Hårdgörning av trä syftar till att göra materialet hårdare. Detta går att åstadkomma genom komprimering, det komprimerade materialet tenderar dock att återgå mot sin ursprungsform då materialet utsätts för fukt om ingen låsning sker. Låsningen kan ske mekaniskt i en treskiktskonstruktion som motverkar träets fuktrörelser. Dessa skivor har dock visat sig vara instabila och tidigare försök har uppvisat deformationer i form av kupning. Denna undersökning syftar till att utreda förutsättningarna för att använda komprimerad asp samt att ta fram underlag för framtagning av en kommersiell produkt.Praktiska tester har genomförts för att studera hårdhet, återfjädring och densitet hos det komprimerade virket.

An Internet application, VEDAIR, for estimation of air quality in regions with small-scale combustion of bio fuel has been developed by Swedish Meteorological and Hydrological Institute with financing from Swedish Energy Agency and Swedish Environmental Protection Agency. The model contains user interface and a coupled model concept where concentrations of atmospheric pollutions are calculated for regional, urban and local contributions. In this report the model is described and a first study of air quality considering PM10 (particles with a diameter less than 10 µm) in two Swedish municipalities, Vänersborg and Gnosjö, is introduced.According to the result, there are areas with poor air quality even in smaller Swedish municipalities, mostly due to high emission from buildings with older wood heating furnace without hydraulic accumulator.In Vänersborg three areas were analysed in VEDAIR for the year 2003: Vargön, Mariedal and the downtown district. In the whole municipality the upper evaluation threshold for PM10, which is defined as 14 µg/m3 for annual average, was exceeded due to background contribution of particles. In all areas, however, the concentrations of PM10 were less than the environmental quality norms.

Stump wood was used between 1850 and 1950 for production of tar and as firewood. In the 1950s the use decreased because of the introduction of the cheap fossil oil. In the 1970s stump wood became an interesting issue again as a raw material for the pulp industry. Stump lifting has today become a possible source for bioenergy. The objectives with this study were to investigate the productivity of stump lifting and stump extraction, and to analyse the economy.

Forest management contributes to the changes in forest structure by turning heterogenous forests of varied age into homogenous forests of similar age and thus affect bird species depending on different structures or habitats which are lost during forestry. In this report, a study was made to investigate how the amount of decidious trees, dead wood and variation in tree diameter affect bird diversity. The purpose of this study was to be able to give forest management guidelines to increase bird diversity. This study was conducted by investigating 65 transects in forests of different structure south of Linköping, Sweden. Along the 65 transects, birds were inventoried as well as the vegetation.

StoraEnso decided in year 2002 to build a pulp mill in the province of Guangxi, southernChina, and also establish eucalyptus plantations to provide it with raw material. By 2010StoraEnso controls about 90 000 of planned 120 000 ha, out of 75 000 ha is already plantedwith Eucalyptus.By using better genetic material, improve the tending, selecting the sites more careful and byusing a proper fertilization regime StoraEnso hopes to increase the mean annual incrementfrom today?s 25 m3/ha, on bark, to 35 m3/ha. This study is one part in this work to increase themean annual increment in the plantation.This master thesis is the forth in a series, that has followed up a fertilization trial that startedin spring 2006 when the trial was laid out and treatments decided. The aim with the trial is toexamine the production potential of Eucalyptus urophylla in Guangxi, southern China.

It is essential to reuse- and recycles residues to decrease the amount of deposit materials and reach sustainable energy use. Two ways to work towards this is to recycle wood ashes to the forest as nutrient compensation and extract biogas from combustion of biomass.The aim with this study was to decide whether wood ashes that been used for biogas upgrading with accelerated carbonation also can be used as a nutrient compensation in the woods according to recommendations from the Swedish Forest Agency (Skogsstyrelsen).The ashes that were used in this study came from Johan Andersson who works at JTI in Uppsala, who also treated the ashes with biogas. The ashes have, in both untreated and treated condition, been analyzed in this study according to contents of elements, leaching properties, hardening properties and contents of crystalline phases, to evaluate what impact carbonation with biogas has on the ashes.The accelerated carbonation led to hardening of the ash, and decreased amount of CaO- and increased amount of CaCO3. The CO2-uptake also entails a dilution of the elements, and the content of nutrients and trace elements decreases. However the results show an indication of an uptake of S from the biogas to the ash, since the dilution had a smaller impact on S than the rest of the elements.

Different methods for shelterwood cutting have been used in differ-ent parts of Europe since the middle ages. The use of shelter wood cutting in Norway spruce (Picea abies (L.) Karst.) forests in Sweden met a revival in the early 1990s as an alternative for the dominating clear-cutting system when silvicultural costs increased dramatically for the latter. Shelterwood cutting systems involve some possible problems but also a lot of positive effects. Among the problems are increased risk of wind throw and damage of the remaining shelter trees caused by the cutting operation. Positive effects are for example a valuable growth in the remaining trees and increased biological di-versity. This study is based on a total of 79 trees from 4 different treatments in a spruce shelterwood, cut in 1994, in the middle of Sweden (62,4º N).

Denna rapport är resultatet av en analys som gjorts vid Vest-Woods fabrik i Forserum under våren 2007 i syfte att reducera interna transporter. Vest-Wood AB i Forserum tillverkar dörrar för den svenska marknaden men förser också en annan fabrik (SdrFelding i Danmark) i samma koncern med dörrstommar. Materialhantering för att förse Sdr Felding fabriken med dörrstommar medför i dagsläget mycket interna transporter i Forserumsfabriken. För att klara ojämn efterfrågan från Sdr Felding fabriken samt för att kunna jämna ut sin egen produktion har Forserumsfabriken valtatt lagerföra de tolv artiklar som beställs mest frekvent från Sdr Felding fabriken. Buffertlagret vid Forserumsfabriken där artiklarna lagerförs är placerat ca 200 m från produktionen vilket medför mycket intern transport för hantering av dessa.

