This Master thesis is about a postal- and telegraphic building in Eskilstuna, Sweden. The construction methods for the specific building and buildings in general from the same time are described. The purpose of the report is to describe the loads acting on the building and how it has been built and why it has been rebuilt during the years. After this, possibilities of reconstruction and adaptation for today?s demands can be evaluated.

Roughly 130 000 dwellings have been officially registered since Norway as of summer 2009 passed their bill ?Energimerkeforskriften? on energy performance certificates in buildings. The main objective is to decrease the total amount of national energy consumption by producing a methodology of calculation of the integrated energy performance of buildings as well as proposing cost effective measures to lower each building?s energy consumption. As the measures should not contravene nor be incompatible with the intended quality and character of the building, the ?Energimerkeforskriften? exempts buildings that due to their historical and cultural values are protected cultural heritage legislation. The current system offers a couple of professional certification alternatives, but when two online semi-automatic methods developed specifically for non-professionals are by far the most used, and since the methods of calculation primarily have focused on modern building materials and construction, the rest of the historical building stock stands literally unprotected by incorrect performance certificates and high-risk energy efficient measures. The objective of this thesis is to identify if the current Norwegian energy certificate system poses a threat to older buildings.

The objective of this work was to introduce measures to reduce energy and water demand at Gävle Söder 17:10. To succeed, this energy audit has been made. The work is based on collected statistics from the property owner Norrporten, measurements, literature review and through consultation with experts in the field. Two models, one for each building, have been created in the simulation program BV2 to estimate the potential of energy measures based on the collected information. The models in BV2 have been verified against the statistics of the energy consumption.With the help of calculations and simulations, seven cost-effective measures have been identified.

The housing sector of today represents for almost 40% of the energy consumption, an energy consumption of which the major part consists of non-renewable energy sources. This is not sustainable and utilization of new energy-efficient technologies in buildings can be a step in the right direction, towards a sustainable energy society.This report has been made on behalf of and in cooperation with Älvstranden Utveckling AB in Gothenburg to examine how future energy-efficient technologies can affect the energy demand in energy-efficient multi-dwelling buildings.The report is based on Älvstrandens passive house, Hamnhuset, a house whose energy consumption is far below the BBR's requirements. The report looks at the opportunities for improvement within windows, insulation, solar energy technologies, as well as white goods. Computer simulations are then made to apply the selected technologies into a reference building. Technologies are selected from an energy efficient perspective and no account has been taken of other aspects such as the economy.

Title: Kvarteret Tvättstugan, an apartment building with massive wood construction. A thesis about acoustic and fire requirements and a comparison of energy and moisture aspects. Earlier restrictions in the Swedish legislation have resulted that only a small percentage of the apartment buildings that have been built are designed with a massive wood construction. It has been allowed to build unrestricted with wood since 1994 as long as the function of requirements are fulfilled. This change in the rules together with the great environmental benefits of wood has led to that more companies choose to build apartment buildings with wood. One of these companies is Folkhem Production AB.

This diploma work was performed because the company Sveriges BostadsrättsCentrum, with the abbreviation SBC, had a need to gain insight into how changes in the Work Environment Act and related regulations which took effect January 1, 2009 affecting their work with the work environment. The changes mean that the client may hand over his work environment responsibilities to a contractor and that he has to select so-called building work environment co-ordinators. At SBC they are working as representatives for tenant-owner's association when a construction is about to be carried out. The purpose was to ascertain how changes may affect the work at SBC. The diploma work intends to educate the staff at SBC how work with the work environment would look like if they met the regulatory requirements.

The purpose of this master thesis is to investigate different types of measures for making buildings more energy efficient and to estimate their profitability. The calculations were performed with the Building simulation program VIP+ and the evaluation of the profitability with the life cycle cost method. Furthermore, it was examined how losses in the distribution of secondary systems of district heating can be avoided. Options to replace district heating with a local district heating system based on bio-energy have been investigated. The possibilities of achieving more efficient thermal energy consumption and production for the chosen estate were also examined.The object of the study has been a residential estate with 133 detached houses in Uppsala, built in 1974.

