This thesis takes as its starting-point the different stands on the ever ongoing growth of multinational corporations (MNCs) and its consequences. Two opposing branches of theories, arguing that the establishment of MNCs in developing countries is good respectively bad for these countries, are tested for the aspect of state capacity. A quantitative method is then used to test if there exists such a relationship at all and if so, which of the two notions that are right.The presence of MNCs is measured as FDI of GDP while state capacity is defined as a combined index for three of ICRG's Political risk indicators. The two variables are analysed, mainly by cross tabulation, using an extensive dataset of 130 developing countries measured for a period of 20 years.The outcome is though ambiguous: No solid correlation can be found, but countries with a higher rate of FDI of GDP tend to have a slight worse rate of state capacity throughout the analysis. Thus the result points in favour of the notion that MNCs are bad for developing countries? state capacity.

During the 19-century a global warming has been observed, which includes increases in global air and ocean temperatures, widespread melting of ice and snow, and rising global sea level. There is a clear connection between emissions of greenhouse gases caused by the human and the increase in temperature. Climatic changes caused by global warming can be stopped trough decreased emission of fossil fuels, for example by an increased use of biogas. Biogas is a renewable energy source which is produced through anaerobic (oxygen free) digestion of organic material. The gas is a mixture of methane (CH4) and carbon dioxide (CO2) and can be among others used as fuel in vehicles.

The aim of this paper was to investigate how 40 typical speakerswith Finnish accent, aged 65-84 years, performed in speech assessmentthrough Dysartribedömningen, a Swedish dysarthria assessment instrument.Their results were compared with results of a matched Swedish nativespeaking reference group. Both groups were assessed in areas offunction/structure, prosody/intelligibility and through a survey oncommunication. Results indicated that the performances of the Finnishparticipant group were estimated as more deviant than the Swedish,considering all areas. The Finnish participants were deviant in articulationand they had a significantly lower speech rate in reading. They also hadsignificantly lower scores in intelligibility compared to the reference group.The results of the survey of communication showed that the Finnishparticipants estimated their levels of activity and participation to besignificantly more limited compared to the reference group.

Uppsatsen är producerat och examinerad under 2007.

AbstractSAAB has for a long time used user controlled pilot models in ARES. ARES is a simulation tool used in the desktop environment for simulations and calculations of the JAS 39 Gripen fighter and other aircraft. ARES stands for ?Aircraft Rigid body Engineering Simulation?. To work with these pilot models has been both time-consuming and inefficient.

This thesis has been performed at the system development company Verendus System AB, together with the home care company Basic Care Unit (BCU).The thesis has consisted of developing a web based informationsystem for BCU in which they can administrate their business. At the time of writing this thesis, BCU was using a windows-application to administrate their activities, which was both costly aswell as resulting in an unnecessary burden. The aim the thesis has thus been to create a platform-independent information system that simplifies and streamlines BCUs work by being user-friendly aswell as imposing some simplifying features.The students has been developing the system by the help of a work method they themselves developed. The method consisted of working in several iterations that each had several milestones. The method resulted in the students knowing easily when each iteration was finished or not.The thesis resulted in a working platform independent prototype.

A new type of device for measuring thev m& ?rate of fuel sprays from a diesel fuel injector has been developed and the various steps in the development are described. The device works by deflecting all of the sprays from the injector at the same time by using a bell shaped deflector. A load cell consisting of a machined steel part with strain gauges mounted on it measures the resulting force. The shape of the curvature in the deflector bell shape has been evaluated by photographing the flow in a 2D?version of the curve shape.

AbstractThe Northern Wheatear (Oenanthe oenanthe) is a small insectivorous passerine bird living in open landscapes. Both parents feed the brood of approximately five chicks, but little is known about how each sex allocates their feeding effort. In this study I investigate feeding nest visit differences between male and female Northern Wheatears relative to the age of the chicks, the number of chicks and the quality of the territory for 17 pairs from 2008-2010. Data were collected using automated data loggers to record nest visitation rates during chick feeding, and the sex was determined from nest video cameras. I also examine if the parents? rate of feeding visits changes over the nestling period.