In this thesis tests has been performed on the pull strength of screws glued into glulam beams.The experiment is based on the already approved method whereby the diameter of the drilled holes is the same as the screw outer diameter of 1 mm or bigger. The screws strength class shall not be less than 4.6 (EN ISO 898-1:1999, 1999).The difference in the experiments that were performed where that the drilled diameter were 1 mm smaller than the outer diameter of the screw so that the screw thread was worked into the wood.In the tests the gluing where made on M8 glulam beams. The screws where drilled at and angel of 90°tangental to the fiber direction with a diameter of 7 mm. The gluing of the screws where made in three different depths and where later exposed to pulling forces. The results showed both pulling breaks and screw breaks when they reached their maximum capacity.

It is essential to reuse- and recycles residues to decrease the amount of deposit materials and reach sustainable energy use. Two ways to work towards this is to recycle wood ashes to the forest as nutrient compensation and extract biogas from combustion of biomass.The aim with this study was to decide whether wood ashes that been used for biogas upgrading with accelerated carbonation also can be used as a nutrient compensation in the woods according to recommendations from the Swedish Forest Agency (Skogsstyrelsen).The ashes that were used in this study came from Johan Andersson who works at JTI in Uppsala, who also treated the ashes with biogas. The ashes have, in both untreated and treated condition, been analyzed in this study according to contents of elements, leaching properties, hardening properties and contents of crystalline phases, to evaluate what impact carbonation with biogas has on the ashes.The accelerated carbonation led to hardening of the ash, and decreased amount of CaO- and increased amount of CaCO3. The CO2-uptake also entails a dilution of the elements, and the content of nutrients and trace elements decreases. However the results show an indication of an uptake of S from the biogas to the ash, since the dilution had a smaller impact on S than the rest of the elements.

The aim for this study where to investigate the frequency of cutting cracks in saw timber harvested in the storm-damaged forests in regions where the storms Hilde and Ivar hit. The idea for this work came from one of the region?s biggest actors, SCA Skog and Jämtlands district. The purpose where to find out how big proportion of the saw timber that contains cutting cracks, their financial cost in lost wood value and also give advice and suggestions on how to work against the frequency of cutting cracks. For the field-study some guidelines where used to make sure that the samples were taken under the same conditions, they were: ? The field-study must be performed under harvesting of storm-felled forest, which are horizontal/inclined trunks. ? The averaged sized tree will make it possible to harvest saw timber. ? The trunks can?t be root cut. A methodology called in Swedish ?Trissmetoden? was used because it is the most frequent used methodology in earlier performed studies and the only one that can be used I field. Under the field-study data were collected from 570 saw timber logs, 30 logs from each one of the tested harvesters.

The need for roundwood transport capacity vary throughout the year. The need during a period is influenced mainly by the volume transported the period, the number of days during which transport can be carried out, seasonal variations in road conditions and the weight of the roundwood, and the origin of the wood (private forest owners/ forest companies). The need for transport capacity generally increase during the winter and in spring, after thawing. Lack of logging trucks combined with a lack of drivers for these trucks make it hard to hire extra help during periods of increased transport capacity needs. It is also very expensive to keep logging trucks for use only during these periods. In this thesis, two new concepts based on the partial transport by truck tractors have been examined, to find out the possibility for increased performance and flexibility.

This study investigates three different methods for evaluating MOE,Modulus of Elasticity, in field measurements. The purpose is toinvestigate the possibility to use dynamic measurement methods infield measurements that hitherto (2010) has been performed with staticmethods. The objects of investigation are 20 glulam beams. The firstfield measurement took place in november 2007 and applied a staticmethod based on the standard SS-EN 408. The second measurement,described in this study, took place during summer 2010, and appliedstatic as well as dynamic methods.The MOE of wood is affected by a range different factors.

In the current situation a big part ofthe settlements that exist in Sweden isin need of renovation and energyefficiency in order to survive.Therefore, also many of the older houseswith a wooden structure are in a need ofenergy efficiency, which can be done ina variety of ways, including addinginsulation.This project deals with whether the useof a diffusion barrier or a vaporbarrier affects a wall structure byadding insulation to an older house witha timber frame. The insulation materialswhich are concidered in thisinvestigation are mineral wool and woodfiber insulation. Efforts are focused onthe effects of moisture on theseinsulation materials.To demonstrate the differences thatarise the moisture measurement programWUFI have been used to simulate avariety of wall designs. These designsare developed in consultation with theconstruction carers who are active inthe industry.Using WUFI graphs illustrating themoisture levels of the wall structureswere obtained and from these conclusionsvould be drawn. The work demonstratesthe differences that arise when using adiffusion barrier or vapor barrier inwall construction.

A recommendation for stand treatment of lodgepole pine (Pinus contorta) is, in a scientific point of view, lacking when it comes to harvesting for biomass energy. Within the next decades it is expected that 280 000 hectares of lodgepole pine will have reached thinning age on the domains of Svenska Cellulosa Aktiebolaget (SCA). Due to this the interest has grown rapidly for studying the possibilities of harvesting biofuel assortments already in the first thinning. In this study the distribution of the biomass within lodgepole pine trees has been studied and taken into account for estimating the proportions of harvested assortments when using different methods of thinning. The methods studied were conventional biofuel-harvesting (with delimbed branches gathered separately from the round wood) and thinning with cutting of round wood and long tops (incl.