The primary function of a mixer is to keep a fluid in constant motion. All mixing applicationsrequire varying degrees of small-scale turbulence and bulk flow. The performance of asubmersible mixer is measured by the thrust that it produces, while the strength of the bulkflow is dependent on the total amount of installed thrust.In a mixer, the fluid quickly flows past the propeller, and as a result, the current is mainlyaxial. The fluid will also obtain a rotating velocity, or a swirl, though this is significantly lessthan that of the propeller. During the process, the total amount of energy increases in the formof static pressure and kinetic energy.

Hydropower is the largest renewable energy source available in today's society. Operation and production is handled by high-tech electronics. This thesis is done on behalf of Statkraft Sweden AB who wants to explore the possibility of replacing the hydraulic cylinder with an electric actuator, generally as well as a case of a small power station on the river Nissan. Whether it is the chaplain or francis turbine vanes are actuated by hydraulic cylinders. Because of Gustavsberg hydropower is inconstant operation, this report is based on power calculations, which are read and computed according to the available hydraulic diagram.

In this thesis a possible cost effective runner change of some of the units in the hydroelectric power station Olidan is investigated. The possibility to drive a unit at the same efficiency point through a change of the turbine shaft speed and the rate of discharge is tested. Furthermore the theories behind model testing, determination of efficiency increase from model to prototype and efficiency measurements shall be discussed and analyzed with Olidan as a starting point.A predicted curve has been built on information from model tests and field measurements on the existing runners and runner data from the test of the new model. The predicted curve shows the difference in efficiency between an existing runner and a modern one. It is the difference in efficiency that is used in the calculations that are to show whether changing to a pair of new runners will be cost effective or not.

Until the beginning of the 1900:th century the paper making process was handicraft. The paper machines that have been developed since then are as impressing in size as fascinating when it comes to the technique. The process has always been improved to give a better paper for lower costs, with as short manufacture time as possible. Stratified forming has been a reality since 1830. From the beginning it was applied to board and paperboard.