When constructing a building, a number of aspects must be harmonized in order for it to fulfill requirements ? a building must fulfill requirements such a load-bearing, conservation of energy and a good indoor environment by means of, among other things, moisture proofing .Moisture problems in buildings can affect health negatively. As we are increasingly staying in indoors, demands on a good indoor environment are higher.This work starts with examining moisture problems in slab-on-ground solutions, and then links the various scenarios to moisture problems in a concrete slab of a real building. The building with moisture problems is located in Årby by in Borlänge and moisture damage was found in the slab at an apartment adjoining wall.By reviewing literature written within the field of moisture problem, making hand calculations and modeling in the program Comsol Multiphysics, judgments are made to find explanations as to why the rise of moisture occurred in the building in Årby by.Generally, the following guidelines may be used to reduce the risk of moisture problems in slab-on-ground constructions:Drying of construction moisture before laying the floor material.Using draining layer beneath the slab, to prevent capillary suction.Using insulation under the slab, partly for comfort and to establish the temperature difference between the ground and the concrete slab.Avoid direct contact between the wood and concrete, due to degradation and fouling smells that normally occurs.If necessary, use additional vapor barrier.In addition to the above, there are various methods for moisture-proof and moisture-monitoring by design or by the method ByggaF suited for the entire construction process various events..

In the spring of 2014 Sweco Systems AB were commissioned to design a ventilation system for a newly built preschool in Linköping. Terms from the client was that it cost efficiency would cope with the energy demands that are placed on the building. The unit chosen was a cross-flow heat exchanger, and this work is to compare it with two other heat exchangers to see if a more energy and cost efficient could have been chosen. The heat exchangers that was chosen for the comparison was a rotating- and a counterflow heat exchanger. Simulations have been made to the different heat exchangers by the manufacturers.

This thesis aims to increase understanding and knowledge of issues affecting the redevelopment of older office buildings to housing. The rising demand for housing in recent years has resulted in a need and an increase in cost housing projects. The need has led property owners wanting to build old office buildings to apartments. The case study is carried out in Lycksele town and in close contact with consultancy TM (Technician Mercantile) ? consulting, which has operations in the area.

Lack of political interest and will to deal with human rights violations carried out under the civil- military dictatorship, has characterized the transition and post-transition in Uruguay. The systematic use of torture, arbitrary imprisonments and forced disappearances in the relatively small country created a culture of fear that has been present through out the post-transition phase. Human rights groups have been central actors in the fight for truth and justice and against impunity. This study analyzes how these groups multiple democracy-building functions have contributed to democratic development. It also analyses how the democracy-building functions have been constrained by the political context.

By using industrialized building, pre-installed modules can be delivered to the construction site where they are easily mounted. This method has many advantages compared to on-site manufacturing, for example, the precision during the production process should be much higher than building each wall and floor on site. Furthermore, the quick erection procedure when using prefabricated elements and the possibility to use weather protection has the advantage of not being dependent on weather conditions, and many other factors.Masonite Beams AB is a Swedish company (a member of the Norwegian company, Byggma ASA) with a relatively new technology using light weight beams as bearing elements in the walls and a certain stiff board lamella slap which is mounted on the top of the floor structure creating an integrated stiff beam / board floor structure. The elements are flat which make it much easier to transport the elements from the factory to the building site where the building parts are easily mounted with special mounting stud.One of the main drawbacks of lightweight structure is the sound transmission. The main topic is low frequency annoyance, however the complex structural elements and their mutual sensitive connections other acoustical problems might appear.

Syftet med det här examensarbetet är att undersöka om det är möjligt att överföra hallbyggnadsteknik till produktion av småhus för att sänka produktionskostnaderna. Studien visar att hallbyggnadsteknik enkelt går att överföra till en villa. Dessutom blir det billigare att bygga klimatskalet med vårt byggsystem jämfört med ett traditionellt prefabricerat småhus. Genom detta system kan den totala byggkostnaden för villan i jämförelsen sänkas med 3-10 % beroende på vilket fasadmaterial som väljs..

There are many factors in a building project that has to collaborate with one another in order to reach the desired end result, how you work with moisture issues in timber is a very important one. While constructing Varbergs Hospital, the building company Skanska came in contact with the issue of extra high demands on the moisture content in timber. What they requested from us was a moisture program in which you clearly could follow the routines regarding work with moisture in timber. The aim is to use this program as a help during the work, in order to achieve a good result.We have developed this study in addition to the moisture program. The aim is that this study will give you a deeper understanding of the important factors to consider.

I denna rapport presenteras ett existerande system som kan hantera paketerade program (?building blocks?) modulärt. Systemet tillämpas på produkten iipax. Ett building block är en enhet (?plugin?) som kan förflyttas mellan iipax-projekt.