This master thesis comprises analysis and dimensioning of a keyed joint between a generator axis and a hub with aid from the FEM-software ANSYS Workbench 13.0.The generator axis is a part of a hydroelectric power station that generates electricity with a reactions turbine, a Kaplan turbine. The existing keyway consists of one parallel key with the width 90 mm and height 45 mm. Due to a planned increase of the power of the generated power with 32 % a design study was needed to see if the keyed joint would be suitable for the extra force. Because of the fact that the axis diameter is bigger than the standards covers/recommends a the keyway had to be re-dimensioned. In an earlier assignment from Skellefteå Kraft AB to Sweco Energuide the keyway was planned to be properly dimensioned, but no final solution was approved.During this master thesis a number of different numerical tests were made.

The Kverneland Ecomat and The Ecomat Seeder has been tested in three different field studies. All the studies were conducted on soils with different clay content during 2005 in Säby outside Uppsala. In one of the trial spring ploughing with the Ecomat and spring ploughing and seeding with Ecomat Seeder were compared with conventional autumn mouldboard ploughing and spring mouldboard ploughing to conventional depth (22-23 cm). In this study the quality of the seedbed, the number of emerged plants and weeds, the pentration resistance and the yield were examined. Shallow spring ploughing (10 cm) with the Kverneland Ecomat has shown to be a good alternative to conventional autumn ploughing when growing spring crops. During the season 2005 tilling with the Ecomat resulted in a higher yield than conventional ploughing. In 2002-2005 the average yield for shallow spring ploughing was 4 percent higher than after conventional autumn mouldboard ploughing and 10 percent higher than after spring mouldboard ploughing to conventional depth (22-23 cm). In the other two studies, ploughing to different depth in the autumn with the Ecomat was compared with conventional mouldboard ploughing and stubble discing.

There are various arguments for using total mixed rations (TMR) or not. Cows can easily become fat and thus poorly utilize the feed while it can be stated that TMR also has a positive effect on cows? health and wellbeing as the rumen environment is more constant than when separate feeding is applied. Studies do show that that especially low yielding cows kept in groups get fatter when fed TMR. The overfeeding implicates higher feeding costs. This study included 10 herds where 5 had TMR and 5 hade separate feeding of forage and concentrates.

Modern sawmills are using the raw-material and the production-capacity more efficiently today, due to rising raw-material prices and higher production costs. Log sweepness has a negative effect on the sawn yield, for sawmills with straight-sawing. It is desirable that these logs could be sorted based on more criteria, if it increases value-yield and consequently the utilization of raw-material. Bow-heights over 1 cm have a negative effect on sawn yield, since the surface of the mantle cuts down in the sawn pattern. Some of these small bow-heights reduce the logs yield of value which affects the production planning negatively. Nearly half of all the Swedish logs have a bow-height over 1 cm.

Lyckeby Starch AB is a farmer-owned company that produces products based on potato starch. In order to increase their production efficiency and their international competitiveness the company is investigating the possibilities of keeping their factories open longer. To achieve this, potato has to be stored for a longer period of time than what is practiced today. Starch potato is usually stored in large piles covered by straw and plastic, either in the field or on the farmyard. The objective was to examine in what way starch yield (starch content*tuber weight) in three different potato varieties was affected by storage in two different types of storage piles. The potato was stored for three months in total and starch content and tuber weight were controlled throughout the period. Stored tubers were also visually examined and prescense of mechanical damage as well as wet rots and dry rots was recorded. Bacteria and fungi were isolated and identified. In general, varietal differences were greater than differences between the storage piles.

The production of cheese is in continuous development with objectives to in-crease productivity, achieve changes in shelf life and functional properties of the products. One concept in the development is to substitute milk fat with vegetable fats and oils in the manufacture of cheese. The objective of this study was to investigate effects on cheese yield and cheese quality of 4 different semi-hard analogue cheese products produced by substituting milk fat with vegetable fat, each analogue cheese with a specific mixture of vegeta-ble fat. As reference a cheese produced with anhydrous milk fat was used. The yield and recovery of fat and protein were determined by recording the weights of each cheese direct after press and after 20±2 days of storage and analysis of the composition of the cheeses after 20±2 days of storage. The cheese was fur-ther subjected for texture profile analysis in a TA-XT Plus Texture Analyser and analysed with Differential Scanning Calorimetry (DSC) to examine whether the fat behaves similar in the cheese as in pure form in respect to its thermal properties. The cheese yield was not significantly different when using different fats. Differ-ent amounts of water were absorbed during the water cooling.

I have chosen to work with drag hose system and try to find an alternative to spread manure with a usually tank system, see if you can make a profit and what advantage and disadvantage the system has. The purpose whith the project has been to try to make a system that can spread manure at better occasions than farmers do today and above everything make a financial addition. Today it is just a heavy work and takes a lot of time. I have counted on investment costs and carefully examined what equipment you need. I have not the technical details in my project, I have just tried to understand how it is to spread manure with drag hose system today. What is drag hose system? You put a hose in your manuretank, connect it to a pump that is driven by a traktor or stationary engine. You place a hose that reach the field were you are going to spread.