The southern part of Sweden, Skåne, is frequently exposed to storms causing great damage to Norway spruce (Picea abies L. Karst.) stands. A storm during the winter 1999/2000 raised the attention of the problem. A lot of forest owners got large areas of spruce stands wind thrown during this storm. Can naturally regenerated birch (Betula sp.) be an alternative on these wind-exposed sites? This was the main question I was facing when discussilig the problems with Esben Möller Madsen, Söderåsens forest district. The aim of this master thesis was to present an economic analysis of Norway spruce versus birch.

The aim of this work is to demonstrate how the net present value (NPV) at the time of the first thinning depends on the spacing after pre-commercial thinning, and show how net value from first thinning in same stand is influenced. This study is performed with models based on non-distant dependent growth models for single trees. Two different growth models have been used, one for cleaning (pre-commercial thinning) and one for thinning. The first one yields stem density distributed over diameter classes. In the second one, (the thinning model), it is possible to choose when thinning should be done, the thinning method, thinning grade and numbers of thinning.

In the last few years people have become more and more aware of how humanity is affecting the climate. In the direction of reducing the greenhouse gases is to design engines with higher tensile properties and reduced weight, in order to achieve lower fuel consumption and cleaner fuel incineration in today's truck engines.In order to achieve these requirements it?s necessary to increase the combustion pressure in the engine. This requires higher tensile properties and high thermal conductivity of the engine material. The department of Component Technology at the University of Jönköping in collaboration with Volvo Powertrain AB, Scania CV AB and DAROS Piston Rings AB has been commissioned to develop this material and to find knowledge of material properties used in truck engines and piston rings used for marine applications.The purpose with this work is to analyze the tensile properties of a series of cast iron, cast under different metallurgical conditions.Four different series of cast irons have been analyzed from four points of view, carbon concentration, nodularity, amount inoculation and cooling rate.After the tensile test all specimen data was analyzed in a mathematic calculation program called Matlab 2006a.

AbstractPrevious studies have shown that wild smolt have 2.5-4.5 times higher survival rate than smolt grown in culture and that starved reared smolt behave more like wild born smolt. The purpose of this project was to study whether there are differences in migration patterns and survival during migration to the coast between wild and reared smolt and between different types of reared smolt.In 2009, 25 smolts in three different groups were tagged with acoustic transmitters: Wild Born, conventionally reared 2-year and 1 ?year old smolt. For the 2010 trial there was also added a group of reared 2 ?year old smolt that were starved before release.

Four different kinds of filter-materials with reactive surfaces have been studied concerning their capacity to absorb heavy metals in leachate from a municipal waste deposit. The heavy metals studied were: lead, cadmium, copper, mercury, chromium, nickel and zinc. The leachate contains high levels of dissolved organic carbon (DOC) and has a high pH-value along with a high buffer capacity. These characteristics of the leachate make it difficult to remove pollutants and require efficient filters. The filters that were examined in the report are blast-furnace slag with CaO, sand covered with iron oxides, olivine and nepheline.

AimThe purpose of this study is to compare the level of activity between playing wii Sports Tennis and wii Sports boxing, and the usual sports, and to see how the two variants are perceived.Issues:- How much strain ratio and energy consumption it gives to exercise wii sports compared with the playing of sport for real?- How do the test participants experience the different tests?- How are the two wii sports games against each other in terms of activity and fitness in the school environment?MethodThis is an experimental study in which 10 test participants (5 men and 5 women) have carried out four different physical tests. The tests consisted of either playing an exergame or playing a sport for 25 minutes. Physical activity was measured during the test using a heart rate monitor. All test participants completed all tests in the same order.

The aim of this study was to investigate whether a direct shift inpostural alignment results in changes in voice source characteristics. Ninemales with untrained voices were recorded standing in ideal posturalalignment and in the deviant postures swayback and kyphosis characterizedby extended hips and a slump back respectively. The voice source wasderived from the audio signal by inverse filtering. The parameters pulseamplitude, maximal flow declination rate, level difference between the firstand second voice source partials, closed quotient and the normalizedamplitude quotient in relation to subglottal pressure were compared betweenideal postural alignment and swayback and kyphosis respectively. Resultsindicate an impact of changed postural alignment on the voice source.Swayback posture gave significantly less pulse amplitude and maximal flowdeclination rate and significantly higher subglottal pressures thus resulting ina less effective phonation.