel / Palestine and sees John the Baptist as the last prophet.

Detta examensarbete behandlar växter som trivs vid havet. Arbetet baseras på frågan vilka växter som tål ett vindpinat och utsatt läge? Arbetet beskriver vad man skall tänka på när man börjar planera en trädgård vid havet. I arbetet har jag tagit upp vilka träd och perenner som man kan använda sig av när man skall skapa en trädgård vid havet. Syftet med arbetet är att man skall kunna använda sig av mitt arbete när man åker till plantskolan för att inhandla växter.

During the year 2014, Artex AB has worked to launch a new product whose function is to locally purify the air. The product is a headboard and its purpose is to give the user clean air while sleeping. The air purifier has different speeds and it`s up to the user to choose which effect that will be on. To get the best experience of the product as possible, the air purifier shall be controlled by a mobile application. In that way the user can increase and decrease the fan speed, even when the user not is home.

Abstract Master Thesis in Business Administration, School of Business and Economics at the Linnaeus University, 2013 Authors: William Funseth and Tobias Åkesson Supervisor: Magnus Willesson Examiner: Sven-Olof Yrjö Collin Title: The liquidity route to more informed investment decisions - A study on the relationship between concentration of ownership and liquidity on Nasdaq OMX. Background and problem: Previous studies have shown that liquidity can explain differences in returns in corporate shares, the company's cost of capital and the valuation of the company. Based on the effects of liquidity we developed a research question concerning how concentration of ownership effects liquidity of corporate shares the studies conducted for companies listed on Nasdaq OMX during a period with major changes on the stock market and is also investigating weather other company-specific differences can explain differences in liquidity. Purpose: The study's purpose is to study the relationship between ownership concentration and liquidity, and whether other factors might explain differences in liquidity. Method: The study is conducted with a quantitative method and it?s based on data collected from 2006-2011 for companies listed on Nasdaq OMX.

With higher prices for oil and increased focus on fossil fuels impact on the environment the heating sector are searching for alternative fuels. Pellets are a quite new product whose production has risen exponential in recent years. Today there are small-, medium-and large-scale users, where the large-scale consumers are the heating sector. The heating sector is mainly using oil to cover the increased demand during cold periods. The purpose of this study is to analyze the potential of pellets if it would replace thermal power plants oil and coal. The study will also analyze the economic impact a conversion would mean for a heating plant and if the pellet is a reasonable substitute. 2008 statistics from the Swedish district heating association were analyzed and a calculation was performed to determine how many tons of pellets is needed to replace coal and oil.

The object of the thesis is to propose a new lighting plan for the square Fyristorg in Uppsala, and to describe the process which have led to it. It all started when I choosed the place together with the municipality of Uppsala. I have been doing research and analyzed how the place and it´s existing lighting works both during different times of the day and also in the evening. After researching the place and it´s existing lighting I´ve decided to put up the following goals fot the new lighting design. 1. The general light level of the place shall be experienced as higher than today. 2. The light level of the place shall be adapted to the light levels of surrounding places. 3. The lighting shall be free from glare. 4. The lighting shall be adapted to people passing by. 5.The lighting shall be adapted to the surrounding architecture. 6.

The town square is an important public space and is often described as the city´s living room. By creating a lively city center a sense of security is developed among the citizens which makes them wanting to use the town square regardless the time of the day. One important meeting point in Gävle is the centrally located Stortorget, sited between Drottninggatan and Nygatan. The town square went through an extensive renovation followed by both positive and negative reactions among the City´s inhabitants.  The aim with the study was to investigate the main walking paths and meeting points as a planning support to Gävle Municipality in their work with a new city plan. By studying the pedestrian movement patterns at Stortorget, Nygatan and Drottninggatan, the main walking paths and meeting points during all hours of the day was obtained.

Several studies has identified the locker room experience as a potential deterrent for participation in physical education. Both psychological and physical issues arise due to several factors. Psychological issues include different kinds of verbal and physical violations, comparisons between pupils, feeling of vulnerability along with a stressful schedule. The physical environment can contribute to negative experience for pupils in terms of filthy premises and cold showers. These factors may contribute to higher absentee rates in physical education.

Syftet med studien är att få en djupare förståelse för hur lunchmåltiden ser ut på förskolor med olika pedagogiska inriktningar. Detta får vi genom att undersöka om man kan se spår av dessa under måltidssituationen. I studien tar vi även reda på vilka spår av Lpfö 98 som framkom under lunchsituationen. Inriktningarna som ingår i arbetet är Montessori, Reggio Emilia och ?I ur och skur?.

In the post Cold-War era, world politics was transforming itself through its emerging complex issues such as terrorism and influential and interdependent actors such as the European Union. In this new era, the European Union was developing its Common Foreign and Security Policy pillar both to present a coherent and unified EU policy and to prove its political potent in order to become an influential actor on world politics. On the other side, security environment was also transforming its content through emerging actors and issues. As one of the most prominent actors of the world politics, the EU was influenced by the transformation of security environment, whose economic ?soft power? proved necessary but insufficient for being a global power in this emerging security environment.

Beredskapsenheten på länsstyrelsen i Värmland driver ett projekt om risk och sårbarhetsanalyser i länet som benämns ?Säkerhet i Värmland?. Detta examensarbete studerar skogsbränder utifrån ett riskperspektiv och är ett led i projektet. Målen med studien är att åstadkomma en riskmodell för skogsbränder som kan användas vid planering på lokal- och regional nivå i samhället. Studien delas upp i två delar.

The company Olofsfors AB manufactures drive belts for forest machinery, known as ECO-Tracks, and abrasion-resistant steel and cutting edges for graders, excavators and tractors, known as Bruxite and SharqEdges. Manufacturing these products requires the steel to be heated and molded, then submerged in water and hardened. The water used in the hardening of steel is pumped to the process from pits below the floor and then pumped back to the pit after it?s been used. Since the temperature of this water rises after being used to harden the steel the temperature of the pumping pit needs to be adjusted to maintain its setpoint of 21°C.

The scope of this project is to make a comparison of costs associated with wind and nuclear power in order to decide which one of these is the most suitable in the case of an increased demand for electricity. It is also investigated if there are other factors that can influence the choice of energy source.An average cost is calculated in terms of kronor per kilowatt-hour (SEK/kWh) using cost of investment, operation & maintenance and taxes & subsidies. Total investment cost is recalculated to production cost using the annuity method at three different interest rates (6%, 9% and 12%).The comparison is made between three cases of wind power and two cases of nuclear power. For wind power there are two ocean-based (300MW and 100MW installed capacity, respectively) and one land-based (60MW) wind farm. For nuclear power there is one EPR-reactor (1600MW) and one AP1000-reactor (1100MW).