The E-department at GETRAG All Wheel Drive in Köping have problems with the efficiency on parts of their production equipment. The equipment with the most significant efficiency problems are four automated multifunctional production cells that produces housing for rear drive units. The major part of the problem is the large amount of small stops that causes the low efficiency.The department already worked with logging of interruptions and efficiency calculations before this project started. However this work was not done to the extent considered necessary for a systematic follow-up of the interruptions.The aim of this paper is to point out a more effective and systematic way to work with logging of interruptions and the follow-up. In addition the equipment were studied with a method for efficiency calculation that ? if used properly- is a more powerful and a visually better method than the one used by the company today.As the initial current state analysis of the equipment was made a lack of documented knowledge about the equipment was discovered.

The fork lifter chipper truck is a concept which has been developed for harvest and transport of bio fuel. The system consists of one fork lifter chipper truck and 1, 2 or 3 transport lorries, usually two, which serves the fork lifter chipper truck. The system is driven by the fork lifter chipper truck that produces chipped material into a container on the truck. When the container has been filled the truck drives to the landing site where it?s offloaded.

Forest enterprises have always searched for ways to improve efficiency. For the past few years there has been an emphasis on stock-keeping levels. Increased demand for fresh round timber and the need to decrease the amount of tied-up capital has made the forest industry reduce its inventory levels. This has brought on a higher demand on the timber supply from the forest management districts concerning both delivery in time and assortment output. As a result, the flow of timber has fluctuated a lot with serious consequence for the timber supply during 1994.

Holmen Skog is currently using a GPS-program called TraktInfo, originally developed within the company. They are now planning to switch to a new GPSprogram or allowing the contractors to buy other programs available from the logging equipment manufacturers. To be able to offer this flexibility, Holmen Skog needs to obtain information about the features offered by the different manufacturers in their specific programs, and also when the manufacturers are planning to start selling programs adapted to the new standard called StanFord2010. According to the study, the manufacturers are hesitant to StanFord2010 and there has also been a lack of clear signals from the customers and clients about what kind of different new features to include in the programs. The feature most frequently used by forest machine operators today is the option to keep record of the harvester?s path by creating a ?log plot?. This feature was not used to its full potential however, since only one out of eight of the forwarders included in the study had computers that were compatible with the harvester?s computer.

Background: IT-security is included in the concept of information security, which considers all the security of handling information within an organisation. Good IT-security is about finding the right level of measurement, however, it is hard to implemement new IT-solutions in an organisation, particularly within the health care field, where sensitive information are handled daily. Lately the Swedish government, together with county- and city council, understand the importance of IT and health care. Carelink, an organisation of interest, is working actively for the presumption of benefit by using IT within the health care field. During spring 2006 the Swedish government introduced a national IT-strategy.

The reduction of coarse, dead wood is considered to be the biggest threat to flora and faunain boreal forests. Extensive harvest of logging residues would increase this reduction evenmore. However, the role of dead wood created at final felling for boreal, epixylic species isstill largely unclear. It is therefore of interest to examine whether epixylic species inhabit thedead wood in young, boreal stands, especially species considered to be confined to forests inlate successional stages.The aim of this study was to investigate whether forest-interior species in fact can inhabitearly-successional forests arisen after logging. The study was conducted in young standsbordering dead wood rich woodland key habitats.

This study aimed to investigate written and oral narrative in adults. The participants consisted of 30 subjects aged 32-79 years. They produced one picture elicited and one free narrative, both written and orally. The written narratives were recorded in a keystroke logging program and the oral narratives were transcribed orthographically. Data from all the narratives were analyzed according to: number of words, words/minute, active writing time, total process time, number of characters and number of characters in the final text.

A high amount of dead wood is one of the most important prerequisites for high biodiversity on forest land in Sweden. Dead wood is most abundant in young forests, thinned forests, woodland key habitats and protected forest land. In old-growth forests most of the dead wood consists of logs and snags, whilst in managed forests a huge proportion of dead wood is made up of logging residues like stumps and FWD, fine woody debris (< 10 cm diameter). All these different types of dead wood may serve as substrates for epixylic bryophytes and lichens. However, few studies have been conducted on the relative importance of these different fractions of dead wood for the occurrence of bryophytes and lichens, especially when considering dead wood on thinned forest land.

