Since the 19th century the concentration of CO2 in the atmosphere hasincreased by 40 percent as an effect of the use of fossil energy sources.Increased concentration of CO2 will likely lead to increased temperature,changes in precipitation, rising sea level and increased frequency of extremeweather like storm events. A step to reduce emissions of CO2 and mitigateclimate change, for the property of Tagel, can be to adopt new silviculturalstrategies and analyse which is the most effective. As a result of that, threescenarios was produced, business-as-usual (BAU), increased set aside landand energy. An introduction of windpower at Tagels estate (property) andeffects on carbon balance was also examined. By using the Heureka systemand LCA-analysis in this study, it showed that the scenario of increased setaside land was the most efficient way to reduce carbon dioxide (CO2)emissions for the analysed period of 100 years.

To save energy it?s popular to build houses with low energy loss. In these houses the walls are keeping a lower temperature in the external side which leads to a higher relative humidity. In addition more material, such as wood studs, are used which means that there is more moisture to dry. More moisture in combination with higher relative humidity may pose a higher risk of microbial growth.

This literature review summarizes available data on infection with the parasitic roundworm, Ascaridia galli, as a cause of disease in poultry, including the consequences of a conversion to alternative production systems. Ascaridia galli has a direct life cycle with resistant eggs that survive and are easily spread in the environment, especially in systems with bedding materials where the faecal contact is high. The infection is usually subclinical but depending on the infection dose, the symptoms range from weight loss and diarrhea to mortality. Factors such as the feed composition and genetic variation among different hybrids clearly affect the establishment rate of the infection. Ascaridia galli will probably become an increasing problem, with a shift from the traditional battery cages to alternative systems where the risk of re-infection is high.

This report was written by Lisa Bengtson and Hanna Paradis and describes the degree thesis "Environmental impacts of solid waste treatment in the Metropolitan Region, Santiago, Chile ? a comparison between current system and incineration with energy recovery". The purpose of this thesis was to investigate if incineration with energy recovery could be motivated through an environmental perspective as an alternative to landfilling of solid waste in Santiago, Chile. The study was performed with Life Cycle Analysis as a theoretical base. In Santiago, situated in the thirteenth region of Chile, Región Metropolitana, lives 6,5 million inhabitants. The major part of the solid waste produced in the region is landfilled on three different sanitary controlled landfills situated outside the city center.

Swedish energy policy aims to increase the use of energy from renewable sources and this should be done in a safe, environmentally and sustainable manner. According to the Energy Agency the use bio-fuel increased by 73% between 1990 - 2006. Stands with high share of slash are often located on areas with high productivity which often are located on soils with poor bearing capacity. This will increase traffic on susceptible soil leading to increased ground damage. To reduce the risk of ground damage at slash-forwarding, ground protection is needed.

To curb greenhouse gases and mitigate climate change is one of the biggest challenges human society face today. Carbon dioxide (CO2) has accumulated rapidly in the atmosphere as a consequence of burning of fossil fuels and deforestation. The aim of this study is to explore two methods to store carbon dioxide in geological formations and biological sinks. The aim is also to discuss the two mitigation options from a sustainable perspective and whether it can lead to a better environment and benefits for local and global societies. The research questions are: Which method to store carbon dioxide, geological or biological, is the most effective? Which method to store carbon dioxide, geological or biological, has the greatest potential to promote sustainable development for local communities?The method used is a comparative case study and presents four case studies that explore the potential for CO2 storage offshore in Norway and Brazil; and in tropical forests in Mexico and Brazil.

This report describes the master thesis project ?Weight Optimization of a Composite Chassis for a Multimodal Lightweight Vehicle? which is a part of the Master program in Naval Architecture and a part of a research project at the Centre for Naval Architecture, KTH. Demands on smart and energy efficient transport solutions are continuously increasing. In the Stockholm region the citizens are expected to increase with 25% and the road vehicles with 80% until 2030, putting high demands on the traffic system. Using a small multimodal vehicle deals with this problem and uses both the land and waterways for transportation.

