Toxic metals contaminate soil worldwide and thus serve as sever environmental threat. Therefore the purposes of this study were to investigate in which soil fractions that different heavy metals (Fe, As, Cu, Zn and Pb) could be found in contaminated soils and if it is possible to use Sieving as a method for decontamination. Soil samples were collected from three different locations, the Nasa silver mine, the Blaiken-mine and Svalget environmental station. The samples were oven dried and later on sieved into six different fractions 8mm, 4 mm, 0.5 mm, 0.250mm, 0.063 mm and <0.063 mm. The fractions 4 mm, 0.5 mm and <0.063 mm from each location were analyzed in an x-ray fluorescence detector.

This master thesis was made to investigate the possibilities of using the Matlab-basedsoftware Basegrain to determine grain size distributions of erosion protections onhydropower dams. Basegrain is a photogrammetric tool developed to generate grainsize distributions and other information about coarse flood sediments by analyzing adigital photo of the stone bed. The investigation was made by validating the ability forBasegrain to assess grain size distributions of various materials smaller than the blocksused in an erosion protection by comparing Sieving results or manual measurementswith the results obtained by the program. A statistical comparison was then made bycomparing the results from Sieving and the program. The possibilities of using thesame method on existing hydropower dams were then investigated by determiningwhether the method was practically viable or not.The results showed that Basegrain generated grain size distributions for coarse gravelthat were very close to the Sieving results.

During a fire large amounts of particles and unhealthy agents occur.  Polyaromatic hydrocarbons (PAH) and toxic metals are examples among many others. These agents have a capacity to bond to particles and when the fire is extinguished, the particles can be transferred with the extinguish water into the soil and to the groundwater.Recent studies in particles have been conducted. A study by Ulrika Iverfelt (2014) reviled that the particles from a fire contained large amounts of both PAH and metals, which is consistent with earlier analyses. Her column experiments with particles in the size ? 11 microns and ?100 microns in silica sand, reviled that the larger particles was immobilized because the transportation was influenced by Sieving or physiochemical particle and surface interactions.The transport of the particles in soil and groundwater is regulated by two main mechanisms: physiochemical surface interactions and straining.

The coproduct, dried distillers grains + solubles (DDGS) from ethanol production based on wheat contains much rumen degradable protein and fiber with low digestibility. To compliment this quality in an effective way a grass silage low in protein and much digestible fiber is needed. The aim of the study was to investigate the effects of adjusting the crude-protein concentration and fiber quality of the silage when feeding DDGS and of varying the inclusion level of DDGS, when feeding the adjusted grass silage, on intake, milk yield and composition, faecal traits and feed efficiency. Four different total mixed rations were compared. The normal grass-clover silage had a crude protein content of 17,8 % and an NDF content of 46,2 % of dry matter. The adapted grass silage had a crude protein content of 14,6 % and an NDF content of 52,9 % of dry matter. The diets were formulated to have similar nutritional content except for A + 4 which had a higher content of rumen degradable crude protein and a lower concentration of NDF.

The amount of various phosphorus (P) fractions in the sediment and the relationship between the amount of P and sediment particle size were investigated in a constructed wetland southwest of Linköping. Furthermore, the possible correlation between clay content in the sediment and distance from the inlet was investigated. Sediment samples were collected along three transects from the inlet to the outlet, with six samples in each transect. In order to measure the soluble P, an NH4Cl extraction was done. This was also analysed for total soluble P after oxidation with peroxodisulphate.

The amount of various phosphorus (P) fractions in the sediment and the relationship between the amount of P and sediment particle size were investigated in a constructed wetland southwest of Linköping. Furthermore, the possible correlation between clay content in the sediment and distance from the inlet was investigated. Sediment samples were collected along three transects from the inlet to the outlet, with six samples in each transect. In order to measure the soluble P, an NH4Cl extraction was done. This was also analysed for total soluble P after oxidation with peroxodisulphate.

The thesis has been made for NCC Teknik in Gothenburg. The NCC Corporation is one of the largest leading companies in Scandinavia within the construction industry. NCC is active throughout the whole construction process, where one part is to carry out soil investigations prior the construction of various buildings, for example residential buildings. NCC Technology wants to visualize the samples taken at the construction sites in 3D for clients, authorities and also internally to show in a simple and understandable way how contamination is spread out in the soil.The thesis includes the area of Limhamns läge in Malmö, previously an industrial area. The area has previously included a concrete factory and the contamination from that factory has lingered in the soil.

X-ray fluorescence (XRF) detection of heavy metals is a cost- and time-effective method for investigation of polluted areas. Compared to laboratory analysis, XRF analysis is limited by high detection limits and uncertainties in some situations. Preparation of samples is known to affect the results of measurements.The purpose of this thesis is to bring a deeper understanding of how different factors affect the results of XRF-analysis. A large number of measurements have been made with the instruments Niton XLt 700 and Niton Xli 700. Results from measurements of lead, zinc and copper have been analysed.This study has shown that a greater moisture content will give a lower measured concentration for the same sample.