Blast furnace is the heart of every steel plant. Steel production is based on the blast furnace process, as it is where the iron is extracted from the iron ore and turned into liquid iron, which will subsequently be used to make liquid steel. Therefore, without hot iron, steel can not be produced. Blast furnaces in this process are supplied among others with pulverized Coal. Raw Coal should be prepared for the blast furnaces in the form of fine Coal powder.

With higher prices for oil and increased focus on fossil fuels impact on the environment the heating sector are searching for alternative fuels. Pellets are a quite new product whose production has risen exponential in recent years. Today there are small-, medium-and large-scale users, where the large-scale consumers are the heating sector. The heating sector is mainly using oil to cover the increased demand during cold periods. The purpose of this study is to analyze the potential of pellets if it would replace thermal power plants oil and Coal. The study will also analyze the economic impact a conversion would mean for a heating plant and if the pellet is a reasonable substitute. 2008 statistics from the Swedish district heating association were analyzed and a calculation was performed to determine how many tons of pellets is needed to replace Coal and oil.

Sweden has a natural gas grid extending along the west coast, from Trelleborg to Stenungsund. There are also several smaller local networks where a planned natural gas pipeline from Skutskär to Hofors prompted the need for a comprehensive study. This study examines the linkages that exist in terms of technology and market of natural gas and biogas in Sweden. Sweden has set high targets for the future with ambition to become independent of Coal and oil as energy sources. Since 1985, a part of the solution has been import of Danish natural gas.

Australia is one of the largest producers and consumers of fossil fuels in the world. In a society where the effects of fossil fuels on global warming are constantly discussed, the nation?s production and consumption are subject to debate. Problems arise when negative aspects of consumption, such as emissions of greenhouse gases, are put in relation to an increased need of energy and economic growth. However, it is important to distinguish between different types of fossil fuels when it comes to their individual impact on the environment and to analyze the possibilities to increase the more environmental friendly ones.

Combustion of fossil fuels is today the dominating source of energy. During combustion,carbon dioxide is formed. The carbon dioxide accumulates in the atmosphere,which raises the global average temperature on earth through the so called greenhouseeffect. The only way to reduce the emissions of carbon dioxide from combustionin a Coal fired power plant is through carbon capture and storage (CCS).Post-combustion capture is a technology to separate carbon dioxide from the uegas after the combustion for efficient transport and storage. The steady state operationof Coal fired power plants with post combustion capture has already beenthoroughly investigated on a pilot scale, however much work remains to investigatethe plants dynamic operation.

Bath has been a part of human history for a long time. Today bathing/swimming inmunicipal pools is for people of all ages and it is possible to take swimming courses,exercise or enjoy recreation. The municipal indoor pool of Hogdalen in Sweden wasbuild in the sixties and has had problems with high levels of heterotrophic bacteria. Thefacility has two larger pools, one adventure park for young kids, two smaller bath tubsand a jacuzzi. To improve water quality UV light and Coal filter were installed inOctober 2009 to the already existing purification system.

I utvecklingsarbetet för att minska energiförbrukningen och variationerna i råjärnskvalitet genom effektivare PCI (pulverized Coal injection) har försök gjorts. Detta för att bidra med information om vilka förändringar som krävs för att minska stoftgenerering till följd av materialsönderfall och dålig förbränning i masugn. Stoft och slamprover uttagna under en försökskampanj från LKAB:s experimentmasugn (EBF) har analyserats för att jämföra vilka faser och kemisk sammansättning proverna innehåller. Under kampanjen har två olika kol (lågflyktigt kol A och högflyktigt kol B) injicerats med olika mängd och sätt att tillföra syret till masugnen. I slammet vid injektion med kol A och syreberikning genom lansen kunde kolet hittas i förening med kisel i SiC (kiselkarbid).

The report aims to describe the austenitic stainless steel Sanicro 25 from a thermomechanical point of view. The thermal and mechanical properties of the material make it suitable for use in Coal ? and thermal power plants. By the use of Sanicro 25 it would be possible to bring the efficiency of these plants up while bringing the carbon emissions down.A material model is created from material testing and validated through simulation in the finite element software Abaqus. The model that has been derived describes the material behavior during loading and stress relaxation for the first cycle in a thermomechanical fatigue test well.

In the last decade, member states of the European Union have adopted a range of measures to decrease the dependency on fossil fuels. This has led to an increased use of biomass in heat and power production. In some countries, the lack of forest resource has led to large scale power producers importing their biomass needs. Due to high energy content and homogeneity, wood pellets have become an internationally traded commodity used for large scale power production. The Baltic States have emerged as one of the largest wood pellet exporting regions in Europe.

AbstractElectricity consumption is a globally increasing problem caused by the high share of electricity produced in Coal power plants. These contribute to high carbon emissions when only about 1/3 of the heat generate electricity and the remaining 2/3 of the heat cools off. Combined heat and power plants (CHP) have high efficiency because they use the residual heat for domestic heating. The CHP plant often use fuels from renewable resources, giving them a lower carbon footprint, but are also depending on the heat demand. If electric powered products such as drying cabinets convert to heat powered products more environmentally friendly electricity will be produced by CHP plants, which can supplant electricity, produced from Coal power plants and reduce carbon emissions.

During 40 years of industrial production, from the end of the 1890?s until the end of 1930?s, Coal and wood distillation products were manufactured in AB Carbo?s tar factory along the River Gimån in Grötingen, in the county of Jämtland, Sweden. In accordance with the Swedish Environmental Protection Agency?s Methods for Inventories of contaminated sites, MIFO, the site in Grötingen has been identified as a potentially contaminated site. In order to determine whether toxic substances pose a threat to human health and ecological systems in the area, there was a need to investigate the presence of contaminants, their levels and potential for migration.

Solid waste management is one of the most essential functions in a country to achieve asustainable development. In India, it has been one of the least prioritized functions during thelast decades. The most common ways to treat waste in India today are open dumping anduncontrolled burning. These methods are causing severe environmental pollution and healthproblems. India is one of the world?s largest emitter of methane gas from waste disposal.Since methane is a strong greenhouse gas, even small emissions have large impact on theclimate.

One of the most common ways to produce heat and electricity in Europe today is by the incineration of waste or combustion of Coal. These materials can be very sulfurous and during combustion sulfur dioxide is produced. This is an environmental and health related toxic substance which is why power plants have strict regulations on removing it from the flue gas. Sulfur dioxide is removed from the flue gas by adding a limestone reagent. The sulfur dioxide reacts with the limestone and the synthetic product obtained is ?Flue Gas Desulfurization gypsum?.

With the expansion onto the international market almost a decade ago, Swedish energy corporation Vattenfall began it's breaking and burning of Coal on German soil. Criticism aimed at Vattenfall peaked in the mid 2000s with the revelation of large quantities of carbon dioxide emissions and the re-location of villages and graveyards in German states Brandenburg and Saxony. The purpose of this thesis is to show where the responsibility for these activities lie. By analyzing the history of, and the political debate surrounding, Vattenfall, I will show that the prevailing policies of right- as well as left-wing parties in the 20th century were all, regarding this matter, market oriented. I will also show that these market promoting policies made possible a situation where the transparancy of, and state control over, Vattenfall were close to eliminated.

Abstract I have made a Website called ?Art school? for Liljevalchs art Gallery, Culture administration in Stockholm and Culture school in Stockholm. It is with scholarship from these that this Website has been possible. The work whit the ?Art school? started in the autumn of 2005 and ended in May 2006 on distance from Stockholm towards Blekinge technology school in Karlshamn.