Swedish energy policy aims to increase the use of energy from renewable sources and this should be done in a safe, environmentally and sustainable manner. According to the Energy Agency the use bio-fuel increased by 73% between 1990 - 2006. Stands with high share of slash are often located on areas with high productivity which often are located on soils with poor bearing capacity. This will increase traffic on susceptible soil leading to increased ground damage. To reduce the risk of ground damage at slash-forwarding, ground protection is needed.

It is possible to affect the feed costs in different ways. By steeping or fermentation the digestibility of the feed is improved for the animals with a natural process in the wet feeding system Steeping means that the feed is soaked some hours before feeding. This process activatesenzymes and improves the digestibility of for example phosphorus in the feed and make it more accessible to the animal. Wet feeding can be fermented or not. Fermentationmeans that the feed has been soaked for a certain length of time so that a biological process is started.

AbstractThe OMX Nordic Exchange Stockholm requires all large companies to apply the Swedish Code ofCorporate Governance. A revised code will be applied from July 2008. The purpose of this paper is toidentify the accessibility of information on corporate governance and in particular how the compliance,concerning the Swedish Code of Corporate Governance in the perspective of an internet active generalpublic.This paper is a complete census of the companies at the OMX Nordic Exchange Stockholm whocomplies with the code. Each company website has been visited and a comparison between the sectorsat the OMX Exchange Stockholm has been performed.Results: 96% of the companies present the members of the nomination committee. 94% presents thenomination committees proposal of the company board members, though only 33% of the companies inthe Energy sector.

A computer model based on minimization of the free energy, capable to predict contact angles and spreading transitions between Wenzel and Cassie mode for drops placed on surfaces with different topography were implemented in matlab. Simulations were compared with experiments documented in the literature. These showed that reported transitions between Cassie and Wenzel mode can be explained by minimization of the free energy. In this report, a study on the possibility of constructing water repellent paper surfaces with a combination of treatment with octadecyltrichlorosilane and topography changes, is included..

Ocean Thermal Energy Conversion (OTEC) is a technology that utilizes the temperaturedifference in oceans between the warm surface water and the cold water at 1000 m depthto produce electricity. The purpose of this report is to investigate if OTEC with its synergiescould become a commercially feasible energy solution for a small island. A literature reviewis conducted to explore the different OTEC technologies and to what extent the threesynergies; fresh water, air conditioning and aquaculture, could be used. In order to calculatethe profitability of these synergies there is also a study conducted on the conventionalmethods and cost of fresh water production, aquaculture and air conditioning. A model is setup using a scenario of a small tropical Island with population of 100 000 people.

 Ett passivhus är ett hus som i stort sett enbart värms upp av människorna och elapparaterna som finns i huset. Särskilda krav för att få kalla huset för passivhus måste uppfyllas.Vi har gjort en enkätundersökning på tre olika passivhusprojekt för att utreda vad de boende tycker om inomhusklimatet. De utvalda projekten finns i Värnamo, Frillesås och Glumslöv. Enkätsvaren visar att de boende i Frillesås är mycket nöjda, medan mer än 50 % av dem som bor i Glumslöv tycker att det är för varmt på sommaren och för kallt på vintern. För att utreda om de olika konstruktionerna har någon inverkan på inomhusklimatet har beräkningar och simuleringar i datorprogrammen VIP+ och IDA gjorts.

Due to higher standards of living around the world, greater industries and larger infrastructures causes an increase of the global energy consumption. This harvest of energy puts a great stress on the global environment. With this development, it becomes increasingly important to utilize energy resources in the best possible way.Fans are components that are often used in the industry and in households. A common problem is that the fan is oversized. An oversized fan causes an excessive flow, which has to be adjusted in order to achieve the correct flow.

AbstractWe have been honored to work with a company called Frimeko AB. Frimeko is located in Halmstad where they make and sell furniture for school and office environment. Our task is to construct a new, more modern sewing machine table for schools. The task is to use the same function as before, ease the storage and production of sewing machine.Efforts to develop the new sewing machine table resulted in that we came up with an innovative design that the company is pleased with.During this project the group has used the method from ?Fredy Olsson Konstruktion? .