Since some years Linköping has invested in biogas production, mainly from offal's, residuals from food industry and manure. The municipality goes for biogas in the local traffic and in all transportation. It is also possible for private car owners to run their cars on biogas. The purpose of this essay is to perform a cost-benefit analysis and examine if the project has been beneficial from a social point of view. The effects have been identified, measured and monetarily valued. The essay is limited to include the year of 2006 only.

The annual demands for forest fuels increases in Sweden. At present, large unutilized biomass resources is found in young, dense forests from which about five million oven-dry tonnes (ODt) (23 TWh) could annually be extracted as forest fuel. But harvesting small trees give high logging costs and new cost-efficient harvesting techniques are therefore required. The aim was to study the productivity of Vimek 608 BioCombi in forest fuel thinning of Lodgepole pine and to calculate the economy of the harvesting and estimate the thinning quality. The time study was performed in Åmarken in the county of Västerbotten.

The aim of this study was to provide SCA Forest Norrbotten District with material to assist in their work towards decreasing the frequency of bucking splits in their saw timber logs. SCA Forest supplies the Munksund sawmill with pine timber. Periodically the sawmill experiences problems related to bucking splits in their logs. The purpose of this study was to find an available method to measure the occurrence of splits directly on incoming timber. The ambition was also to gain some knowledge about possible variations between different logging crews in terms of split frequency. If possible, this information could be used to investigate if certain crews produced more splits than others, and thereby making it possible to provide feedback to the logging machine operators. The study consisted of two major parts, a literature review, and a practical sawmill study.

The global Positioning System (GPS) provides location and time information as long as there are unobstructed lines of sight to four or more GPS satellites. However, when this is not the case the signal may be inaccurate or sometimes even completely blocked. In these situations the Inertial Navigation System (INS) is an appropriate choice for positioning.  An INS has already been proposed in a previous thesis by Erik Andersson and the objective of this thesis is to fuse the GPS with the INS in a proper way. A part of this project is to decide the reliability of the GPS.Three methods for GPS reliability detection have been proposed. One method based on the statistical properties of each of the separate systems, and two methods based on the statistical properties of the residuals between the GPS and INS.

As a student during my studies, I have been told about entrepreneurs who have red numbers in their financial statements, and there is a forest machine operator shortage in Sweden. The basic idea of this thesis was to examine the underlying factors that may have caused the problems described above. The aim of this thesis was to investigate the factors that create stress and job satisfaction as a forest machine operator. The study was performed as a comparison between forest companies own harvesting teams and entrepreneur teams to investigate if there are any differences in stress and job satisfaction between the two different types of team. The study was conducted in collaboration with SCA Skog. The material for this study was collected by doing interviews with SCA's harvesting teams. A total of 27 forest machine operators were interviewed, divided into a total of 10 separate harvesting teams. It was very similar between the different type of teams, which situations the operators experienced stress.

Profit in first commercial thinnings of today is hard to achieve. This is because of prevailing pulpwood prices and because of high costs of logging and transport. To reduce these costs higher productivity is advocated. One way to increase the productivity is the use of multi-tree handling harvester heads. The aim of this study was to calculate logging and transport costs in first thinnings, where multi-tree handling has been used.

Illegal logging and its related trade is of great concern around the world. The European Union Timber Regulation (EUTR) is a regulatory approach by the EU to prevent illegal timber and timber products to be placed on the European Union inner market. This means the regulation affects both actors in the member countries as well as the actors exporting timber and timber products to the EU from non EU member countries. This study aims to study the implementation process of the EUTR in Bosnia and Herzegovina (B-H), and its preconditions. Institutional theory is used to understand and explain how the EUTR affects B-H organisations? business environment, and how the organisations choose to respond to the EUTR.