The production of oilseed rape is an important issue in Sweden and those who never have grown oilseed rape (OSR) are now willing to try. It is always a risk to grow oilseed rape, specially winter OSR, because of outwintering. This risk increases as you go north and therefore establishment and autumn growth is very important. These are some of the reasons that I have chosen to write about the establishment of winter oilseed rape in Middle Sweden. There are many factors that influence the outcome of the establishment, e. g.

Automatic milking systems (AMS) provide the opportunity for less manual labour and an increased milking frequency. But in order to reach an optimal milking frequency a well-functioning cow traffic is crucial. There are many factors affecting cow traffic but one factor that has not been studied thoroughly yet is the effect of different light intensities during the night, 22.00 h to 05.00 h. Therefore the aim of this study was to determine the effect of different light intensities during the night on number of selection gate passages (GP), milking frequency and milk yield. The study was conducted as a Latin square were three light intensities were applied: LOW (11 ± 3 lux), INT (33 ± 1 lux) and HIGH (74 ± 6 lux), in three different herds.

Swedish goats are mainly held for cheese production and therefore, both milk quality and composition are of great importance for dairymen. Today, only few data exists on milk composition from Swedish dairy goats and the casein content is still unknown. One way to reduce the work load for goat farmers and increase animal welfare can be to keep goats and kids together for longer periods. The aims of this study were to investigate how milk yield and composition were affected when kids suckled their dams during 8 weeks, and to measure the casein content on farm level by a mid-infrared spectroscopy method, previously calibrated for goat milk. Lactating goats were kept in two different MIX- systems where the dams are both suckled and milked.

Background: Society of today is characterised by greater dynamics and a constant demand for innovation and fresh ideas. This development is often named "the new economy" or "the knowledge society". Independent of how one chooses to name this society, most individuals seem to agree upon the fact that knowledge grows more and more important. New competencies, such as new knowledge and new forms of organising, will be demanded for corporations to be successful in the future. In recent years it has become more common with corporations based on projects.

Heifer?s growth may be divided into three main phases: calf period, puberty and pregnancy. When the heifers are about three months old a critical period begins. This period ends when the heifer reach puberty and have her first oestrus at around 9-12 months of age. In the critical period the mammary gland starts to grow at a fast rate and Insulin-like growth factor-1 (IGF-1) transport the growth signals to the mammary glands.

When facing the fact that high yielding dairy cows has an increasing energy requirements, the practice of adding lipid supplements such as concentrates rich in palm oil and/or palm oil industry by-products become more common. Palm oil containing high levels of C16:0 causes high levels of free fatty acids (FFA) which are linked to larger milk fat globules (MFG) which affect the reaction of lipolysis resulting in rancid flavour and processing problems. Instead of using palm oil, rapeseed oil rich in C18:1 C18:2 can be used. In order to evaluate the effect of added C18:0 and C16:0 on milk lipolysis, 30 Swedish Red lactating dairy cows including 15 multiparous (MP) and 15 primiparous (PP) cows were randomly divided in three groups resulting in 3 10 cow-groups (5 PP and 5 MP cows per group) and fed one out of three concentrate mixtures: control (C), a standard concentrate mixture with no fat added; palmitate (P) as C plus the addition of palmitate methyl ester (10 % in DM basis); and stearate (St) as C plus the addition of stearate methyl ester (10 % in DM basis). Milk yield was registered, and milk samples were collected and analysed for milk composition, FFA content and size of MFG.

The aim of the study was to investigate if the Grazemore Decision Support System (DSS) is able to provide a grazing management strategy that gives a high utilisation of grazed grass in milk production in the north of Scandinavia. To do this, a grazing experiment was planed and performed during the summer 2005. Simulations in the DSS were run to get a suggestion of how the cows should graze, grazing calendar 1. Deviations and updates during the season resulted in the simulated grazing calendar 2. During the experiment, the actual milk yield was recorded twice weekly. The difference between actual and predicted milk yield by Grazemore DSS was analysed statistically with regression analysis and the mean square prediction error (MSPE) was estimated.

Swedish agriculture has gone through big changes in the latest 60 years. The farm sizes have increased, which has led to raised tractor and machinery sizes and therefore increasing problems with soil compaction. A method to reduce these problems is to implement controlled traffic farming, CTF. All field operations are then concentrated to specific tracks by using GPS guidance. The aim of this work was to study how the tillage regime, with or without CTF, affects the soil, with the main focus on macroporosity. In Säby close to Uppsala, and Alnarp close to Malmö, randomized block trials has been carried out, and the data has mainly been taken from these trials.