Flow measurement is one of the greatest challenges in order to calculate efficiency in hydropower. Most hydropower plants in Sweden use differential pressure methods for flow measurement. These methods are dependent on constant conditions in the waterways. A change in these conditions, like turbine improvements, prevents differential pressure methods to verify efficiency improvements. Since efficiency improvements can?t be verified by one measurement system, another method, which isn?t affected by changing conditions, can be used.

Syftet med vår studie är att undersöka de problem som kan uppstå vid en överföring av ett styrinstrument, innehållande Key Performance Indicators, från en organisation till en annan i samband med förvärv. Uppsatsen utgår från en fallstudie av ett företag i kemibranschen. I vår fallstudie använder vi ett abduktivt angreppssätt och en kvalitativ metod. I den teoretiska referensramen utgår vi ifrån teorierna om The Balanced Scorecard och Key Performance Indicators. Empiriinsamlingen har skett med semistrukturerade intervjuer..

Too much attention has been given to mainstream approaches in performance management and management accounting research, without taking in to account changes in the environment with the rapid growth of online retailing. This paper evaluates how and/or if performance management differs in online contexts by using a conceptual model developed by Ferreira et al (2009). The model and its components are tested on three multichannel- and six e-commerce businesses. The result and its analysis is commented on by two e - commerce experts. The result shows that the operation method of the models twelve components do not differ in terms of work methods in online and offline contexts.

Ribs from sheep, goat and pig are rarely assessed  to species due to the fact that they are very similar in their morphology and size. The ribs are instead considered unidentifiable although it is possible to see what kind of bone it is. If these ribs would be identified to species not only would species assessment degree of archaeological source material   increase, the relationship between meat-rich and meat poor regions would change.To find out whether there are morphologically measurable differences between sheep, goat and pig ribs, three measurement points on each rib has been defined and measured. At each measurement point two measurements were measured, one medial-lateral measurement and one cranial-caudal measurement. The ratio between the medial- lateral measurement and the cranial-caudal measurement was calculated for each point.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

Together with NCC and Sweco we measured the air-flow on a semi-detached house in Jönköping. When a pressure measurement is made, the house gets exposed to over- and under pressure. This is done in order to examine the houses climate shell. The climate shell of the semi-detached house we tested exceeded the required air thickness in BBR-2002, hence, measures have to be taken.This report also displays the importance of building air thick houses and what consequences a non air-thick house can have for the ones residing the house. A discussion of different measures is on for the addressed problems with the flow-measurement and the alternative construction-solutions.Furthermore we have described in this report of how to account for the performance of the air pressure, what kind of equipment we used and how we came up with the results.

Performance of an intersection affects the total travel time in a traffic network. An intersection with good performance can easily be described by its contribution to lower travel time than in a comparable intersection. The travel time is of importance in the cost calculations when a specific intersection is to be chosen and designed. It is important to be able to make correct and precise performance calculations so that the cost calculations will not be incorrect. For that purpose the software Capcal, which is a traffic model for intersection analysis on performance, is used in Sweden.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

The purpose of this thesis is to identify the factors that drive efficiency and effectiveness in technical development projects performed at A?F?s department of product development. In addition to identifying and analyzing these factors, the thesis also analyzes what needs to be taken in to account in order to implement a measurement system that is able to both monitor and control the identified factors.The thesis has been performed in a qualitative manner. It is based on interviews with people from several different technological companies, within different lines of business, all of which are customers to A?F?s department of product development.The results show that there are seven critical factors for project efficiency and effectiveness.

Caran has a strong belief that women leaders affect the financial profitability positive. Since women leaders are intangible resources it is very difficult to calculate its exact value. The authors found that one of their measurement methods can’t be used to calculate the value of women leaders. The other measurement method can calculate significance between women and men leaders and provides an index to be compared to other groups. But there is no prove that women are better creating value than their men colleagues, the figures indicate that women add more value due to their lower wages.